BYMUSE FLO Bedienungsanleitung
USER GUIDE
BYMUSE FLO Wireless Neckband Earphones
1
BYMUSE FLO earphones Quick Start Guide
In the Package
USER GUIDE
BYMUSE FLO Wireless Neckband Earphones
3 - pairs of in-ear earphones
Large | Med | Small
3 - pairs iso-Fit Cushions
Large | Med | Small
1 - USB Micro
Charging Cable
(Med size installed on the headphones.)
(Med size installed on the headphones.)
2
Note: When you wear the BYMUSE FLO headset, note that the
side with the control button is to the right.
Getting to know your BYMUSE FLO
In-ear earphones
Iso-Fit Cushion
LED Indicator
Light
Left Right
Mic
Rubber Flap
Covers Micro USB
Charging Port
Backsideof
InlineControls
3
charge a low battery
Charging the Battery
Step 2: Insert the smaller end of
the Micro USB Cableinto the Micro
USB Charging Port as shown.
Step 3: Insert the other end of the
Micro USB cableinto either a USB
wall charger for a smartphoneor
a USB port on your laptop to
charge the battery.
The LED
Indicator Lightwill come on.
Step 1: Carefully lift the rubber
flap that covers the Micro USB
Charging Port and rotate the
flap to the rear
Slowly flashing Red when charging
Solid Red when fully charged
The LED Indicator Light
Your BYMUSE FLO rechargeable
battery will have a partial charge and
be ready to play. For maximum
playtime, fully charge the battery.
Music Play Time
Up to 8 hours on afull charge, with
volume at 60%. Louder volume will
reduce play time.
Low Charge Remaining Indicator
When the battery charge gets down
to 20% there will be a voice prompt
and the RED LED Light will flash in
rapid succession.
Automatic Turn Off
The BYMUSE FLO will turn off 15
minutes after being disconnected
from your mobiledevice.
Charge indicator on iPhone
Charging Time
It will take about2 to 3 hours to fully
charge a low battery
The vertical battery charge level
will appear in the top right
corner of youriPhone screen
4
LED Indicator Light
will turn on
Flashing Blue rapidly
indicates
BYMUSE FLO
isin pairing mode
Flashing Blue 3 timesevery 5 seconds
indicates
BYMUSE FLO
is connected to a
mobiledevice and is ready to play
Turning On and Off
Press and Hold Down button for2 Seconds
Turn ON
LED Indicator Light
flashes RED twice and turns off
LED Indicator Light
Press and Hold Down button for2 Seconds
Turn OFF
5
Pairing&Connecting to your mobile device
Turn ON your BYMUSE FLO
- Your mobile device needs to be within 30 unobstructed feet of the BYMUSE FLO
- Make sure your BYMUSE FLO battery has a sufficient charge
The LED Indicator Light will turn on
If the blue light is rapidly flashing
the BYMUSE FLO is ready to pair and connect.
If the blue light is flashing 3 timesevery 5 seconds
the BYMUSE FLO has automatically reconnected to the last
mobiledevice itwas connected to and is ready to play.
The BYMUSE FLO will try to reconnect each time it is turned on.
The BYMUSE FLO can be connected to one mobile device at
a time. To pair and connect to adifferent mobiledevice, you
need to disconnect the currently paired mobiledevice.
To disconnect it:
press and hold down the button and the button
together for 3 seconds.
The blue light will begin flashing and the BYMUSE FLO is ready
to pair and connect.
6
- Go to Settings> Bluetooth, check Bluetooth is on
- Select ‘ BYMUSE FLO ’ when it appears under OTHER DEVICES
- The BYMUSE RUN will connect in a few seconds
- The LED Light on your BYMUSE FLO will flash BLUE 3 times every
5 seconds and you are ready to play
- Go to Settings > Bluetooth, check Bluetooth is on
- Scan or Search and select ‘ BYMUSE FLO ’when it appears under
AVAILABLE DEVICES
- The BYMUSE FLO will connect in a few seconds
- The LED Light on your BYMUSE FLO will flash BLUE 3 times every
5 seconds and you are ready to play
Note: Your Smartphone or Tablet instructions may vary, please check
your mobile device’s manual for specific pairing instructions.
Pairing&Connecting to your
MobileDevice (continued)
To pair and connect from an iPhone, iPad, or iPod:
To pair and connect from a Smartphone or Tablet:
7
Play Controls
Press
Press
Press and Hold for 2 Seconds
Press and Hold for 2 Seconds
Volume Up
Press
Volume Down
Next Track
Play / Pause
Previous Track
8
To Hear the Best Sound and Best Bass
from your BYMUSE FLO Select the
Best Fitting In-Ear FLO
Side View
Top View
LARGEMED SMALL
A comfortable snug fitof the In-Ear FLO provides the highest quality
listening experience with the BYMUSE FLO .We suggest starting with the
medium sizeIn-Ear FLO to learn if they are snug and comfortable. If
they donot feel snug try the large In-Ear FLO , and if the medium are too
tight try the small In-Ear FLO .The largest sizeIn-Ear FLO that are
comfortablewill provide the best overall sound experience.
9
Comfort Fit with Iso-Fit Cushions
Sideview
Sideview
Lineup holes
Iso-Fit Cushion
In-Ear FLO
Step 1: With the In-Ear FLO
removed, slide the Iso-Fit
Cushion over the shaft of
the earbud with the smaller
tube opening facing
outwards from the earbud
and the small holes lined up
Step 2: Slide the In-Ear FLO
onto the earbud shaft
Step 3: Your BYMUSE FLO
are now ready to insert
into your ear
The Iso-Fit Cushions help provide a comfortable snug fit,
perfect for listening during sports and physical activity.
Inhaltsverzeichnis
Andere BYMUSE Kopfhörer Handbücher
