ENG - 2
Getting Started
Connecting to Device
1. Begin by searching for an appropriate location to setup device. Please
keep in mind to keep device in the center of working area as the signal
strength and data transfer rate diminishes with distance.
2. It is also recommended to place device at a higher position to ensure
minimum obstacle interference.
3. Make sure that all network devices are powered off, including the
device itself, PCs, switches, cable or DSL modem, and others.
4. Connect the modem to WAN
port of the device by one CAT
5 Ethernet cable.
5. Connect PC(s) or other
network enabled device(s)
with LAN ports (1/2/3/4) of
the device by CAT 5 Ethernet
cables.
6. Connect power adapter to
wall socket and device to
power on the cable or DSL
modem.
7. POWER and WAN indicator
should light up steadily if
connected properly.
Internet Configuration Wizard
The default network address of the device is set as 192.168.2.1. Please
configure IP address of host PC at 192.168.2.XXX where XXX is a number
between 002 and 254. The subnet mask should be 255.255.255.0. Please
follow below steps to enter web browser management mode.
1. Start Internet QuickSetup Configuration
