19. CHANGING THE MASTER / DEFAULT SETTINGS.
There are various master / default settings that can be changed by entering the default settings.
To enter these settings, press the MODE button and the ENTER button simultaneously and hold for 3
seconds. You are now in settings mode shown in diagram to the right if you don’t press any button for 2
minutes display reverts back to AUTO mode. If you wish to exit the settings screen press MODE button and
the ENTER button simultaneously.
20. SETTING THE TIME AND DATE.
The time and date are factory set so it will not normally be necessary to do this on site.
If you need to change the time after entering the settings screen (shown above) press the MODE button until
the display shows Settings - Time and the Hour is flashing.
Now using +and –buttons adjust to correct hour (24h format) and then press ENTER button and minutes will
start to flash. Now using +and –buttons adjust to correct minutes and then press ENTER button.
If you need to change the date after entering the settings screen (shown above) press the MODE button until
the display shows Settings - Date and the Month is flashing.
Now using +and –buttons adjust to correct month and then press ENTER button and day will start to flash.
Now using +and –buttons adjust to correct day and then press ENTER button and year will start to flash. Now
using +and –buttons adjust to correct year and then press ENTER button.
Note:- If you forget to press the ENTER button new setting will not be stored
21. OTHER SETTINGS.
S.Time –(Auto) Automatic adjustment of British Summer Time can be turned on or off here.
Temp Offset –(0⁰C) Used if you wish to fine turn or calibrate the thermostat, can adjust the temperature up or
down by 1,2,3,4 or 5⁰C.
Full Power –(Yes) Setting NO reduces all the heaters maximum output by between 1/3 and 1/2 their output.
Setting YES returns the heaters to their maximum output. INSTALLER PLEASE NOTE - Adequate size cables
MUST still be used to take maximum load. Do not use this as a way of reducing cable sizes.
Progs / Day –(2) Set the number of programs per day you require either 2, 4 or 6.
Fan Mode –(Off) Setting OFF means that the fan turns on and off when the heat turns on and off. Setting ON
means that the Fan remains on continuously in AUTO mode regardless of the heat turning on and off This is
general only used on air curtain heaters.
Adapt Start –(Off) Turns on or off adaptive start see page 2 for full description on how it works.
Reset to New –(NO) Rests the controller to its “NEW” factory settings. Select YES and press Enter to reset.
Warning: resetting to new changes all user inputs and master settings back to factory settings which are
shown in green above. Only the current time and date settings are not affected.
