Bosch VBN-5085 Bedienungsanleitung

DINION 5000 AN

VBN-5085

en Installation Manual

DINION 5000 AN Table of Contents | en 3

Bosch Security Systems Installation Manual AM18-Q0644 | v1.0 | 2013.03

Table of Contents

1Safety 5

1.1 Safety precautions 5

1.2 System ground/Safety ground 5

1.3 Important safety instructions 6

1.4 Important notices 7

1.5 FCC information 8

1.6 UL certification 9

1.7 Bosch notice 9

2 Introduction 10

2.1 Features 10

3 Installation 11

3.1 Unpacking 11

4 Connection and mounting 12

4.1 Power connection 12

4.1.1 Low voltage cameras 12

4.1.2 High voltage cameras 13

4.2 Video connections 14

4.2.1 Output Video signal 14

4.3 Alarm and relay connector 15

4.4 Lens mounting 16

4.5 Back focus adjustment 17

4.6 Mounting the camera 19

5 Configuration 20

5.1 Menus 20

5.1.1 Top level menus 20

5.1.2 Menu navigation 21

5.2 Pre-defined modes 22

5.3 Day/Night switching 23

5.4 Camera control communication (Bilinx) 23

5.5 Main menu structure 24

5.5.1 Mode submenu 24

4en | Table of Contents DINION 5000 AN

AM18-Q0644 | v1.0 | 2013.03 Installation Manual Bosch Security Systems

5.5.2 Exposure submenu 25

5.5.3 Day/Night submenu 27

5.5.4 Enhance / Dynamic Engine submenu 29

5.5.5 Color submenu 31

5.5.6 VMD submenu 32

5.5.7 Image Adjustment submenu 33

5.6 Install menu structure 34

5.6.1 Language submenu 35

5.6.2 Lens Wizard submenu 35

5.6.3 Synchronization submenu 37

5.6.4 Alarm I/O submenu 38

5.6.5 Connections submenu 39

5.6.6 Test signal submenu 39

5.6.7 Camera ID submenu 40

5.6.8 Privacy masking submenu 41

5.6.9 Flip submenu 41

5.6.10 Defaults submenu 42

6Troubleshooting 43

6.1 Resolving problems 43

6.2 Customer service 44

7 Maintenance 45

7.1 Repairs 45

7.1.1 Transfer and disposal 45

8 Technical Data 46

8.1 Specifications 46

8.1.1 Dimensions 48

8.1.2 Accessories 49

DINION 5000 AN Safety | en 5

Bosch Security Systems Installation Manual AM18-Q0644 | v1.0 | 2013.03

1Safety

1.1 Safety precautions

1.2 System ground/Safety ground

System (video) ground is indicated by the symbol .

Safety (power) ground is indicated by the symbol .

The system ground is only used to comply with safety standards

or installation practices in certain countries. Bosch does not

recommend connecting system ground to safety ground unless

it is explicitly required. However, if the system ground and

safety ground are connected and grounding loops are causing

interference in the video signal, use an isolation transformer

(available separately from Bosch).

DANGER!

High risk: This symbol indicates an imminently hazardous

situation such as "Dangerous Voltage" inside the product.

If not avoided, this will result in an electrical shock, serious

bodily injury, or death.

WARNING!

Medium risk: Indicates a potentially hazardous situation.

If not avoided, this could result in minor or moderate bodily

injury.

CAUTION!

Low risk: Indicates a potentially hazardous situation.

If not avoided, this could result in property damage or risk of

damage to the unit.

CAUTION!

Connecting System ground to Safety ground may result in

ground loops that can disrupt the CCTV system.

6en | Safety DINION 5000 AN

AM18-Q0644 | v1.0 | 2013.03 Installation Manual Bosch Security Systems

1.3 Important safety instructions

Read, follow, and retain for future reference all of the following

safety instructions. Heed all warnings on the unit and in the

operating instructions before operating the unit.

1. Cleaning - Generally, using a dry cloth for cleaning is

sufficient but a moist, fluff-free cloth or leather shammy

may also be used. Do not use liquid cleaners or aerosol

cleaners.

2. Heat Sources - Do not install the unit near any heat

sources such as radiators, heaters, stoves, or other

equipment (including amplifiers) that produce heat.

3. Water - Never spill liquid of any kind on the unit.

4. Lightning - Take precautions to protect the unit from

power and lightning surges.

5. Controls adjustment - Adjust only those controls specified

in the operating instructions. Improper adjustment of

other controls may cause damage to the unit.

6. Power sources - Operate the unit only from the type of

power source indicated on the label.

7. Servicing - Unless qualified, do not attempt to service this

unit yourself. Refer all servicing to qualified service

personnel.

8. Replacement parts - Use only replacement parts specified

by the manufacturer.

9. Installation - Install in accordance with the manufacturer's

instructions and in accordance with applicable local codes.

10. Attachments, changes or modifications - Only use

attachments/accessories specified by the manufacturer.

Any change or modification of the equipment, not

expressly approved by Bosch, could void the warranty or,

in the case of an authorization agreement, authority to

operate the equipment.

DINION 5000 AN Safety | en 7

Bosch Security Systems Installation Manual AM18-Q0644 | v1.0 | 2013.03

1.4 Important notices

Disposal - Your Bosch product was developed and

manufactured with high-quality material and components that

can be recycled and reused. This symbol means that

electronic and electrical appliances, which have reached the

end of their working life, must be collected and disposed of

separately from household waste material. Separate collecting

systems are usually in place for disused electronic and

electrical products. Please dispose of these units at an

environmentally compatible recycling facility, per European

Directive 2002/96/EC

WARNING!

Power disconnect for high voltage versions: A unit has power

supplied whenever the power cord is inserted into the power

source. The power cord plug is the main power disconnect for

the unit. For pluggable equipment, install the socket outlet near

the equipment so it is easily accessible.

WARNING!

All-pole power switch: Incorporate an all-pole power switch,

with a contact separation of at least 3 mm in each pole, into the

electrical installation of the building.

CAUTION!

Fuse rating: The branch circuit protection must be secured with

a maximum fuse rating of 16 A. This must be in accordance with

NEC800 (CEC Section 60).

CAUTION!

The Low Voltage power supply unit must comply with EN/UL

60950. The power supply must be a SELV-LPS unit or a SELV -

Class 2 unit (Safety Extra Low Voltage - Limited Power Source).

8en | Safety DINION 5000 AN

AM18-Q0644 | v1.0 | 2013.03 Installation Manual Bosch Security Systems

1.5 FCC information

FCC & ICES Information

(U.S.A. and Canadian Models Only)

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following

measures:

– reorient or relocate the receiving antenna;

– increase the separation between the equipment and

receiver;

– connect the equipment into an outlet on a circuit different

from that to which the receiver is connected;

– consult the dealer or an experienced radio/TV technician

for help.

Intentional or unintentional modifications, not expressly

approved by the party responsible for compliance, shall not be

made. Any such modifications could void the user's authority to

operate the equipment. If necessary, the user should consult

the dealer or an experienced radio/television technician for

corrective action.

The user may find the following booklet, prepared by the

Federal Communications Commission, helpful: How to Identify

and Resolve Radio-TV Interference Problems. This booklet is

available from the U.S. Government Printing Office,

Washington, DC 20402, Stock No. 004-000-00345-4.

DINION 5000 AN Safety | en 9

Bosch Security Systems Installation Manual AM18-Q0644 | v1.0 | 2013.03

1.6 UL certification

Disclaimer

Underwriter Laboratories Inc. ("UL") has not tested the

performance or reliability of the security or signaling aspects of

this product. UL has only tested fire, shock and/or casualty

hazards as outlined in UL's Standard(s) for Safety for Information

Technology Equipment, UL 60950-1. UL Certification does not

cover the performance or reliability of the security or signaling

aspects of this product.

UL MAKES NO REPRESENTATIONS, WARRANTIES, OR

CERTIFICATIONS WHATSOEVER REGARDING THE

PERFORMANCE OR RELIABILITY OF ANY SECURITY OR

SIGNALING-RELATED FUNCTIONS OF THIS PRODUCT.

1.7 Bosch notice

More information

For more information please contact the nearest Bosch Security

Systems location or visit www.boschsecurity.com

10 en | Introduction DINION 5000 AN

AM18-Q0644 | v1.0 | 2013.03 Installation Manual Bosch Security Systems

2 Introduction

2.1 Features

The DINION 5000 Day/Night WDR camera is a high-

performance, smart, surveillance color camera. It uses a wide

dynamic range 960H CCD sensor for outstanding picture

performance.

The camera is easy to install and ready to use, and offers the

best solution for demanding scene conditions. Features

include:

– 1/3-inch 960H CCD sensor with wide dynamic range

– True Day/Night performance with switchable IR filter

– 720TVL sensor resolution

– High Dynamic Range

– Privacy zones

– Detail enhancement

– Bilinx (bi-directional coaxial communication)

– Wide operating temperature range

–Lenswizard

– Six pre-programmed operation modes

– Dynamic noise reduction

– Multiple language on-screen display

– Built-in test pattern generator

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Bosch Sicherheitskamera Handbücher

Bosch

Bosch VG4-522-ECS0WF Bedienungsanleitung

Bosch

Bosch VEZ-400 Series Bedienungsanleitung

Bosch

Bosch VC7D1305T Bedienungsanleitung

Bosch

Bosch VG4-100 Series Bedienungsanleitung

Bosch

Bosch LTC 0510 Series Bedienungsanleitung

Bosch

Bosch DINION IP 4000 HD Bedienungsanleitung

Bosch

Bosch FlexiDomeXF VDC-485V03-10 Bedienungsanleitung

Bosch

Bosch NDN-498 FlexiDome2X Bedienungsanleitung

Bosch

Bosch MIC Series 550 Bedienungsanleitung

Bosch

Bosch MIC Series 440 Bedienungsanleitung

Bosch

Bosch VDN-498V03-11 Bedienungsanleitung

Bosch

Bosch BasicDome Series Bedienungsanleitung

Bosch

Bosch FlexiDome NDC-455V03-21P Bedienungsanleitung

Bosch

Bosch MIC IP fusion 9000i Bedienungsanleitung

Bosch

Bosch DCN-SWSACC Montageanleitung

Bosch

Bosch NWD-495 Bedienungsanleitung

Bosch

Bosch AUTODOME IP starlight 5000i IR Bedienungsanleitung

Bosch

Bosch NBN-498 Bedienungsanleitung

Bosch

Bosch AUTODOME IP 5000 IR Bedienungsanleitung

Bosch

Bosch LTC 0465 Series Bedienungsanleitung

Bosch

Bosch UHI-OG-0 Bedienungsanleitung

Bosch

Bosch VEZ-400 Series Bedienungsanleitung

Bosch

Bosch VDC-480V03-20S Bedienungsanleitung

Bosch

Bosch FLEXIDOME AN micro 1000 Bedienungsanleitung

Beliebte Sicherheitskamera Handbücher anderer Marken

Okina USA

Okina USA SIR36-870VF650LP Bedienungsanleitung

Divio

Divio NDR155PA Bedienungsanleitung

Canon

Canon VB-C500D Bedienungsanleitung

Easy Access

Easy Access EasyGuard Bedienungsanleitung

Vivotek

Vivotek FD9389-EHV-v2 Bedienungsanleitung

TUYA

TUYA COSMO W2 Bedienungsanleitung

Eusso

Eusso UNC7500-IR Einrichtungshandbuch

urmet domus

urmet domus 1096/204 Bedienungsanleitung

VC VC20 series Bedienungsanleitung

Axis

Axis Q1614 Bedienungsanleitung

ieGeek

ieGeek DD201 Bedienungsanleitung

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Bedienungsanleitung

Vicon

Vicon V662-D-1 Betriebsanleitung

Grundig

Grundig GCH-K0274P Bedienungsanleitung

Lorex

Lorex VANTAGE LBC7032 Bedienungsanleitung

4xem

4xem WPT Bedienungsanleitung

Samsung

Samsung SCV-3082 Bedienungsanleitung

Vitek

Vitek VTC-C544 Bedienungsanleitung