NOTE: This equipment has been tested and found to comply with the
limits
fm
aClass Bdigital device. pUl'suant to
Pali
15
of the
FCC
Rules. These
limits
al'e designed to provide reasonable protection against
harmful
Interference
in
aresidential installation. This
equipment
genemtes. uses. and can mdlate
mdio
fl'equency enel'gy and. if not
installed and used
in
accordance
with
the instructions. may cause hal'mful interference to radio
communications.
Howevel'. there
is
no gual'antee that interfel'ence will not
OCCUI'
n a pal'ticula( installation. If this eqUipment does
cause hal'mful interTer-ence
to
radiO
01'
television reception. which can
be
determmed
by
!umlllg
t'le
equipment off
a'ld
on. the user is encourageo to t(y to
COt'rect
tne i1terferellce by one mmore of the followln(J IlleaSUles:
-Remient mrelocate tile I'eceiving antenna.
"I
,1m,
..
-Increase the sepal'ation between the equipment ana I'eceivel'.
-Connect the equipment into an outlet on acil'cuit diffel'ent from that to
which
the receiver is connected.
-Consult the dealer or an expenenced
radiolN
technician for help.
D8,10,l,Un
This
device
compiles with Pal't
15
of the
FCC
Rules. Opel'atlon
IS
subject
to
the following two
conditions:(nthis
device may
110t
cause harmful intel'ference. and(2)this device must accept any interfel'ence received. including
intet'fel'ence that may cause undeSired opel'alton.
Information to
User
Alteration or modifications can'ied out
without
appropriate authorIZation may invalidate the
users
right to operate
the equipment. D8'10'2_En
CAUTION: This product satisfies
FCC
regulations when shielded cables (with Ferrite'cores attached) and
connectors are used to connect the unit to other equipment.
To
prevent electromagnetic interference with electric
appliances such as radios and televisions. use shielded cables (with Ferrite,cores attached) and connectors for
connections. D8'10'3b_En
If the AC plug
of
this
unit
does not
match
the AC
outlet you
want
to
use. the plug
must
be removed
and appropriate one fitted. Replacement and
mounting
of an
AC
plug on
the
power supply cord of
thiS
unit
should be performed only by qualified
service personnel.
If
connected
to
an AC outlet.
the
cut'off
plug can cause severe electrical shock. Make
sure it
is
properly disposed of aftel' removal.
The
equipment
should be
disconnected
by
removing
the mains plug from the wall socket when left
unused for along penod of
time
(for example, when
on vacation). D3'4,2,2'la_A_En
CAUTION
The POWER/MODE but on on
this
unit
will not
completely
shut
off all power
from
the AC outlet.
Since
the
power
cmd
serves
as
the
main
disconnect
device for the unit. you wil need 0
unplug
it
hom
the AC au let
to
s t
down
all power. Therefore,
make s
re
the
unit
as been Installed so hat
the
power cord can be easily
unplugged
from the AC
outlet in case of an aCCident
To
avoid fire hazard.
the power cord should also be
unpiugged
from the
AC outlet when left unused for along penod of
time
(for example,
when
on vacation), D3-4,2,2'2a_A.En
POWER-CORD CAUTION
Handle the power cord by the plug, Do not
pullout
the
plug by
tugglllg
the
cOl'd
and never
touch
the power
cord when your hands are wet as
this
could
cause a
short
circuit
or electric shock Do not place the unit. a
piece of fumiture,
etc"
on the power
cmd.
or pinch the
cord,
Never
make aknot
In
the
cOl'd
or tie it with othel'
cords, The powel' cords should
be
routed such
that
they
al'e not likely to
be
stepped on, Adamaged power cord
can cause afll'e or give you an
electncal
shock, Check
the power cord once in awhile. When you
filld
it
damaged, ask youl' nearest CANON authmized service
centel'
or
your dealel'
for
areplacement. S002_En
When using this product
follow
the instructions
written
on
the underside
of
the unit, which
concern rated voltage, etc. D3-4'2'2'4_En
This
product
includes
FontAvenue®
fonts
licenced
by
NEe
Corporation.
FontAvenue is aregistered
trademark
of
NEC
Corporation.
This
product
complies
with
the
EMC
Directive
2004/108/EC.
DH'2'l'9aA_En
3
En
