Borg BORGD1200 Bedienungsanleitung

WARRANTY INFORMATION

3 YEAR LIMITED WARRANTY

Sunbeam Products, Inc. doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada)

Limited doing business as Jarden Consumer Solutions (collectively “JCS”) warrants that for a period of three years

from the date of purchase, this product will be free from defects in material and workmanship. JCS, at its option, will

repair or replace this product or any component of the product found to be defective during the warranty period.

Replacement will be made with a new or remanufactured product or component. If the product is no longer available,

replacement may be made with a similar product of equal or greater value. This is your exclusive warranty. Do NOT

attempt to repair or adjust any electrical or mechanical functions on this product. Doing so will void this warranty.

This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable.

Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. JCS dealers, service

centers, or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and

conditions of this warranty.

This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or

misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly,

repair or alteration by anyone other than JCS or an authorized JCS service center. Further, the warranty does not

cover: Acts of God, such as fire, flood, hurricanes and tornadoes.

What are the limits on JCS’s Liability?

JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or

statutory warranty or condition.

Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for

a particular purpose is limited in duration to the duration of the above warranty.

JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise.

JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use

the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of

contract, fundamental or otherwise, or for any claim brought against purchaser by any other party.

Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages

or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights that vary from province to province,

state to state or jurisdiction to jurisdiction.

How to Obtain Warranty Service

In the U.S.A.

If you have any question regarding this warranty or would like to obtain warranty service, please call

1-800-397-5964

and a convenient service center address will be provided to you.

In Canada

If you have any question regarding this warranty or would like to obtain warranty service, please call

1-800-397-5964

and a convenient service center address will be provided to you.

WARRANTY INFORMATION

131686/9100010010742 BORGD120009EM1 Printed In China

In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions located

in Boca Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing

business as Jarden Consumer Solutions, located at 20 B Hereford Street, Brampton, Ontario L6Y 0M1. If you have any

other problem or claim in connection with this product, please write our Consumer Service Department. PLEASE DO

NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE.

Distributed by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431.

PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS

Owner’s Guide

BORGD1200

Architect

Table Fan

BORGD1200-U_09EM1.indd 1BORGD1200-U_09EM1.indd 1 12/23/08 10:42:36 AM12/23/08 10:42:36 AM

PLEASE READ AND SAVE THESE

IMPORTANT SAFETY INSTRUCTIONS

FEATURES - OPERATIONS

CLEANING/MAINTENANCE

Follow these instructions to correctly and safely care for

your table fan. Please remember:

• Always unplug the fan before cleaning or

disassembling.

• Do not allow water to drip on or into the Fan Motor

Housing.

• Do not use any of the following as a cleaner:

gasoline, thinner, benzene.

NOTE: This fan can also be used during the cold winter

season to circulate warm air throughout your home.

Fan Blade Cleaning

1. To access the Fan Blade, loosen the Rear Grill Screw,

remove the Front Grill and the Blade Cap.

2. Clean the Fan Blade, Front Grill and Rear Grill with a

soft cloth moistened with a mild soap solution.

3. Replace blade, tighten the Blade Cap, and securely

fasten the Front Grill.

Fan Head and Base Cleaning

Using a soft, moist cloth, with or without a mild soap

solution, carefully clean the Fan Base and Head. Please

use caution around the Motor Housing area. Do not allow

the motor or other electrical components to be exposed to

water.

FAN STORAGE

When storing your fan in the off season, it is important to

keep it in a safe dry location. It is important to protect

the fan head from dust.

ASSEMBLY INSTRUCTIONS

NOTE:MAKE SURE YOU REMOVE ALL CONTENTS FROM

THE PACKAGE. PLEASE CHECK PACKAGING MATERIALS FOR

PARTS THAT COULD BE REQUIRED TO OPERATE YOUR FAN.

1. Remove the Rear Grill Nut from the Motor Housing.

2. Line up the posts located on the front of the Motor

Housing with the holes located around the center of

the Rear Grill.

3. Secure the Rear Grill to the Motor Housing Assembly

by tightening the Rear Grill Nut over the threaded

post of the Motor Housing Assembly.

4. Slide the Fan Blade over the Motor Shaft making sure

the pins located on the Motor Shaft line up with

hollowed interior of the Fan Blade.

5. Secure the Fan Blade onto the Motor Shaft by turning

the Blade Cap counter clockwise and tighten firmly.

6. Center the Front Grill by aligning the BORG™logo

plate parallel to the floor, and then snap the Front

Grill into the clips located around the inner perimeter

of the Rear Grill.

NOTE: you may need to loosen the Grill Screw

located on the bottom of the Rear Grill prior to

securing the Front Grill to the Rear Grill.

7. Tighten the Grill Screw at the bottom of the Rear Grill.

8. Run the power cord through the opening located on the

top of the base and pull the cord all the way through.

Line the tabs located on the bottom of the stem with

the holes located around the pocket of the base and

push the stem down until it is secured to the base.

OPERATING INSTRUCTIONS

1. Set fan on a dry, level surface.

2. Make sure that the Power/Speed Knob is in the off

position ( ). The Power/Speed Knob is located on

the front stem of the fan housing.

3. Plug cord into any standard 120 volt AC outlet.

4. Adjust the speed of your fan by turning the Power/

Speed Knob to the desired setting: 3-High, 2-Medium,

1-Low.

5. To turn the fan off turn the Power/Speed Knob to the

off position ( ).

6. The Oscillation Control Knob ( ) is located on

the top of the Fan Motor Housing. To start Oscillation,

push Oscillation Knob all the way down. To stop

Oscillation, pull Oscillation Knob all the way up.

ADJUSTMENT INSTRUCTIONS

Fan Head Tilt Adjustment

To adjust the angle of the fan head simply grab the stem

with one hand. With your other hand, adjust the angle of

the fan head.

When using electrical appliances, basic safety precautions

should always be followed to reduce the risk of fire,

electric shock, and injury to persons, including the

following:

1. Read all instructions before using this appliance.

2. Use fan only for purposes described in the instruction

manual.

3. To protect against electrical shock do not immerse

unit, plug or cord in water or spray with liquids and

plug the appliance directly into a 120V AC electrical

outlet.

4. Close supervision is necessary when any appliance is

used by or near children.

5. Unplug from outlet when not in use, when moving

fan from one location to another, before putting on

or taking off parts and before cleaning.

6. Avoid contact with moving parts.

7. Do not operate in the presence of explosive and/or

flammable fumes.

8. To avoid fire hazard, NEVER place the cord under

rugs or any parts near an open flame, cooking or

other heating appliance.

9. Do not operate any appliance with a damaged cord

or plug after the appliance malfunctions, or has been

dropped/damaged in any manner.

10. The use of attachments not recommended or sold by

the appliance manufacturer may cause hazards.

11. Do not let the cord hang over the edge of a table,

counter or come in contact with hot surfaces or leave

exposed to high traffic areas.

12. Do not use outdoors.

13. To disconnect, grip plug and pull from wall outlet.

Never yank on cord.

14. Always use on a dry, level surface.

15. Do not operate fan until fully assembled with all

parts properly in place.

16. This product is intended for household use ONLY and

not for commercial or industrial applications.

17. WARNING:To reduce the risk of electrical shock

and injury to persons, do not use in window.

18. WARNING: This fan is provided with an internal

electronic fan speed control. To reduce the risk of fire

or electric shock, do not use this fan with any other

solid-state speed control device.

PLEASE READ AND SAVE

THESE IMPORTANT

SAFETY INSTRUCTIONS

CLEANING / MAINTENANCE

THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the

other). To reduce the risk of electric shock, this plug is intended to fit in

a polarized outlet only one way. If the plug does not fit fully in the

outlet, reverse the plug. If it still does not fit, contact a qualified

electrician to install the proper outlet.

DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS

SAFETY FEATURE IN ANY WAY.

DEJ

FHI

Figure 1

A. Logo Plate

B. Front Grill

C. Blade Cap

D. Fan Blade

E. Rear Grill Nut

F. Rear Grill

G. Rear Grill Screw

H. Motor Shaft

I. Motor Housing Assembly

J. Oscillation Knob

K. Power/Speed Knob

L. Fan Stem

M. Base

If you have any questions regarding your product

please contact our Consumer Service Department at

1-800-397-5964 or visit our website at www.jardencs.com.

BORGD1200-U_09EM1.indd 2BORGD1200-U_09EM1.indd 2 12/23/08 10:42:39 AM12/23/08 10:42:39 AM

Inhaltsverzeichnis

Andere Borg Lüfter Handbücher

Borg

Borg W2100R Bedienungsanleitung

Beliebte Lüfter Handbücher anderer Marken

ELTA FANS

ELTA FANS H03VV-F Bedienungsanleitung

Hunter

Hunter 20714 Gebrauchsanweisung

Emerson

Emerson CARRERA VERANDA CF542ORB00 Bedienungsanleitung

Hunter

Hunter Caraway Gebrauchsanweisung

Panasonic

Panasonic FV-15NLFS1 Bedienungsanleitung

Kompernass

Kompernass KH 1150 Bedienungsanleitung

VES

VES FALA100/12V/TR Bedienungsanleitung

Vertiv

Vertiv Liebert DCD Bedienungsanleitung

Westinghouse

Westinghouse GFP Series Bedienungsanleitung

Venmar

Venmar KUBIX HRV PLUS Series Bedienungsanleitung

Maico

Maico ECR 31 Bedienungsanleitung

Sonnenkonig

Sonnenkonig Dinky Bedienungsanleitung

S&P

S&P ECOWATT HXBR Bedienungsanleitung

Wider

Wider IMP03369BH Bedienungsanleitung

Panasonic

Panasonic F-60DHN Bedienungsanleitung

Hinkley

Hinkley HIGHLAND Bedienungsanleitung

Broan

Broan 766BN Bedienungsanleitung

Premium

Premium PFS16022 Montageanleitung