Bticino 391696 Bedienungsanleitung
Part. LE03104AA
Indoor/Outdoor Speed Dome camera
391696391695
391715 391716/391717
Instructions manual
391695 / 391696 / 391715 / 391716 / 391717 2
IMPORTANT SAFETY GUIDE
Read, heed and follow all the Instructions
Read all the safety and operating instructions before using the product.
Keep this manual
Keep this manual for reference in future.
Attachments / Accessories
Use only the attachments or accessories specified by the manufacturer.
Installation
Do not install near any heat resources such as radiators, heat registers, stoves, or other appratus including amplifiers
that product heat. Improperly installed product may fall, cause serious injury to a child or adult and damage the
product.
Do not block any ventilation holes or openings. Install in accordance with the manufacturer’s instructions.
Use only with the cart, stand, tripod, bracket, mounting devices, or table specified by the manufacturer.
Installation should be done only by qualified personnel and conform to all the instructions by the manufacturer.
Refer all servicing to qualified service personnel.
Unless the product is specifically marked as IP67, more than IP67 or confirmed by the manufacturer, it is designed for
indoor use only and it must not be installed where exposed to rain and moisture.
Do not load on the product.
Use stainless steel hardware to fasten the mount.
To prevent damage from water leakage when installing a mount outdoors on a roof or wall, apply sealant properly
around holes.
These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not
perform any servicing other that contained in the operationg instructions unless you are qualified to do so.
Use only replacement parts specified by the manufacturer.
Power source
This product should be operated only from the type of the power source indicated on the marking label.
3
CAUTION
Operating
Before using, make sure that the power supply and others are properly installed.
While operating, if any abnormal condition or malfunction is observed, stop using the product immediately and then contact
your local dealer.
Handling
Do not disassemble or tamper with the parts inside the product.
Do not drop or subject the product to shock and vibration as this can damage the product.
Care must be taken when you clean the clear dome cover. Especially, scratch and dust will ruin the quality of the product.
Installation and Storage
Do not install the product in areas of extreme temperature, which exceed the allowable range.
Avoid installing in humid or dusty places.
Avoid installing in places where radiation is present.
Avoid installing in places where there are strong magnetic fields and electric signals.
Avoid installing in places where the product would be subject to strong vibrations.
391695 / 391696 / 391715 / 391716 / 391717 4
TABLE OF CONTENTS
1 Introduction
1.1 Model Code 5
1.2 Features 6
1.3 Package Components 8
1.4 Main Part Description 11
2 Installation
2.1 DIP Switch Setup 15
2.2 In-Ceiling Mount Installation (MPS) 21
2.3 Installation with Surface Mount Bracket (MPS) 22
2.4 Direct Installation on the Ceiling Mount Bracket(MPS) 23
2.5 Installation using Wall Mount Bracket(MPS) 26
2.6 Installation with Ceiling Mount Bracket(MAO/MAI) 27
2.7 Installation with Wall Mount Bracket(MAO/MAI) 28
2.8 Wiring and Cabling 29
3 Operation
3.1 Check Point before Operation 34
3.2 Check Points for Preset and Pattern Function before Operation 34
3.3 OSD Menu 35
3.4 Reserved Presets (Hot Keys) 35
3.5 Preset 36
3.6 Swing 36
3.7 Pattern 37
3.8 Group 38
3.9 Other Functions 39
3.10 OSD Display 40
4 OSD Menu
4.1 Quick Programming Guide 41
4.2 Main Menu 41
4.3 Display Setup 42
4.4 Privacy Zone Mask Setup 44
4.5 Camera Setup 46
4.6 Motion Setup 50
4.7 Preset Setup 53
4.8 Swing Setup 57
4.9 Pattern Setup 58
4.10 Group Setup 59
4.11 System Initialization 62
5 Specifications 63
5.1 Dimension 68
5
1. INTRODUCTION
1.1 MODEL CODE
Ref. 391695 391696 391715 391716 391717
Serie
Mini plastic
small
Mini Aluminium
with fan/heater
Mini Aluminium
with fan/heater
Aluminium with
fan/heater
Aluminium
with fan/heater
Outdoor serie NO YES
Video signal PAL
Wall mount
bracket NO YES
Rated power :
12 VDC
Sensor
3 In / 1 Out 4 In / 2 Out 3 In / 1 Out
391695 / 391696 / 391715 / 391716 / 391717 6
1.2. FEATURES
Powerful Zoom Camera & Setup Options
391695 391696 391715 391716 391716
Optical Zoom ×10 x27 x10 x27 x37
Digital Zoom ×10 x12 x10 x12 x12
Max. zoom magnification ×100 ×324 x100 x324 x444
High light compensation
NO
NO
YES YES YES
Privacy Masks
4
8
4
8 8
Day & Night
YES
WDR
NO YES
Focus Mode
Auto-Focus, Manual Focus, Semi-Auto Focus
OSD Menu YES
Image Sensor ¼” CCD Sony interline
Transfer CCD
super HAD color
CCD
Sony Interline
Transfer CCD super HAD color CCD
Powerful Pan/Tilt Functions
MAX. 360°/sec High Speed Pan/Tilt Motion
With the Vector Drive Technology, Pan/Tilt motions are accomplished along the shortest path. As a result, the time to
target view is remarkably short and the video on the monitor is very natural in monitoring.
With the Micro-Stepping Control Technology, the video looks very natural at high zoom magnification during a jog
operation on a controller since the camera can be controlled by 0.05°/sec. Hence it is very easy to make the camera
focus on desired target views at high zoom magnification. Additionally it is easy to make the camera focus on desired
positions with zoom-proportional pan/tilt movement.
Preset, Pattern, Swing, Group, Privacy Mask and More…
MAX. 127 Presets are programmable and each preset can have its own parameter values independently from the
other presets.
For an example, refer to the below table.
Preset No. White Balance Auto Exposure ••• Label Remarks
Preset 1 Case A Case 3 “ENTRANCE”
Preset 2 Case C Case 5 “WAREHOUSE”
Preset 3 Case V Case 2 “OFFICE”
•••
Preset 95 −−−−Reserved for OSD Menu
•••
Preset 128 Case K Case 9 “TERRACE”
7
MAX. 4 Patterns are programmable. This function is that the camera memorizes the path (mostly curve path) by the
joystick of the controller and revives the trajectory operated by the joystick as closely as possible.
MAX. 8 sets of Group are programmable. This function is that the camera memorizes the combination of Presets,
Pattern and/or Swings sequently and runs Presets, Pattern and/or Swings repetitively. A Group can be combined upto
20 functions with any of Preset/Pattern/Swing.
Privacy Masks are programmable, not to intrude on any other’s privacy :
391696/391716/391717 : 8 privacy zones
391695/391715 : 4 privacy zones
PTZ (Pan/Tilt/Zoom) Control
With the RS-485 communication connection, MAX. 255 units of cameras can be connected to a single controller.
Pelco-D or Pelco-P protocols can be selected as a control protocol in the current firmware version.
OSD (On Screen Display) Menu
OSD menu is provided to display the status of camera and to configure the functions interactively.
The information such as Camera ID, Pan/Tilt Angle, Direction, Alarm Input and Preset is displayed on screen.
Alarm In/Out Function
391696 : 4 alarm sensor inputs and 2 alarm output relays
391695/391715/391716/391717 : 3 alarm sensor inputs and 1 alarm sensor outputs
Alarm sensor input is decoupled with photo-couplers to avoid external electric noise and shock perfectly.
Both of N.O.(Normal Open) sensors and N.C.(Normal Close) sensors can be used and the signal range of the sensor
input is from DC 5.0V to 12.0V for various applications.
The camera can be set to move to a Preset position or to run functions such as Pattern, Swing and Group when there
are external sensor activations. Also “Post Alarm” function is possible, which is supposed to activate after user-defined
time period and sequentially in succession to the action by external sensor activations.
Reserved Presets (Hot Keys)
Most camera setup options can be set up easily and directly with the reserved presets (Hot Keys), without entering
into OSD menu. For more information, refer to “Reserved Presets(Hot Keys)” in this manual.
Perfect Outdoor Environment Compatibility and Easy Installation
391715/391716/391717 : The fans and heaters are built-in in the camera for cold and hot temperature environment.
Also idealistic mechanical design protects the camera from water and dust. (IP67 when installed properly with wall
mount bracket only)
It is easy to install the camera.
391695 / 391696 / 391715 / 391716 / 391717 8
1.3. Package Component (391695 Model)
Product & Accessories
Main Body & Surface Mount Bracket Default Accessories
[Main Cable, Calblock, Screws : Tapping M4×16, Tapping M4×25,
Machine M3×6, Machine M3×8]
I/O Cable
9
Package Component (391696 Model)
Product & Accessories
Main Body / Terminal Cover Dome Cover Screws
Optional brackets
In-Ceiling Mount Bracket
391885
Ceiling Mount Bracket
391883
Corner bracket
391849
Wall mount bracket
391847
391695 / 391696 / 391715 / 391716 / 391717 10
Package Component (391715/391716/391717 Models)
Product & Accessories
Main Body & Surface Mount Bracket Default Accessories
[Main Cable, Wrench]
Accessories for The Models with Alarm In/Out Function
[I/O Cable]
Wall Mount Bracket
[Screws : Machine M5×15, Hex Lag #14×50]
Optional Brackets
Corner bracket 391849 Ceiling Mount Bracket 391848
Pole bracket 391850
Dieses Handbuch passt für folgende Modelle
4
Inhaltsverzeichnis
Andere Bticino Sicherheitskamera Handbücher
Bticino
Bticino TVCC Bedienungsanleitung
Bticino
Bticino LE06585AA-01AT-13W27 Bedienungsanleitung
Bticino
Bticino 391769 Bedienungsanleitung
Bticino
Bticino 391891 Bedienungsanleitung
Bticino
Bticino 391773 Bedienungsanleitung
Bticino
Bticino LE03110AA Bedienungsanleitung
Bticino
Bticino TVCC T9654A Bedienungsanleitung
Bticino
Bticino 391716 Bedienungsanleitung
Bticino
Bticino 391615 Bedienungsanleitung
Bticino
Bticino 391782 Bedienungsanleitung
