Cabletron Systems FN100 Bedienungsanleitung

9031867-01 Page 1

Fast Network 100 (FN100) Quick Setup

Unpack the FN100 from the shipping carton. Be sure to save all shipping material.

Make sure the following items were included with the FN100:

Fast Network 100 User Guide

Fast Network 100 LCM Commands Reference Card

Fast Network 100 MIB Reference Guide

Console Cable Kit

AC power cord

Four stick-on feet (for desktop installation)

Two rack-mount brackets with fasteners

Examine the FN100 for any damage. If you suspect a problem, call Cabletron Systems

Technical Support.

If you are rack mounting the FN100, see

“Rack-mounting a FN100” in Chapter 2 of the

Fast

Network 100 User Guide

for rack mounting instructions.

If you are installing the FN100 on a

desktop, do not place a monitor on top of the unit.

To power up the FN100, plug the AC power cord into the AC power connector on the rear of

the FN100 chassis and plug the other end of the power cord into a three-prong grounded

outlet. The input voltage must be between 90 - 250

VAC

If you are going to manage the FN100 using the Local Console Monitor (LCM), connect

your ASCII terminal, or terminal emulator, to the out-of-band management RS232C port on

the front panel of the FN100 using a standard 9-pin serial cable (Only three of the nine

wires are necessary: Receive Data, Transmit Data, and Ground).

Be sure your terminal is

set to the following: 9600 baud, 8 data bits, 1 stop bit, and no parity.

Press the Enter key several times. If the FN100 is operational, the LCM prompt,

FN100>

, is

displayed on your terminal’s screen.

Step

9031867-01 Page 2

To manage the FN100 from one of its RJ45 ports, you will need to assign an IP (Internet

Protocol) address to the port that will be performing management functions. At the

FN100>

prompt, type:

ipaddr

[port number]

[IP address]

. For example:

ipaddr 6 192.138.217.40

For more information

Refer to the following chapters in the

Fast Network 100 User Guide

Topic Chapter

Introduction 1

Installation 2

Conﬁguration 3

Local Console Manager (LCM) 4

Power-up Diagnostics 5

Troubleshooting 5

Speciﬁcations Appendix A

Glossary Appendix B

Step

LCM command port # IP address

Andere Handbücher für FN100

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Cabletron Systems Schalten Handbücher

Cabletron Systems

Cabletron Systems 2H28-08R Bedienungsanleitung

Cabletron Systems

Cabletron Systems MMAC-Plus 9T125-24 Handbuch

Cabletron Systems

Cabletron Systems MMAC-Plus 9F206-02 Technisches Dokument

Cabletron Systems

Cabletron Systems SEH-22 Bedienungsanleitung

Cabletron Systems

Cabletron Systems SmartSwitch 6500 Montageanleitung

Cabletron Systems

Cabletron Systems 42T Bedienungsanleitung

Cabletron Systems

Cabletron Systems SmartSTACK ELS100-8TXUF2 Bedienungsanleitung

Cabletron Systems

Cabletron Systems SmartSwitch 2H22 Betriebsanleitung

Cabletron Systems

Cabletron Systems MMAC-Plus 9T122-24 Bedienungsanleitung

Cabletron Systems

Cabletron Systems 7C03 MMAC SmartSWITCH Bedienungsanleitung

Cabletron Systems

Cabletron Systems ATX Bedienungsanleitung

Cabletron Systems

Cabletron Systems MMAC-Plus 9A000 Bedienungsanleitung

Cabletron Systems

Cabletron Systems MiniMMAC Bedienungsanleitung

Cabletron Systems

Cabletron Systems Spectrum 2E42-27 Programmierhandbuch

Cabletron Systems

Cabletron Systems MICROMMAC-22T Bedienungsanleitung

Cabletron Systems

Cabletron Systems 9F426-03 Bedienungsanleitung

Cabletron Systems

Cabletron Systems 9A426-02 Bedienungsanleitung

Cabletron Systems

Cabletron Systems SmartSwitch 04-0053-01 Bedienungsanleitung

Cabletron Systems

Cabletron Systems ELS10-26TX Bedienungsanleitung

Cabletron Systems

Cabletron Systems 9F120-08 Technisches Dokument

Cabletron Systems

Cabletron Systems CSX200 CyberSWITCH Bedienungsanleitung

Cabletron Systems

Cabletron Systems 3E02-04 Bedienungsanleitung

Cabletron Systems

Cabletron Systems SmartSTACK ELS100-S24TX2M Bedienungsanleitung

Cabletron Systems

Cabletron Systems MMAC-Plus 9H423-28 Handbuch

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung