Blue Ridge PTAC Installationsanleitung
PTAC Wall Sleeve, Grille and
Condensation Kit
Assembly Instruction Manual
Table of Contents:
1. Wall Sleeve Assembly Instructions p. 2
2. Condensation Drain Kit Assembly Instructions p. 9
3. Grille Assembly Instructions p. 12
1. Assembling the wall sleeve.
Important:
In this manual, right and left are defined from the “IN” side. By definition, A PTAC sleeve is a
through-the-wall product and therefore half will be inside the structure and half outside. To
avoid confusion, find the inside and outside of each piece as defined below before you begin
assembly.
Sleeve box contents:
1 bottom section
1 top section
2 side sections
8 small, self-tapping sheetmetal screws
4 long screws with flanges
4 threaded clips
6 plastic grill vibration dampeners
6 small, Hex-Head machine screws with washers
Identify the bottom section which has a small strip of foam at the back and two folded metal ribs
at either edge. Place the bottom section on your work surface with the foam strip away from
you. Note - you should now be standing on the ‘In” side of the wall sleeve.
Orient the side sections such that the 4 large, keyed holes on the flanges are on the outside and
the six smaller holes are on the inside.
“Out” side ”In” Side
The right side section should have a white sticker that says "Use on Single Outlet Circuit Only".
On the bottom and top edges of the side sections, a second piece of sheetmetal forms a slot
that runs the length of the edge.
Place the slot of the right side section over the flange of the right side of the bottom
section. Secure with two small self-tapping sheetmetal screws. The outer edge of the side
section must be all the way to the outside for proper water shedding.
Repeat on the left side.
Note: The inside of the top section is completely covered in foam for insulation and noise
reduction. Make sure you don’t have top and bottom reversed at this time.
Place the top section flange on the outside edge of both the right and left sides and the
back. Secure with the remaining 4 small, self-tapping sheetmetal screws.
Note: Since there are similar slots on the top and bottom of the side sections, it may appear
that the flanges of the top piece go inside the slots. However, the outer flange of the top piece
must be at the extreme outside for correct water shedding.
Place the 4 threaded clips over the topmost and bottommost of the six holes in the inside flange
of each side panel. The threaded portion should be toward the inside of the sleeve.
When the time comes, you will secure the PTAC to the sleeve by using the 4 long screws with
flanges into these threaded clips
Place the plastic grille dampeners in the oval holes in the outer edge. These will prevent any
rattling from vibration between the sleeve and grille.
2. Installation of the condensation drain kit.
If you plan to use a condensation drain kit, install it now, prior to working on the grille.
Condensation Drain Kit Box Contents:
1 90 copper elbow
1 straight copper extender
4 sheetmetal screws
3 foam gaskets
4 steel plates (various)
Locate the two condensation drain ports at the bottom outside corners of the sleeve. Select one
side to block off and the other will be the drain location.
Assemble one of the blocking gaskets and the blocking plate with two screws. Affix securely
into the provided screw holes.
Andere Blue Ridge Lüfter Handbücher
