Blaupunkt AMP7502 Bedienungsanleitung

Bridgeable Range Amplier

AMP1504

AMP1501

AMP7502

Operation is subject to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received, including interference

that may cause undesired operation. WARNING: This product contains a chemical known to the

State of California to cause cancer and reproductive toxicity.

2231 Colby Ave, Los Angeles California 90064

System Planning

Speaker Requirements

Symptom Possible Cause Action to take

installation carefully, you can avoid situations where the performance and reliability of your system is

compromised. Our authorized dealer has been trained to maximize your system’s sound quality when

Ωspeaker loads when used in Stereo Mode. When

a channel-pair is bridged, the recommended

minimum load impedance is 3Ωfor subwoofer use,

and 4Ωfor full range operation. Although

operation with lower impedances is not likely to

cause immediate damage to the internal circuitry,

the unit will most likely overheat, causing the

thermal protection circuitry to shut down the

operation will resume.

conditions is not recommended and will reduce its

life expectancy. Most speakers designed for car

audio operation are 4Ωimpedance. Connecting

two such speakers in parallel will result in a 2Ω

nominal impedance, which is not recommended

Poor bass response Speakers wired wrong

polarity causing cancellation

at low frequencies

Check speaker polarity and repair as

needed

Crossover set incorrectly Reset crossover referring to the

section of this manual for detailed

instructions

Battery fuse blowing

too low

Check speaker impedance load. If below

2Ωstereo or 4Ωmono, rewire speakers

to achieve a higher impedance

Short in power wire or

incorrect power connections

Check power and ground connections

and repair as needed

Fuse used is smaller and

recommended

Replace with proper fuse size

Too much current being drawn Check speaker impedance load. If below

2Ωstereo or 4Ωmono, rewire speakers

to achieve a higher impedance and

replace with recommended fuse size

Short in power wire or incorrect

wire

Check power and ground connection and

repair as needed

Too much current being drawn Check speaker impedance load. If below 2

Ωstereo or 4Ωmono, rewire speakers to

achieve a higher impedance and replace

with recommended fuse size

Check power and ground connections.

Repair as needed

Fuse used is smaller than

recommended

Replace with proper fuse size

Trouble Shooting

CAR

AMPLIFIER

tart up

Connect the amplifier s

output to drivers

ole ositive ole

he Appropriat se

Connected to the

positive pole

Connection Diagram

efore beginning,

WARNING

Connect to the frame of

car for grounding

DO NOT connect the car battery’s negative poles to the positive poles.

Symptom Possible Cause Action to take

No output Low or no remote

turn-on input

Check remote turn-on voltage

needed

Fuse down Check power wire integrity and

reverse polarity, repair as needed

and replace fuse

Power wires not connected Check power wire connections

and repair/replace as needed

Audio input not connected or

no output from source

Check input connections and signal

integrity repair/replace as needed

Speaker wires not connected

Check speaker wires and repair/

replace as needed

Speakers are blown Check system with known working

speaker and repair/replace speakers

as needed

Thermal protection engages

temperature exceeds 90°C

Make sure there is proper ventilation

as needed

Loose or poor audio input Check input connections and

repair/replace as needed

Distorted output

set too high, exceeding

maximum output capability

Reset gain. Refer to the turning section

of the manual for detailed instructions

too low

Check speaker impedance load. If below

2Ωstereo or 4Ωmono, rewire speakers

to achieve a higher impedance

Shorted speaker wires Check speaker wire connections and

repair/replace as needed

Speaker incorrectly

properly

Check speaker wiring and repair/replace

as needed. Refer to the installation

section of this manual for detailed

instructions

Speakers are blown Check system with known working

speaker and repair/replace as needed

L R

B R I D G E

! " # $

%&' ( ) *+, ) * - , , ) *. , ) *

System 1: 2- Channel Mode System 2: Connection Subwoofer

AMP1501

Specifications

utput power 4Ω(Watts)

utput power 2Ω(Watts)

re uency response ( 2d )

ignal to noise ratio

ensitivity

ecommended fuse type

imensions

563W x 1 CH

330W x 1CH (Τ2%)

0.0 %

10H 300Hz

100m 6

20A x 2

180 x 1 3 mm

L R

B R I D G E

AMP7502

System 2: Bridge Connection Subwoofer

Specifications

utput power 4Ω(Watts)

utput power 2Ω(Watts)

ridged output power 4Ω(Watts)

re uency response ( 2d )

ignal to noise ratio

ensitivity

ecommended fuse type

imensions

330W x 2 CH

325W x 2 CH

160W x 1CH

H %)

0.0 %

10H 4 Hz

1 0m 6

30A x 1

220 x 1 3 mm

System 1: Connection Subwoofer

$%&'

( &'

' ) * *

' + + * ,

$#( - .! ( - .( /$010

2 3 4 + , 3

(

C H3 C H4

B R I D G E

C H1 C H 2

! "#$%&' ( %& ! "#$%&' ( %&) ( ( %&* ( %&

+ , - .+ , - .

System 1: 4-Channel Mode System 2: Bridge Connection Subwoofer

Specifications

utput power 4Ω(Watts)

utput power 2Ω(Watts)

ridged output power 4Ω(Watts)

re uency response ( 2d )

ignal to noise ratio

ensitivity

ecommended fuse type

imensions

300W x 4 CH

150W x 4CH

1500W x 2CH

0.0 %

10H 4 Hz

1 0m 6

30A x 2

300 x 1 3 mm

C H3 C H4

B R I D G E

C H1 C H 2

AMP1504

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Blaupunkt Verstärker Handbücher

Blaupunkt

Blaupunkt BSA 160 Bedienungsanleitung

Blaupunkt

Blaupunkt BQX 300 Bedienungsanleitung

Blaupunkt

Blaupunkt GTA 470 Mystic Series Technisches Datenblatt

Blaupunkt

Blaupunkt Velocity V7000 Bedienungsanleitung

Blaupunkt

Blaupunkt EMA 260 Leitfaden

Blaupunkt

Blaupunkt GTA 2 Special Mk II Bedienungsanleitung

Blaupunkt

Blaupunkt GTA 270 SF Bedienungsanleitung

Blaupunkt

Blaupunkt TSA 1300 Handbuch

Blaupunkt

Blaupunkt TSA 280 Handbuch

Blaupunkt

Blaupunkt GTA 280 Bedienungsanleitung

Blaupunkt

Blaupunkt THA 1250 PnP Bedienungsanleitung

Blaupunkt

Blaupunkt GTA 11250 DSP Bedienungsanleitung

Blaupunkt

Blaupunkt TSA 460 Bedienungsanleitung

Blaupunkt

Blaupunkt GTA 270 DSP Leitfaden

Blaupunkt

Blaupunkt THA 555 PnP Bedienungsanleitung

Blaupunkt

Blaupunkt THA 475 PnP Bedienungsanleitung

Blaupunkt

Blaupunkt GTA 1500 D Leitfaden

Blaupunkt

Blaupunkt Velocity VA 1004 Bedienungsanleitung

Blaupunkt

Blaupunkt Velocity VA4100 Bedienungsanleitung

Blaupunkt

Blaupunkt BGA 250 Bedienungsanleitung

Blaupunkt

Blaupunkt GTA 2600 HP Bedienungsanleitung

Blaupunkt

Blaupunkt 7 607 792 036 Bedienungsanleitung

Blaupunkt

Blaupunkt GTA 470 DSP Leitfaden

Blaupunkt

Blaupunkt GTA 5350 Bedienungsanleitung

Beliebte Verstärker Handbücher anderer Marken

ASTRO

ASTRO HVO V40 P Bedienungsanleitung

Marantz

Marantz SUPERSCOPE BLA-545 Montageanleitung

NAD

NAD CI980 Bedienungsanleitung

Technics

Technics SE-CH770 Bedienungsanleitung

Harman Kardon

Harman Kardon HK6300 Bedienungsanleitung

NAD

NAD T975 Bedienungsanleitung

McIntosh

McIntosh MA6850 Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Bedienungsanleitung

Viatron

Viatron Autrix Bedienungsanleitung

GME

GME GA9800 Bedienungsanleitung

Atlas

Atlas CP700 Bedienungsanleitung

Roland

Roland KC-1000 Bedienungsanleitung

Pyle

Pyle PFMRA350BW Bedienungsanleitung

Advantage

Advantage S-250 Bedienungsanleitung

IRT Electronics

IRT Electronics DVA-3007 Bedienungsanleitung

Dimavery

Dimavery BA-100 Series Bedienungsanleitung

Sony

Sony XM-S400D Bedienungsanleitung

Schertler

Schertler ROY X Bedienungsanleitung