CallPass iGotcha Quick Device Bedienungsanleitung
INSTALL GUIDE
QUICK DEVICE
OBDII PASS-THRU INSTALLATION
IMPORTANT NOTES
Before starting the Quick Device install with
OBDII installation process please download the
‘iGotcha GPS APP’ from the Apple APP Store (for
iPhones and iPads) or Google Play Store (for
Android phones or tablets).
Login into your account and follow the ‘APP instructions’
(included in your box) to scan the GPS Device Barcode
and then scan the car VIN to register the device to the
vehicle.
QUICK DEVICE INSTALL
WITH OPTIONAL OBDII PASS-THRU CABLE
TOLL FREE SUPPORT
PHONE // +1 (877) 324-0999
EMAIL // [email protected]
Copyright © 2020 CallPass, LLC | 08-2020
Quick Device Install Guide - OBDII
STEP 1
Identify the the connections on the supplied OBDII cable
as shown in Step 1. Note that the power cable is already
connected.
STEP 2
Remove the dash panel and locate the vehicle OBDII
connector. Snap the vehicle’s OBDII connector from its
bracket. If the OBDII connector is molded to a bracket,
detach the entire assembly.
STEP 3
Now install the supplied OBDII Pass-Thru Cable by
connecting the male end of the supplied OBDII
Pass-Thru Cable to the female end of the vehicle’s
factory OBDII cable.
STEP 4
Secure the OBDII plug back into the factory bracket or if
necessary, use the bracket supplied with the kit.
Simply plug the 14 pin power cable into the device. Now
that power is connected, the GREEN LED is solid and
represents GPS. The BLUE LED begins blinking while
searching for the Cellular signal. When acquired, the
BLUE LED will pause then continue blinking in 3 second
intervals while the GREEN LED blinks steadily.
At this point, return back to your phone or tablet and push
the locate button. If the device responds with the correct
location, mount the device label side up with a zip tie
under the dash and replace any removed dash panels.
Your installation is complete.
This is a vehicle
OBDII connector.
This is the male end of
the supplied OBDII cable .
This is the female end
of the vehicle’s factory
OBDII plug.
This is the female end of
the supplied OBDII cable.
2
This is the 14 Pin Power
cable plugged into the device.
The device is now powered.
3
4
GREEN LED = Power/GPS
BLUE LED = Cellular
14 Pin Power
Cable Male OBDII
Connection
Female OBDII
Connection
1
OBDII CABLE
WIRE CONNECTION IDENTIFIER
Andere CallPass GPS Handbücher
