Assuming the unit is cooling and there are
no leaks, unplug the pump.
Replace the 3-piece reservoir cover
ensuring all tubing and the pump power
cord are routed through the slotted corner.
The top cover is optional so it may be
set aside.
Plug the pump in to your temperature controller.
Set your desired fermentation temperature by
following the instructions provided with the
temperature controller.
Conrm the IceMaster reservoir temperature is
properly set to where you need it.
CONGRATULATIONS, YOUR SYSTEM IS READY!CONGRATULATIONS, YOUR SYSTEM IS READY!
The temperature controller (found just above the red power switch near the bottom of the unit) has several
functions to help maintain ideal conditions to control your fermentations.
THE CONTROLLER UNIT ITSELFTHE CONTROLLER UNIT ITSELF
IS FAIRLY STRAIGHTFORWARD,IS FAIRLY STRAIGHTFORWARD,
BUT IT’S STILL A GOOD IDEABUT IT’S STILL A GOOD IDEA
TO GET FAMILIAR WITH THETO GET FAMILIAR WITH THE
BUTTONS/FUNCTIONS.BUTTONS/FUNCTIONS.
THE DESIRED TEMPERATURE SETTING
TEMPERATURE DIFFERENTIAL
IceMaster will cycle on/o to keep its temperature
within the set range of the set temperature –
example: if you set the temperature at 5°C and
the dierentialto 1°C, the unit will cycle on at 6°C
and chill the reservoir till the temperature cools
back down to 5°C.
COMPRESSOR DELAY TIME IN MINUTES
This feature protects the unit from turning on/
o too quickly, and potentially damaging the
compressor. The range is from 1-10 minutes
with the default set at 3.
CALIBRATES THE ICEMASTER AGAINST AN
ACCURATE THERMOMETER
Generally,theunitdoesnotneedanyadditional
calibration. However, to nd the correct
adjustment – place an accurate thermometer
in the unit and compare against the controller
readout. If needed, set the calibration on the
controller +/- by the number of degrees it is
o. This will ensure the unit is adjusting to
your desired temperature properly.
TO MAKE CHANGES TO ANY
OF THE FUNCTIONS
Hold down the Sbutton until
F1 shows on the controller,
release the button.
Select the desired function by
clicking the UP or DOWN arrows
until the controller shows the
correct function number.
Press & hold the Sbutton while
using the UP/DOWN arrows to
adjust to your desired setting.
Release the Sbutton
And nally, press the POWER
button to lock in the setting.
IceMaster does not turn on
IceMaster does not seem
cold enough
IceMaster shuts o/on
too oen
IceMaster is always on
IceMaster seems to make
too much noise
Check temperature setting by placing a thermometer inside reservoir.
Check aer 30 minutes & compare against set unit temperature.
Calibrate with F4 function on controller as needed.
Check set temperature range. Adjust F2 function on controller
to a higher range.
Ambient room temperature is too high, so unit is working harder
to cool to set temperature.
Humming is normal and gurgling sounds are caused by cooling
liquid used by the unit. The unit may not be not level.
Check circuit breaker or fuse ; Check plugs.
FUNCTION SETTINGS
FUNCTION CHANGES
CONTROLLER BASICS
f1
f2
f3
f4
•To turn on/o - hold the POWER
button down for few seconds.
•The readout on the controller will
show the temperature (Celsius) of
the liquid inside the IceMaster.
•To check the temperature setting
- press & hold the UP arrow.
•To check the dierential
(+/- range from the set temp) -
press & hold the DOWN arrow.
Final Set-Up
ICEMASTER TEMPERATURE CONTROLLER SETTINGS
MAINTENANCE/
CLEANING
To ensure the unit
continues to properly
function it is good
practice to dust/clean
the heat exchangers
every 6 months.
TROUBLESHOOTING
1
2
3
4
5
6
1
2
3
4
5
