Bogen Easy Design CS1EZ Bedienungsanleitung

Easy Design Speaker

Model CS1EZ

Speaker Layout

The layout of the speakers should be planned before installation

begins. Layout starts in one corner of the room. The first speaker

should be positioned from each wall a distance approximately equal

to the ceiling height of the room.

The next speaker in row 1should be spaced a distance approxi-

mately equal to twice the height of the ceiling. Each additional speak-

er in the row should use this same spacing.

Row 2 starts at twice the ceiling height distance from row 1and

twice the ceiling height from the wall. The other speakers in this row

are also spaced at twice the ceiling height.

Row 3 is again spaced at twice the ceiling height from the previous

row. The first speaker starting this row is positioned at one ceiling

height distance from the wall (similar to row 1).

Continue this pattern of alternating rows until the room is covered.

The spacing of the speakers can be adjusted so that the speakers are

evenly spaced in a row and aesthetically pleasing.

TB8 Tile Bridge - The TB8 supports the weight of the

speaker and recessed enclosure. This is also the item to

which the speaker mounting screws attach. The TB8 is

required for each speaker assembly installed.

TB8

Tile Bridge

RE84

Recessed

Enclosure

RE84 Recessed Enclosure - The RE84 is an optional back box

for ceiling speakers. UL Listed for use where ceiling plenum is

part of an air handling system. The RE84 also includes attach-

ment tabs allowing the enclosure to be supported from struc-

tures other than the actual ceiling grid.

Additional Hardware

50 Spring Street, Ramsey NJ 07446

Tel. 201-934-8500, Fax: 201-934-9832

www.bogen.com

54-5043-01 Printed in Korea 9904

Specifications subject to change without notice.

Speaker Installation

Figure 1

Figure 2

Horseshoe Tab

Locator Tabs

RE84

TB8

CS1EZ

STEP 1 - Remove the tile from ceiling and center the TB8

tile bridge on the back. Use the tile bridge to trace out,

and then cut an 8-1/2” square hole.

NOTE: It is sometimes more efficient to stack up

a number of ceiling tiles and then cut the speaker

opening in a number of them at once.

STEP 2 - If using the optional RE84 Recessed Enclosure,

bend up the 4 horseshoe tabs (see figure 1 on the TB8).

Position the TB8 over the hole in the tile and push down

the locator tabs (see figure 2).

STEP 3 - Using the 4 supplied screws, attach the CS1EZ

to the TB8 using the 4 clips in the corners of the opening

on the TB8 as nuts.

NOTE: Only tighten the screws until the grille is

snug against the tile. Over tightening will cause the

screws to dimple the grille.

STEP 4a - If not using RE84 Recessed Enclosure:

Make the electrical connections using the 2 screw terminals

on the CS1EZ. The suggested amplifier connections are:

70V terminal - 70V HOT

COM terminal - 70V COMMON

NOTE: The speaker will also work perfectly well with

these connections reversed. However, it is important

to be consistent in the wiring of the speakers in the

system. If adjacent speakers have reversed wiring

connections, they will tend to cancel each other’s bass

response, diminishing the sound quality.

STEP 4b - If using RE84 Recessed Enclosure:

Install an entry fitting to a knock-out in the RE84 to

accommodate the plenum cable. Feed cable through RE84

entry and clamp. Make speaker connections as in 4a. All

connections and any splices must be made within the

enclosure. Place the RE84 over the horseshoe tabs (see

step 2) and twist the tabs with pliers to secure the RE84 to

the TB8.

STEP 5 - Place the assembled ceiling tile back into the

ceiling.

Inhaltsverzeichnis

Andere Bogen Sprecher Handbücher

Bogen

Bogen NEAR IG6s2 Bedienungsanleitung

Bogen

Bogen HFSF1 Leitfaden

Bogen

Bogen SP158A Bedienungsanleitung

Bogen

Bogen AMBSL1 Bedienungsanleitung

Bogen

Bogen AMT-12 Dimensionsleitfaden

Bogen

Bogen HFCS1 Leitfaden

Bogen

Bogen HFCS1 Leitfaden

Bogen

Bogen Speaker Line Attenuator UTI1 AUX Bedienungsanleitung

Bogen

Bogen SCW20 Bedienungsanleitung

Bogen

Bogen CSD2X2 Bedienungsanleitung

Bogen

Bogen CSD2X2U-V2 Betriebsanleitung

Bogen

Bogen Easy Design CS1EZ Bedienungsanleitung

Bogen

Bogen OPS1 Bedienungsanleitung

Bogen

Bogen Near Signature S5 Bedienungsanleitung

Bogen

Bogen Nyquist NQ-S1810CT-G2 Bedienungsanleitung

Bogen

Bogen NEAR OPS1 Leitfaden

Bogen

Bogen SM1EZ Bedienungsanleitung

Bogen

Bogen CSD2X2 Bedienungsanleitung

Bogen

Bogen G8G Bedienungsanleitung

Bogen

Bogen Easy Install Bedienungsanleitung

Bogen

Bogen HFCS1LP Leitfaden

Bogen

Bogen NEAR Orbit OCS1 Bedienungsanleitung

Bogen

Bogen Nyquist NQ-S1810CT-T1 Betriebsanleitung

Bogen

Bogen OPS1 Leitfaden

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung