Bosch AVIOTEC IPSTARLIGHT 8000 Bedienungsanleitung

AVIOTEC IP starlight 8000

FCS-8000-VFD-B

en Operation Manual

Table of contents

1Safety instructions 5

1.1 General Safety Messages / Notices 5

2Introduction 8

2.1 Disclaimer 8

2.2 About this manual 8

2.3 Conventions in this manual 8

2.4 Definition of optical terms 8

2.4.1 Illumination 8

2.4.2 Focal length 9

2.4.3 Monitoring Area 10

3System Overview 11

3.1 Camera 11

3.1.1 Power supply 11

3.1.2 Uninterruptible Power Supply 12

3.2 Algorithm 12

3.2.1 Flame detection characteristics 13

3.2.2 Smoke detection characteristics 14

3.3 IVA 15

3.4 Video Management System 15

4Planning 16

4.1 Minimum distances 16

4.2 Maximum distances 17

4.3 Image margin area 18

4.4 Immediate environment of the camera 20

4.4.1 Illumination and brightness 20

4.4.2 Privacy protection 20

5Installation 21

5.1 Lens mounting 21

5.2 Camera mounting 24

5.3 Setting the field of view 24

5.4 Wiring of the camera 26

6Camera integration 28

6.1 Local Area Network 29

6.2 Local Area Network with recording solution 29

6.3 Monitoring Center 30

6.4 Fire Alarm Control Panel 30

6.5 Mobile Devices 33

7Access via web interface 35

8Detection settings 36

8.1 General settings 36

8.1.1 Sensitivity 36

8.1.2 Min. Size 36

8.1.3 Verification time [sec] 36

8.2 Masking 37

8.2.1 Mask 37

8.2.2 Time region mask 37

AVIOTEC IP starlight 8000 Table of Contents | en 3

Bosch Sicherheitssysteme GmbH Operation Manual 2016.02 | 1.0 | F.01U.318.200

9Troubleshooting 38

9.1 Smoke and flame detection 38

9.2 Camera 38

10 Maintenance 40

10.1 Cleaning 40

10.2 Repair 40

10.3 Reset 40

11 Technical data 41

12 Appendices 43

12.1 Maximum detection distances for margin areas 43

12.1.1 Flame detection 44

12.1.2 Smoke detection 46

Index 49

4en | Table of Contents AVIOTEC IP starlight 8000

2016.02 | 1.0 | F.01U.318.200 Operation Manual Bosch Sicherheitssysteme GmbH

Safety instructions

In this document, the following symbols and notations are used to draw attention to special

situations:

Danger!

Indicates a hazardous situation which, if not avoided, will result in death or serious injury.

Warning!

Indicates a hazardous situation which, if not avoided, could result in death or serious injury.

Caution!

Indicates a hazardous situation which, if not avoided, could result in minor or moderate

injury.

Notice!

Indicates a situation which, if not avoided, could result in damage to the equipment or

environment, or data loss.

General Safety Messages / Notices

Warning!

Do not moisten the electronic appliances inside of the lens.

It may cause fire or electric shock. In this case, shut off the power supplied to the lens

immediately.

Caution!

Do not leave or store the lens under direct sunshine.

The lens may focus rays of light on a near-by object and cause fire.

Caution!

In case of unusual behavior, smoke, noise or smell coming out of the lens, shut off the power

immediately and pull out the lens cable.

Notify the installer or sales agent from which you purchased the product.

Notice!

Avoid obstructions in the field of view!

Covered fires cannot be detected correctly. An unobstructed view of the detection area is

necessary.

Notice!

Activating video-based fire detection sets camera settings to a specific preset.

This preset affects several camera settings as long as this mode is activated.

1.1

AVIOTEC IP starlight 8000 Safety instructions | en 5

Bosch Sicherheitssysteme GmbH Operation Manual 2016.02 | 1.0 | F.01U.318.200

Notice!

No detection of moving fire.

Moving fires will not be detected by the video-based fire detection.

Notice!

Indoor use only.

This product is designed for indoor use only. Outdoor use is not allowed.

Notice!

No direct connection to fire services in EN54 compliant installations.

Authorities can allow a connection to fire services after verifying alarms in a monitoring

center.

Notice!

Minimum Illumination required.

To ensure the proper functioning of the video-based fire detection algorithm, a minimal

illumination of 7 lx is required.

Notice!

No existing standards.

There are no existing EN standards concerning the video-based fire detection.

Notice!

Calm wind conditions only.

Strong air currents can cause false alarms by raising dust or debris similar in appearance to

fire and smoke.

Notice!

Respect data protection.

The relevant data protection and privacy rules are to be complied with.

Notice!

Avoid backlight.

Backlight can disturb the video-based fire detection algorithm.

Notice!

Optimized smoke detection.

The video-based fire detection algorithm is optimized for smoke of smoldering fires.

Notice!

Qualified personnel only.

Assembly and installation must only be performed by qualified personnel.

6en | Safety instructions AVIOTEC IP starlight 8000

2016.02 | 1.0 | F.01U.318.200 Operation Manual Bosch Sicherheitssysteme GmbH

Notice!

Reduced detection distances at image margin area.

Due to optical distorsion of the lens, the maximum detection distances at the image margin

area are reduced.

Notice!

Avoid image regions with continuous upward motion.

Continuous upward motion might lead to false alarms.

Notice!

Make sure the camera is firmly mounted.

Camera shake might lead to false alarms. Avoid vibrations of the camera and the camera

environment.

AVIOTEC IP starlight 8000 Safety instructions | en 7

Bosch Sicherheitssysteme GmbH Operation Manual 2016.02 | 1.0 | F.01U.318.200

Introduction

Disclaimer

Video Fire indication systems are video content analysis systems. They give indications for

fires and are designed to supplement fire detection systems and human guards in

monitoring centers.

Video Fire indication systems are confronted with a higher amount of challenges

considering scenery and background compared to conventional fire detection systems. It

cannot be granted that fire is detected in all scenery settings. Thus the video fire detection

system shall be seen as a system that enhances the probability of early fire detection, with

the restriction that it might detects false alarm. It shall not be seen as a system that

ensures fire detection in all possible image scenarios.

About this manual

This manual has been compiled with great care and the information it contains has been

thoroughly verified. The text was correct at the time of printing, however, the content can

change without notice. Bosch Security Systems accepts no liability for damage resulting

directly or indirectly from faults, incompleteness or discrepancies between this manual and

the product described.

For more information please contact the nearest Bosch Security Systems location or visit

www.boschsecurity.com

All hardware and software product names used in this document are likely to be registered

trademarks and must be treated accordingly.

The operation manual provides an overview of possibilities and fields of application of the

video-based fire detection. It should be a guideline for customer-specific application planning.

Conventions in this manual

Terms concerning the adjustment of the smoke and flame algorithm, such as menu options,

commands or text in the user interface, are written in bold.

Definition of optical terms

The reflected light coming from the field of view arrives at the camera lens. The image sensor

of the camera transforms the light into electric signals. This electrical image is the basis for

further data processing. This chapter contains basic descriptions of optical terms.

Illumination

Illumination is an important influencing factor for sensible optical systems. Natural light shows

the huge range of illumination values from direct sunlight (~100.000 lx) to full moon on a clear

night (~1.0 lx). A luxmeter can be used to measure the light levels.

The following table provides an overview of typical illumination values in different application

areas:

Application Area Illumination (in lx)

Storage facility 50

Process plants 200

2.1

2.2

2.3

2.4

2.4.1

8en | Introduction AVIOTEC IP starlight 8000

2016.02 | 1.0 | F.01U.318.200 Operation Manual Bosch Sicherheitssysteme GmbH

Sales room 300

Office space 500

In general a well illuminated monitoring area is advantageous for the video-based fire

detection. Backlight should be avoided.

Focal length

The focal length of an optical system defines the distance between a light refracting lense and

the focal point. Field of view, maximum distance and field angle are dependant as shown in

the graphic below.

4.1

6.5

The maximum width of the field of view may be realized by the minimum focal length. This

adversely affects the maximum distance to a detectable fire.

The maximum distance to a detectable fire may be reached by adjusting the largest focal

length which decreases the width of the field of view to the minimum.

2.4.2

AVIOTEC IP starlight 8000 Introduction | en 9

Bosch Sicherheitssysteme GmbH Operation Manual 2016.02 | 1.0 | F.01U.318.200

Monitoring Area

The monitoring area defines the effective space that can be observed by the video-based fire

detection. It is depending on the setting of the camera lens.

Beliebte Sicherheitssystem Handbücher anderer Marken

Inner Range

Inner Range Concept 2000 Bedienungsanleitung

Climax

Climax Mobile Lite R32 Montageanleitung

FBII

FBII XL-31 Series Bedienungsanleitung

Johnson Controls

Johnson Controls PENN Connected PC10 Bedienungsanleitung

Aeotec

Aeotec Siren Gen5 Bedienungsanleitung

IDEAL

IDEAL Accenta Betriebsanleitung

Swann

Swann SW-P-MC2 Bedienungsanleitung

Ecolink

Ecolink Siren+Chime Bedienungsanleitung

Digital Monitoring Products

Digital Monitoring Products XR150 Bedienungsanleitung

EDM

EDM Solution 6+6 Wireless-AE Bedienungsanleitung

Siren

Siren LED GSM Bedienungsanleitung

Detection Systems

Detection Systems 7090i Montageanleitung

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Bedienungsanleitung

Siemens

Siemens FDM273 Bedienungsanleitung

DSC

DSC PC 4010 Betriebsanleitung

UniPOS

UniPOS 6202L Bedienungsanleitung

AJAX

AJAX DoubleButton Bedienungsanleitung

Rondish

Rondish Nexus Bedienungsanleitung