Black Widow Security BW RAS 120 Bedienungsanleitung

Standard Features

The following features are standard with your

Security/Remote Start:

(2) four button remote controls

Status Indicator (LED)

Valet/Service mode switch

Remote Start capabilities

Remote Heater/AC capabilities

Parking Light Verification

Safety Inputs (Brake & hood))

Remote Shutdown Operation

Extended Range Receiver

Multi-tone siren (120dB)

Dual stage impact detector

Remote panic

Remote chirp mute

Remote sensor bypass

Passive or active arming

Ignition controlled door locks

Stop & Go

Auto Cold Start (protected)

Illuminated entry

Flashing parking lights

Optional Features that you may

add to your Security/Remote Start (Consult

with your technician)

Hood & trunk protection

Remote keyless entry (Door lock/unlock)

Trunk/hatch release

Window roll-up

Back up battery

Additional sensors; glass break, microwave

Note: Some features and options may

require additional parts and labor or may not

be appropriate for certain vehicles.

Automatic transmission and electronic fuel

injection are required on vehicles for use with

this Remote Start/Security System.

SECURITY/REMOTE AUTOSTART

OWNERS MANUAL

Remote Start

Operation

Important: Do not operate this remote

auto start in an enclosed garage or area with-

out proper ventilation. Be sure to familiarize

yourself with the features of the Remote Auto

Start Product prior to using the product.

REMOTE STARTING

THE VEHICLE:

Press the ASTERISK button

on the remote transmitter,

the siren chirps 3 times.The

parking lights will come on

solid.Approximately 2 seconds later the

Security/Remote Autostart will attempt to

start the vehicle. Once the car has started,

the heater or air conditioner will turn on (if

it is set to run prior to exiting the vehicle),

it will run for the preprogrammed time (12

or 24 minutes). If the engine fails to start on

the first attempt, it will repeat the starting

procedure 2 more times. If the vehicle fails

to start after a total of 3 times the siren

will chirp 6 times.

Driving the Vehicle after Remote Started:

Unlock the door by pressing

the UNLOCK button on the

remote transmitter (option-

al). Enter vehicle, turn igni-

tion key to the on position

(Note:Do not turn the key all the way to the

start position as you may damage the starter).

Once the ignition key is turned to the on

position, press the brake pedal and shift the

car into the proper gear and you may now

drive the vehicle (Note:If brake pedal is

pressed prior to turning on ignition, engine will

turn off).

Remote Engine Shutdown:

If the vehicle has been

remotely started and you

desire to turn the vehicle

off, simply press the ASTER-

ISK button on the remote

transmitter.After the motor has turned off

the doors will relock (optional).

Disengaging the Auto Cold Start

Activation:

To turn this feature off via

the remote transmitter press

and hold the ASTERISK but-

ton on the remote transmit-

ter for 5 seconds, the parking lights will

flash 10 times to confirm deactivation.You

may also disengage the Auto Cold Start fea-

ture by pressing the brake pedal or turning

Trunk

Lock

Asterisk

UnlockLED

Press

Hold

Press

the ignition to the on position at anytime.

Note:Also, by remote starting the vehicle.

TRUNK/HATCH POP 3rd

CHANNEL

(Optional):

Press the TRUNK button

for approximately 2 sec-

onds and the trunk/hatch

will pop open.

SAFETY FEATURES:

The Security/Remote Autostart will not start the

vehicle under the following conditions:

1. The brake pedal is pressed.

2. The Hood is opened (an optional pin

switch needs to be installed).

3. The ignition is turned on.

Security System

Operation

ARMING OPERATION:

Active Arming-To activate

the alarm, simply press the

LOCK button on your

remote control.You will

hear one chirp from your

siren, your parking lights will flash one time.

Your doors will lock, and the L.E.D. will turn

solid for 2 seconds then it will start flashing

slowly.After 10 seconds the system is

armed.

Passive Arming- If your system was

installed to arm passively, simply turn off

your ignition key and exit the vehicle, the

system will arm 30 seconds after the last

door is closed. After you shut off the igni-

tion, the LED will start flashing rapidly to let

you know that the system is in the Pre Arm

state.You can always arm the system at any

time by pressing the LOCK button on the

remote.

DISARMING OPERATION:

To deactivate the alarm

press the UNLOCK button

on your remote.The siren

will chirp twice, and parking

lights will flash twice (car

location feature).The LED will stop flashing,

the doors will unlock; system is disarmed. If

you have the illuminated entry system

installed the interior light will flash twice

then stay on for 30 seconds or until you

turn the ignition on or rearm the system.

VALET MODE:

Valet mode will keep your alarm system

Press Press

Press

from

passive

arming

(if pro-

grammed to passive arm), if you need to

have your vehicle serviced, or run it

through the car wash, etc.

To put your system in Valet Mode, dis-

arm system, turn the ignition key on and

press and hold your valet/override switch

in for approximately 3 seconds, the LED

will turn solid. Your vehicle’s system is in

Valet Mode. If you have keyless entry fea-

tures the remote will still lock and unlock

the vehicle while in Valet Mode.

To exit Valet Mode: Turn ignition key on,

press and hold valet/override switch for

approx. 3 seconds, LED will turn off and

siren will chirp 2 times.

EMERGENCY OVERRIDE:

If you

lose

your

trans-

mitter,

or it fails to operate the system, unlock

door and enter vehicle. The siren will

sound, insert your ignition key and turn

the ignition to the ON position. Then

press the Valet/ Override Switch, the sys-

tem will override and allow you to start

the vehicle.The system will automatically

go into valet, so it will not passively

rearm. (See valet operation to take sys-

tem out of valet mode.)

REMOTE PANIC:

For your personal safety you may activate

the siren by pressing the

LOCK button on your remote

for 3 seconds, this will trigger

the system into the Panic

mode.The siren will sound and

the parking lights will flash.

The panic mode will run for 45

seconds, or until you press the

UNLOCK button on your

remote again.This feature will

not operate when the ignition

is on.

SIREN MUTE ARM/DISARM:

If you wish to arm or disarm

your alarm, but do not want

the siren to chirp loudly, simply

press and release the TRUNK

button on the remote control.

CHIRP DELETE:

To turn off ARM/ DISARM chirps, turn

ignition switch on, then press and hold

the ASTERISK button until you hear a

double chirp. The arm/disarm chirps will

turn off .To return the chirps, repeat the

procedure until you hear (2) double

chirps.

ENTRY VIOLATION MEMORY:

In the event that your Security/Remote

Autostart system is triggered and runs an

entire cycle, when you return to disarm

it, instead of the usual 2 chirps you will

hear 3 chirps unless you have deleted that

function (see above).To indicate that the

your system was set off, parking lights will

flash 3 times as well.

AUTO REARM FEATURE:

If you would like your system to auto

Press

Hold

Press

3 Sec.

Press

rearm (if system is remotely disarmed) and

a door is not opened, within 30 seconds

the alarm will automatically rearm the sys-

tem.This feature may be disabled by turn-

ing the ignition to the on position and

pressing and holding the LOCK button on

the remote. Siren will chirp twice. Repeat

the procedure to enable the feature.

NOTE: This will not work on vehicles with

the illuminated entry feature enabled.

REPLACING STOLEN

OR LOST REMOTE CONTROLS:

Your authorized Black Widow Dealer can

program in more remote controls, and

erase the codes for stolen or lost transmit-

ters at the same time, so that they will not

operate the system.

LED STATUS INDICATORS

Off= System off in Active mode

Slow Flashing= System Armed

Rapid Flashing= Passive Pre Arm State

Rapid Flashing (after disarm)=System

was triggered while away.

On Solid= In Valet Mode.

On Solid (when disarmed, and not in

Valet)= Door/Hood is open.

CHIRP INDICATIONS:

One Chirp= Armed

Two Chirps= Disarmed

Three Chirps= Disarmed, but system was

triggered while away.

Four Chirps= 8 seconds after arming,

indicates faulty sensor or trigger.

Six Rapid Chirps= Warn away triggered

DLC/U.S.A. 12753 Moore Street • Cerritos, California 90703

PARKING LIGHT FLASHING FUNCTIONS

Flashes Function

1 DOORS LOCKED (optional)

2 DOORS UNLOCKED (optional)

4 RAS UNABLE TO START VEHICLE

5 AUTOMATIC COLD START ACTIVATION ENGAGED

10 AUTOMATIC COLD START ACTIVATION DISENGAGED

LED STATUS INDICATOR FUNCTIONS

Flashes Function

SLOW DOORS LOCKED (optional)

RAPID VEHICLE IS BEING REMOTE STARTED & RUNNING

SOLID REMOTE AUTO START IN SERVICE MODE

DOUBLE AUTOMATIC COLD START ACTIVATION ENGAGED

Trunk

Lock

Asterisk

UnlockLED

REMOTE CONTROL FEATURE OPERATION

Button Duration Function

LOCK SHORT ARM

UNLOCK SHORT DISARM

LOCK LONG (3 SEC.) REMOTE PANIC

ASTERISK LONG (3 SEC.) REMOTE START

TRUNK LONG (3 SEC.) TRUNK POP

TRUNK SHORT SILENT ARM/DISARM

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Black Widow Security Sicherheitssystem Handbücher

Black Widow Security

Black Widow Security BW FM 100 Bedienungsanleitung

Black Widow Security

Black Widow Security BW 690 Bedienungsanleitung

Black Widow Security

Black Widow Security BW 690 Bedienungsanleitung

Black Widow Security

Black Widow Security BW RAS 130 Bedienungsanleitung

Black Widow Security

Black Widow Security BW-1600 Bedienungsanleitung

Black Widow Security

Black Widow Security BW 752 Bedienungsanleitung

Black Widow Security

Black Widow Security BW 700 Bedienungsanleitung

Black Widow Security

Black Widow Security BW FM 6150 Bedienungsanleitung

Black Widow Security

Black Widow Security BW 690-C Bedienungsanleitung

Beliebte Sicherheitssystem Handbücher anderer Marken

Inner Range

Inner Range Concept 2000 Bedienungsanleitung

Climax

Climax Mobile Lite R32 Montageanleitung

FBII

FBII XL-31 Series Bedienungsanleitung

Johnson Controls

Johnson Controls PENN Connected PC10 Bedienungsanleitung

Aeotec

Aeotec Siren Gen5 Bedienungsanleitung

IDEAL

IDEAL Accenta Betriebsanleitung

Swann

Swann SW-P-MC2 Bedienungsanleitung

Ecolink

Ecolink Siren+Chime Bedienungsanleitung

Digital Monitoring Products

Digital Monitoring Products XR150 Bedienungsanleitung

EDM

EDM Solution 6+6 Wireless-AE Bedienungsanleitung

Siren

Siren LED GSM Bedienungsanleitung

Detection Systems

Detection Systems 7090i Montageanleitung

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Bedienungsanleitung

Siemens

Siemens FDM273 Bedienungsanleitung

DSC

DSC PC 4010 Betriebsanleitung

UniPOS

UniPOS 6202L Bedienungsanleitung

AJAX

AJAX DoubleButton Bedienungsanleitung

Rondish

Rondish Nexus Bedienungsanleitung