6. ADVANCE DEFAULT SETTINGS.
To enter the advance settings, turn off the thermostat by pressing the button. Now press the screen
in the touch sensitive area until all the buttons light up. Then press and hold the button for 3-5
seconds until the advance options appears on the screen. You are now in settings mode and if you
don’t press any button for 5 seconds the display reverts back to off mode.
Press button to switch to next option and press or buttons to adjust the data. If you wish
to exit the settings without waiting 5 seconds press the button.
BN Sensors used.
N1= Built in sensor only.
N2= External sensor only.
N3= Built in sensor and external sensor.
NOTE.- N3 only used for specialist applications
if recommended by BN Thermic.
N1
DO NOT USE - leave set at 0
DO NOT USE - leave set at 0.
7. USING AS A CONVENTIONAL THERMOSTAT.
It is easy to set up your WiFi thermostat to operate as a simple, conventional thermostat without the
need to programme different times and temperatures. There are 2 steps.
1. Set the temperature required – Refer to “Run Modes” on page 3 and use manual mode, then
select the required temperature by using the or buttons.
2. Lock the thermostat - Refer to “Locking the controller” on page 3. Locking the thermostat will
disable all the buttons except the on/off button. If you want to disable the on/off button as well,
you will need to change the default lock settings before starting this process (see section 5).
8. SENSOR FAULT CODES.
E1 or E2 fault codes are displayed if the sensors are faulty or are not
connected. The thermostat will stop heating until the fault is
corrected. E1 = Internal sensor faulty. E2 = External sensor faulty or
not present.
If in the advance default settings shown above, you have selected
N3 for option BN (Sensors used) you will get a fault code and the
thermostat will not work, please select either N1 if you are using the
internal sensor or N2 if you are using an external mounted sensor.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and
component parts without prior notice.
REGISTER:
Activate your warranty by registering online at www.bnthermic.co.uk and
retain this installation data for future reference.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Your BN Thermic product is guaranteed for one year from date of
purchase. We will repair or replace at our discretion any part found to be defective. We
cannot assume any consequential liability. This guarantee in no way prejudices your
rights under common law and is offered as an addition to consumer liability rights.
OUH3-WIFIINS-v01
This appliance bears the symbol of the crossed waste bin. This indicates that, at the end of its useful life, it must not be disposed
of as domestic waste, but must be taken to a collection centre for waste electrical and electronic equipment. It is the user's
responsibility to dispose of this appliance through the appropriate channels. Failure to do so may incur penalties established
by laws governing waste disposal.
34 Stephenson Way,
Crawley, RH10 1TN
Tel: 01293 547361
sales@bnthermic.co.uk
