Bromic Heating FD4T0660H Bedienungsanleitung

Conﬁdence and control.

REVISION 2 | 10/07/2023

INSTRUCTION MANUAL

HOT & AMBIENT FOOD DISPLAYS

3736300, 3736301, 3736302, 3736303, 3736312

3736304, 3736305, 3736306, 3736307

CONTENTS

Note: Bromic Refrigeration reserves the right to make changes to speciﬁcations, parts, components and equipment without prior notiﬁcation.

This Installation, operation and service manual may not be reproduced in any form with prior written consent from Bromic Refrigeration.

1. PREFIX

2. IMPORTANT NOTES & WARNINGS

3. PRODUCT OVERVIEW

4. INSTALLATION

5. OPERATION

6. PRODUCT LOADING AND STORAGE

7. TROUBLESHOOTING

8. OPTIONAL ACCESSORIES

ENVIRONMENTAL & DISPOSAL NOTES

10. WARRANTY

1300 276 642bromicrefrigeration.com.au

1. PREFIX

This manual contains important information about the installation, operation, and maintenance

of Bromic Food Display units. Please pay close attention to the important safety information

shown throughout this instruction manual. Any safety information will be accompanied by the

following safety alert symbols:

DANGER, WARNING, IMPORTANT

• READ THIS MANUAL CAREFULLY before installing or

servicing this product.

• Improper installation, operation, or maintenance can result

in death, severe injury, or property damage.

• Improper installation, operation, or maintenance may also

result in warranty being voided.

• This appliance is intended for 230-240 Volt power supply.

• Installation MUST be carried out by a licensed and

authorised technician in accordance with local electrical

codes.

1300 276 642 bromicrefrigeration.com.au

• Read all instructions before installing or using this appliance

• Retain this manual for future reference

• Use this appliance only as described in this manual. Any other use not recommended by the

manufacturer may cause ﬁre, electric shock or injury.

• Improper installation, adjustment or alteration and failure to follow the warnings and instructions in

this manual could result in severe personal injury, death or property damage

• The manufacturer is not responsible for any damage that could happen from improper use. The

manufacturer emphasises that this appliance should be used in a responsible manner and that all

procedures, warnings, and safety instructions contained in this booklet be followed strictly.

• Check the appliance for damage. Do not operate a damaged unit.

• Check for damage to the appliance regularly. If damage to the appliance is suspected, discontinue

use immediately and contact the supplier or qualiﬁed person to repair.

• This appliance is not intended for use by people (including children) with reduced physical, sensory

or mental capabilities, or lack of experience and knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a person responsible of their safety.

• Keep packaging material out reach of children

• Children should be carefully supervised to ensure that they do not play with the appliance

• Do not attempt to alter the appliance in any manner.

• Please pay attention to the maximum load limit when ﬁlling the shelves.

• All work on electrical equipment must be carried out by a qualiﬁed and licensed technician only.

• Do not perform maintenance until the appliance has been turned o and power disconnected.

• Never detach any cover except where speciﬁcally instructed in this manual. Doing so might expose

live electrical parts.

• Do not operate the appliance with panels, covers or guards removed.

• Keep the air intake and outlets free of obstructions.

• Do not use the appliance outdoors.

• If the supply cord becomes damaged, it must be replaced by an authorised service agent or similarly

qualiﬁed person in order to avoid a hazard.

• If the appliance has not been used, or will not be used for a long period of time, disconnect

power supply.

• Ensure the appliance has adequate ventilation.

2. IMPORTANT NOTES AND WARNINGS

1300 276 642bromicrefrigeration.com.au

3. PRODUCT OVERVIEW

FD4T0660H FD4T0900H FD4T1200H FD4T1500H FD4T1800H

Part Number 3736312 3736304 3736305 3736306 3736307

External Dimension

Height, mm 1360 1360 1360 1360 1360

Width, mm 660 900 1200 1500 1800

Depth, mm 740 740 740 740 740

Capacity Litres 300 350 470 580 700

Weight kg 155 186 204 223 242

Net Volume Litres 300 417 542 686 830

Air Circulation Type Forced Forced Forced Forced Forced

Temperature

Range 50°C to 70°C 50°C to 70°C 50°C to 70°C 50°C to 70°C 50°C to 70°C

Type Digital Digital Digital Digital Digital

Exterior Material Stainless Steel Stainless Steel Stainless Steel Stainless Steel Stainless Steel

Interior Material Stainless Steel Stainless Steel Stainless Steel Stainless Steel Stainless Steel

Electrical

Voltage, V 240 240 240 240 240

Frequency, Hz 50 50 50 50 50

Current, A 4.7 7.5 9.9 10 15

Power, W 1138 1800 2382 2411 3600

Internal Light Type LED LED LED LED LED

Colour

Temperature

Warm White,

3000K

Warm White,

3000K

Warm White,

3000K

Warm White,

3000K

Warm White,

3000K

Door

Solid/Glass Glass Glass Glass Glass Glass

Type Hinged Sliding Sliding Sliding Sliding

Self-Closing No No No No No

Door Lock No No No No No

Shelves Qty 3+base 3+base 3+base 3+base 3+base

Weight Limit,

kg 20 20 21 23 28

Adjustable Height&angle Height&angle Height&angle Height&angle Height&angle

Plug Rating 10A 10A 10A 10A 10A

HOT DISPLAYS

1300 276 642 bromicrefrigeration.com.au

FD4T0900A FD4T1200A FD4T1500A FD4T1800A

Part Number 3736300 3736301 3736302 3736303

External Dimension

Height, mm 1360 1360 1360 1360

Width, mm 660 900 1200 1500

Depth, mm 740 740 740 740

Capacity Litres 417 542 686 830

Weight kg 142 174 206 238

Exterior Material Stainless Steel Stainless Steel Stainless Steel Stainless Steel

Interior Material Stainless Steel Stainless Steel Stainless Steel Stainless Steel

Electrical

Voltage, V 240 240 240 240

Frequency, Hz 50 50 50 50

Current, A 0.2 0.26 0.35 0.49

Power, W 47 58 86 119

Door

Solid/Glass Glass Glass Glass Glass

Type Sliding Sliding Sliding Sliding

Self-Closing No No No No

Internal Light Type LED LED LED LED

Colour

Temperature

Warm White,

3000K

Warm White,

3000K

Warm White,

3000K

Warm White,

3000K

Shelves Qty 3+base 3+base 3+base 3+base

Weight Limit,

kg 20 21 23 28

Adjustable Height&angle Height&angle Height&angle Height&angle

Plug Rating 10A 15A 15A 15A

AMBIENT DISPLAYS

1300 276 642bromicrefrigeration.com.au

4. INSTALLATION

Locating the Cabinet

Ensure the following instructions are observed as this is vital for proper and trouble-free operation.

• Do not install the cabinet outdoors.

• Locate the appliance in a dry and well ventilated place.

• The unit must be positioned on a level surface.

• Do not install in the vicinity of heating radiators or other heat sources.

• Do not install the appliance where it is exposed to direct sunlight.

• Keep the air intake and outlets free of obstructions (for Warm showcase only).

Before Operating

• Remove all the packaging material before using the appliance.

• Start the appliance only if it has been installed as described.

Power Supply

• The appliance must not be plugged into a multiple outlet power board.

• The appliance is supplied with a ﬂexible power cord ﬁtted with a 3-pin plug.

• The socket used must be properly earthed and fuse/RCD protected.

• See the rating label inside the cabinet for supply voltage, frequency and current draw.

• Power cable is rated 70°C. It is recommended that the cable should not come into contact

with parts over 50°C.

• Do not turn o power before consulting the person responsible.

• Mark the power source clearly, so the cabinet is not unplugged or turned o accidentally.

1300 276 642 bromicrefrigeration.com.au

5. OPERATION

Start-up

• Connect the appliance to the mains power supply and turn on the main switch (blue) by

ﬂipping it upward.

• Switch on the Heating (for Warm showcase) and Lighting switches, and check that the fan

(for Warm showcase) and lighting are working correctly.

• The electronic controller will display the current cabinet temperature after the Heating

switch is turned on (for Warm showcase).

• Make sure the unit is clear of obstructions on all sides, and the electrical cable is not

touching the external surface of the appliance, as the surface can be hot during operation.

Setting the temperature (For Warm showcase)

i. Press the button for more than 3 seconds.

ii. The value of the set point will be displayed and the ‘°C’ or ‘°F’ LED starts blinking.

iii. Press or arrow key within 10 seconds to adjust the set point.

iv. Press the key again or wait 10 seconds.

Handling (For Warm showcase)

WARNING: Appropriate PPE (Personal Protective Equipment) must be worn when

using the warm showcase cabinet. High surface temperature inside the cabinet may

cause severe injury.

WARNING: Untrained personnel are not allowed to operate the cabinet due to

safety risk related to high surface temperature.

1300 276 642bromicrefrigeration.com.au

6. PRODUCT LOADING AND STORAGE

Start-up

• Clean the interior surface with a soft cloth and warm water before loading.

• There are 2 water trays located at the base of the Warm showcase, ﬁll the tray with water

to help preventing food getting dried during heating.

• Ensure there is free circulation of air between the products.

• Do not block the airways.

• Do not overstock the unit.

• Keep the door openings to a minimum.

• Some products are sensitive to ultraviolet (UV) light, please see storage guidelines from

the manufacturer before removing from packaging.

• Maximum recommended shelf load (for each shelf) is speciﬁed in section 3 (page 5) of

this manual. Do not overstock.

IMPORTANT: Run the appliance for at least 1 hours before loading.

7. MAINTENANCE

Cleaning the Cabinet

• Remove the products and transfer to a suitable location prior to cleaning the inside

of the cabinet.

• Do not use any aggressive or abrasive cleaning agents.

• Never use a water hose or a high-pressure jet to clean.

• Do not use sharp or pointed objects for cleaning.

• Clean the inside and outside of the appliance with a clean damp cloth or with a

neutral cleanser.

• Dry all surfaces with a dry cloth.

WARNING: Disconnect the appliance from the power supply before performing any

maintenance. Never unplug the appliance by pulling on the cord. Always grasp the

plug ﬁrmly and pull straight out of the outlet.

WARNING: Exposure to signiﬁcant water ingress will void warranty and cause

potential safety issues. If the unit should be exposed to water, please contact the

manufacturer immediately.

IMPORTANT: Warranty may be void if there is no evidence of preventative

maintenance is performed on the appliance.

WARNING: WARNING: Never store explosive substances such as aerosol cans with

a ﬂammable propellant inside the appliance.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Bromic Heating Vitrine Handbücher

Bromic Heating

Bromic Heating DD1250SG-NR Bedienungsanleitung

Beliebte Vitrine Handbücher anderer Marken

Hatco

Hatco FLAV-R-SAVOR FSCD Series Bedienungsanleitung

Bonnet Neve

Bonnet Neve SKYLIGHT Bedienungsanleitung

True

True TCGD-50 Bedienungsanleitung

Tecnodom

Tecnodom EVO SELF Betriebsanleitung

Delfield

Delfield F15SC48N Bedienungsanleitung

saro

saro FIONA Bedienungsanleitung

Hendi

Hendi 233962 Bedienungsanleitung

Hoshizaki

Hoshizaki HNC-120BE-L-BLH Bedienungsanleitung

Nordcap

Nordcap GENIUS 2 H145-L70 Bedienungsanleitung

Omcan

Omcan RS-CN-0140-D Bedienungsanleitung

Tecnodom

Tecnodom M Series Betriebsanleitung

freor

freor MERCURY Bedienungsanleitung

Costan

Costan WHALE 2000 G LG300 Bedienungsanleitung

Costan

Costan IMPALA Bedienungsanleitung

True Manufacturing Company

True Manufacturing Company TCGD-50 Bedienungsanleitung

Bartscher

Bartscher 100L Bedienungsanleitung

Steelcase

Steelcase Opus Bedienungsanleitung

Hatco

Hatco Glo-Ray GRHD-2P Anwendungshandbuch