Cable Electronics CE Labs 1001ST Bedienungsanleitung
Theater 1001ST
Audio/Video Stereo Modulator
1001ST
Information Brochure
True MTS compatible stereo output
Distributes a Video/Audio Source to multiple
locations over a single coax cable.
Cable Electronics, Inc.
3209 Wood Drive
Garland, Texas 75041
(469)429-9200 Fax (469)429-9205
DVD Player / Video Game / Camera / Etc.
1001ST
TELEVISION
AUDIO Right / Left
VIDEO
TV
F-Connector
Coax Cable
To Ant.
Or CATV
Typical application diagram.
1001ST
This unit allows any stereo Audio/Video source, to distribute Audio and
Video to different locations over standard coax cable. The RF output can
be changed to any channel between 14 to 69 or cable channels from 65
to 125 ( 95-99 not included).
SPECIFICATIONS
VIDEO
Nominal Input level: 1 Volt peak to peak
Input Impedance: 75 ohms
Isolation port to port: 32 dB
Isolation out to input: 60 dB
Video bandwidth: > 4 Mhz
AUDIO
Nominal Input level: 1 Volt peak to peak
Input impedance: 22k ohm
THD: < 0.5%
Frequency Response: 20Hz to 14kHz
Channel Separation: >30dB
Signal to Noise: >60dB @ 2 Volts
POWER
Requirement: External 9 Volt DC @ 250mA (minimum) with a 2.5mm
Coaxial Center positive connector. Power Supply is included.
WARRANTY
Cable Electronics, Inc. warrants this product to be free from defects in material and
workmanship, under normal use and service, for a period of one year from the purchase by
the original purchaser. If this product is defective or malfunctions, Cable Electronics will
replace or repair this unit (at their option) within a reasonable time. No expressed or implied
warranty is made for any defects caused by immersion or exposure to liquids, abuse,
neglect, improper operation of unit, excess wear and tear and defects resulting from
unauthorized disassembly and or modification.
NOTE: *Please allow one channel spacing above and below the modulator tuned channel
to prevent interference to existing channels.
*Press and hold the mode button to change the frequency output mode. Hold for
at least 6 seconds or until display changes.
1001ST
PERFORMANCE SPECIFICATIONS
And Features
Interface
Tuning Push but ton digital control
Display 2 ½ D igit , Se ven S egm ent Digit al Readout
Mode Selects Off-Air or Cable output frequencies
Video
Input Level: Standard 1 Vp-p
Input Impedance: 75 ohms
Connector: RCA
Audio
Full MTS Stereo Compatibility.
Input level: Standard 1 Vp-p ( 2 Vp-p max )
Input Impedance: 22K ohm minimum
Frequency Response: 20 Hz to 14 kHz
Channel Separation: Greater than 30 dB typical
Signalto Noise: 60 dB
Distortion: Less than 0.5 %
Connector: Two RCA, Right and Left
Misc.
Channel Range: UHF 14 to 69, Cable 65 to 94, 100 to 125
RF Output Level: +20 dBmV, F connector
Power Supply: 9 to 12 Vdc, 250 mA minimum
Size: 3.9 x 3.9 x 1.5 inches
Internal Band Pass Filtering to virtually eliminate spurious signals
Stereo encoder is Macrovision compatible for use w ith DVD and VCR sources
Inhaltsverzeichnis
Andere Cable Electronics Modulator Handbücher
