CareCo BD06018 Bedienungsanleitung

BD06018 – Sure Support Bed Rail

Assembly and Installation:

Product Parts:

1. Locate all items from the box and lay them out on the floor.

2. Locate the two main tube structures denoted by smaller bar

sections protruding out. The left side will have the protrusions at 3:00 and 12:00 if looking top

down. The right side will have the protrusions at 9:00 and 12:00 if looking top down.

3. Locate the transverse bar and their respective push pins. Insert to left side by lining up the push pins

to the small receiving tube. Push the pin, insert, and ensure an audible click is heard indicating the

push pin is in the locked position. Repeat on the right side.

4. Locate the padded hand-grip. This will be installed on the top portion of the main tube structure.

The top portion can be found by locating the two rivets found in the general mid-section of the

tube. The rivets should be positioned above the transverse bar. To install the padded hand-grip,

locate the push pins. Depress them, and slide the tube into the main tube structure. Ensure an

audible click is heard indicating the push pin is in the locked position. Repeat on the other side.

5. Locate each height-adjustable leg and insert into the main tube section. Locate the push pins.

Depress them, and slide the tube into the main tube structure. Ensure an audible click is heard

indicating the push pin is in the locked position. Repeat on the other side. To adjust the height of

the legs, depress the push pin, slightly twist the legs and slide the leg tube up or down until

desired height is achieved. Twist back and ensure an audible click is heard ensuring it is in the

locked position.

6. Locate the shaped hand-grip locking pin. Insert on the inside of the main tube structure.

They should be inserted in the receiving holes above the rivet.

7. Locate the horseshoe shaped bar. Insert into the receiving tube at the rear of the main tube

structure. Locate the push pins. Depress them, and slide the tube into the main tube structure.

Ensure an audible click is heard indicating the push pin is in the locked position. Repeat on the

other side.

8. Bed Installation: Fully insert the bed rail between the mattress and box spring of the bed.

The padded hand-grip should be 18” away from the head of the bed and 4” to 6” above the top

of the mattress.

1. Padded hand-grip

2. Horseshoe shaped bar

3. Padded hand-grip locking pin

4. Height adjust push pin

5. Main tube structure

6. Transverse bar

7. Height adjustable legs

Note: Always seek the advice of your doctor or primary care

giver in the safe use of the bed rail as it pertains to your

mobility needs.

Please find assembly diagram overleaf.

Warranty:

Your CareCo branded product is under warranty to be free from defects in material and workmanship

for one year from date of purchase. This warranty expresses our confidence in the workmanship and

materials used for our products.

In the event of a defect covered by this warranty, CareCo will, at our discretion, replace the product

or supply parts to remedy. This warranty does not cover device failure due to owner misuse or

negligence, or due to normal wear and tear. The warranty does not extend to non-durable parts which

are subject to normal wear and tear or/and require periodic replacement.

If you have any queries please contact CareCo.

CareCo, Hubert Road, Brentwood,

Essex CM14 4JE

www.careco.co.uk

Check all parts

Insert foam handle

Connect cross bar

to posts (x2)

Use E-clips (x2) to

secure handle and

adjust height

Add under-bed

support frame

Add mesh pouch

Insert legs (x2) so they

rest firmly on the ground

Secure safety strap by

looping around bed rail

and back through slot on

under bed frame

Assembly Diagram:

Andere CareCo Mobilitätshilfe Handbücher

CareCo

CareCo BA07036 Bedienungsanleitung

CareCo

CareCo ProLite Carbon X-TRAIL Bedienungsanleitung

CareCo

CareCo XPEDITION Transport Chair Benutzerhandbuch

CareCo

CareCo WA01057 Benutzerhandbuch

CareCo

CareCo WA01047 Benutzerhandbuch

CareCo

CareCo Pano 2.0 Bedienungsanleitung

CareCo

CareCo Evo Benutzerhandbuch

CareCo

CareCo Access-Tec MS09130 Bedienungsanleitung

CareCo

CareCo Sanandres Benutzerhandbuch

CareCo

CareCo DL06107 Bedienungsanleitung

CareCo

CareCo Breeze 8 II Bedienungsanleitung

CareCo

CareCo ProLite NERO SPORT Bedienungsanleitung

CareCo

CareCo MS05016 Bedienungsanleitung

CareCo

CareCo ZEST Bedienungsanleitung

CareCo

CareCo Secco 4 Benutzerhandbuch

CareCo

CareCo ALPINE Bedienungsanleitung

CareCo

CareCo Deluxe Duo Programmierhandbuch

CareCo

CareCo Comet Bedienungsanleitung

CareCo

CareCo iCONNECT STEALTH Bedienungsanleitung

CareCo

CareCo PRIMA WA04032 Bedienungsanleitung

CareCo

CareCo GoodKnight BD06023 Bedienungsanleitung

CareCo

CareCo Orbit WA01060 Benutzerhandbuch

CareCo

CareCo Aluminium Glider 2.0 Bedienungsanleitung

CareCo

CareCo Rollafold Benutzerhandbuch

Beliebte Mobilitätshilfe Handbücher anderer Marken

Alber

Alber Scalamobil iQ Bedienungsanleitung

Ferno

Ferno CCT-PX Bedienungsanleitung

HEPRO

HEPRO Gripo Bedienungsanleitung

Otto Bock

Otto Bock Pheon 3R62 Bedienungsanleitung

NRS Healthcare

NRS Healthcare M11090 Bedienungsanleitung

Medline

Medline MDS86835DSHEC Installationsanleitung

Guldmann

Guldmann Twin Turner II Bedienungsanleitung

Drive

Drive ROOMBA Bedienungsanleitung

Gate

Gate Balder Bedienungsanleitung

Decon wheel

Decon wheel TNS Notos Bedienungsanleitung

ExoAtlet

ExoAtlet ExoAtlet-II Bedienungsanleitung

Invacare

Invacare Storm Series Bedienungsanleitung

Rhythm Healthcare

Rhythm Healthcare B3800F Bedienungsanleitung

AMF-BRUNS

AMF-BRUNS PROTEKTOR Bedienungsanleitung

Drive DeVilbiss Healthcare

Drive DeVilbiss Healthcare OTTER Bedienungsanleitung

Rhythm Healthcare

Rhythm Healthcare C500U Bedienungsanleitung

Lumex

Lumex RJ4200A Bedienungsanleitung

Rebotec

Rebotec Jumbo Bedienungsanleitung