9
Automatic drying programs
Automatic drying programsAutomatic drying programs
Automatic drying programs
The appliance detects the moisture in the load and
automatically adjusts the optimum drying time. The
electronic control ensures the best drying results
even at less loading of the dryer. It is activated in all
programs, except in the program with time control.
Capacity
CapacityCapacity
Capacity
Do not overload the appliance, otherwise the fabrics
will become stretched and drying will be impaired.
Refer to the information in the "Program table".
Drum light
Drum lightDrum light
Drum light
As soon as you open the appliance door, the inside
of the drum is lighted up to ensure that no washing is
left behind when removed. The lamp is switched on
for approx. one minute.
Starting a program
Starting a programStarting a program
Starting a program
NOTE
NOTENOTE
NOTE:
::
:
Humming noises at the start of a drying operation,
which are generated by the compressor start-up, are
normal.
•Connect the appliance to the power supply.
•Put the washing into the drum.
•Switch on the appliance via the power button.
•Select the required operating conditions.
•Press the start/pause button to stat the operation.
Progra
PrograProgra
Program change
m changem change
m change
A change is not possible after a successful startup.
To select a new program, you must switch the appli-
ance off and on again.
End of program
End of programEnd of program
End of program
After completion of the drying process the display
shows [
0:00
] and the corresponding control lamp is
lighting. If the signal function is activated, you will
hear a series of beeps. The control panel switches to
standby mode and starts an automatic anti-crease
cycle.
Automatic anti
Automatic antiAutomatic anti
Automatic anti-
--
-crease cycle
crease cyclecrease cycle
crease cycle
If you do not remove the clothes from the appliance
after the drying process has finished, the appliance
will start the automatic anti-crease cycle of approx.
30 minutes. The appliance continues rotating the
drum in intervals in order to prevent textiles from
creasing. At the end of that cycle the appliance will
stop operating completely.
Switch off
Switch offSwitch off
Switch off
•Switch the appliance off by pressing the power
button.
•Clean the lint filter and empty the condenser wa-
ter tank as described under “Cleaning and
Maintenance”.
•If the appliance is not in use for an extended time:
-
disconnect it from the power supply.
-
leave the appliance door slightly open until the
next dry cycle to avoid odors.
Cleaning and
Cleaning and Cleaning and
Cleaning and Maintenance
MaintenanceMaintenance
Maintenance
WAR
WARWAR
WARNING
NINGNING
NING:
::
:
•Always switch off the appliance and disconnect it
from the power supply before cleaning and user
maintenance.
•Allow the appliance to cool down sufficient before
cleaning.
•Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock!
Risk of electric shock!Risk of electric shock!
Risk of electric shock! Hot steam could damage
the plastic parts. The appliance must be dry be-
fore restarting operation.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
•Do not use a wire brush or other sharp, abrasive
items.
•Do not use any acidic or abrasive detergents.
