POWER SOURCE:
Unwind the A/C power adapter (located in the adapter compartment on back
of the unit). Connect the small end of the adapter to the back of the turntable,
then the other end to power outlet.
UNPACKING THE TURNTABLE:
1. Carefully remove unit from it’s package and take it out of the plastic bag.
2. Open lid, remove black tie-wrap by untwisting and gently sliding out
from under tone arm.
3. Remove cardboard shipper.
4. Slightly lift up the needle protector below the needle.
5. Using your ngers, release the two large chrome security screws located on
both side turntable platform (2). Do not force it. This allows turntable to oat
on its shock absorbers.
6. Release tone arm hold down clip by gently pushing to the right. This will
unlock tone its arm rest.
Note: Remember to lock the hold down clip(5) and 2 chrome security
screws (8) before the unit to another location.
TURNTABLE OPERATION
1. Turn the unit on by turning the ON/OFF VOLUME(12) knob clockwise.
2. Set SPEED CONTROL switch(7) to desired speed (33, 45 or 78 rpm).
It located near cue lever.
3. Place a record on the turntable.
4. Use CUE LEVER (6) to raise the tone arm. Move the tone arm by hand out
over the and slowly lower it using the cue lever. Readjust the volume to
desires level by turning ON/OFF VOLUME (12) knob.
5. At the end of the record, the tone arm will automatically return to its arm rest.
6. Use the TONE control (11) to adjust the sound quality.
ACCESSORIES
ADAPTER FOR 45 RPM
To play the 45 rpm record, place the ADAPTOR (1) on the SPINDLE (3).
NEEDLE
Part# 007-1005-00
1005AV Record player
LOCATION OF PARTS
1. ADAPTOR FOR 45 rpm RECORDS
2. PLATTER
3. CENTER SPINDLE
4. TONE ARM
5. TONE ARM REST
6. CUE LEVER
7. SPEED SELECT SWITCH
8. SECURITY SCREW
9. ADAPTER JACK
10. ADAPTER COMPARTMENT
11. TONE CONTROL
12. ON/OFF VOLUME KNOB
TROUBLESHOOTING GUIDE
The unit will not operate, try the following tips:
1. Check the unit is properly connected
to an A/C outlet.
2. Make certain that the small end of the
adapter is plugged into the power
