CDA EZA60BL Kurzanleitung
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : customer.care@cda.eu W : www.cda.eu
www.cda.eu
EZA60BL &
EZA90BL
Extractors
Installation, Use and Maintenance
2
Contents:
3 Important
4 Important information
6 Using your extractor
7 Care and maintenance
8 Removing the grease filter
8 Changing/fitting the charcoal filter(s)
9 Changing the light
9 Troubleshooting
10 - 16 Installation
10 Installation preparation - height
12 Ducting and ventilation
16 Mains electricity connection
17 Electrical information
19 Energy Eciency Information
3
Important
The CDA Group Ltd cannot be held responsible for injuries or losses
caused by incorrect use or installation of this product. Please note that
CDA reserve the right to invalidate the guarantee supplied with this
product following incorrect installation or misuse of the appliance or
use in a commercial environment.
This appliance is not designed to be used by people (including
children) with reduced physical, sensorial or mental capacity, or
who lack experience or knowledge about it, unless they have had
supervision or instructions on how to use the appliance by someone
who is responsible for their safety.
Under no circumstances should any external covers be removed for
servicing or maintenance except by suitably qualified personnel.
Appliance information:
Please enter the details on the appliance rating plate below for
reference, to assist CDA Customer Care in the event of a fault with
your appliance and to register your appliance for guarantee purposes.
Appliance Model
Serial Number
EU Declarations of Conformity:
This appliance has been designed, constructed and marketed in
compliance with safety requirements of EU Directive 2014/35/EU (LVD)
4
and requirements of EU Directive 2014/30/EU (EMC).
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2012/19/EU.
At the end of its working life, the product must be taken to a special
local authority waste collection centre or to a dealer providing
appliance recycling services.
Disposing of a household appliance separately avoids possible
negative consequences for the environment and health. It also
enables the constituent materials to be recovered, saving both energy
and resources. As a reminder of the need to dispose of household
appliances separately, the product is marked with a crossed-out
wheeled dustbin.
Please note:
•Under no circumstances should the extractor be connected to any
gas ventilation system, flue system or hot air ducting system.
• Do not vent the extractor into an attic or loft space.
•Only house the extractor in rooms with adequate ventilation.
Remember that the extractor is powerful and whatever air is
extracted needs to be replaced.
•Do not tile the extractor in. It should be removable for service or
maintenance.
•Do not use silicone sealant to secure the hood to the wall.
•You must be able to isolate the extractor from the mains electrical
supply after installation.
5
•This extractor has been designed to be used in a room with a
volume of less than 36m.
•Steam cleaners must not be used when cleaning this appliance.
•The performance of your extractor will vary depending on a number
of factors. These include: type of extraction, length of ducting, room
volume, ventilation available and cleanliness of the filters.
Important information relevant to the reduction of the overall
impact of the cooking process on the environment:
•When cooking with pots and pans, always cover them with lids
where possible.
•Remember to switch the extractor o at the end of cooking (or use
the countdown timer available on some models)
•Remember to turn o the extractor lighting at the end of cooking
and avoid using the lights for ambient lighting.
•Use appropriate cookware for the cooking zone to be used on your
hob and, with gas hobs, adjust the flame to the size of the pot.
•Utilise the highest speed on your extractor when cooking fume
levels are high.
•Clean the grease filter(s) regularly and replace any charcoal filters
regularly if extracting via recirculation.
6
Using your Extractor
For best performance, you should switch on the extractor 15 minutes
before starting to cook and leave it to run for approximately 15
minutes after the end of cooking.
Control Panel
A - Power o button B - Speed level buttons C - Light button
To switch the extractor light on or o
• Press the light button (C).
To switch on the extractor or to change the speed at any time
when the extractor is running
• Press the relevant speed button (B) for the first, second, third or
fourth speed level as required.
• Press and hold any speed setting for approximately 2 seconds
to activate a 10 minute timer for that speed. The selected speed
should flash. Touch the same sensor to cancel the timer.
To switch the extractor o
• Press the power o button (A).
7
A B C
7
Care and Maintenance
IMPORTANT: DO NOT PERFORM
MAINTENANCE OR CLEANING OF
THE EXTRACTOR WITHOUT FIRST
SWITCHING OFF THE ELECTRICITY
SUPPLY.
Cleaning
You should use a non-abrasive cleaner.
Any abrasive cleaner (including Cif) will
scratch the surface and could erase the
control panel markings.
You can clean you extractor eectively
by simply using a dilute solution of
water and mild detergent and drying to
a shine with a clean cloth.
IMPORTANT:
Always protect surfaces
immediately beneath
the extractor (such as
a hob) with a clean, dry
towel or similar item
before carrying out
any cleaning or
maintenance in case of
falling parts/items. Fig. 3
Fig. 2
1
2
3
8
Removing and cleaning the grease filter - Fig. 2
The grease filter should be kept clean to minimise the risk of fire.
At least once a month you should remove and clean the grease
filters with hot soapy water. You can also wash the grease filter in a
dishwasher, ensuring that you place it in an upright position to prevent
damage from other items in the dishwasher. After rinsing and drying,
replace the filters.
To remove the grease filter, lift open the extractor cover and then
release the catch on the handle on the grease filter. It will release at
the handle side. Then lower the grease filter to remove it completely
(fig. 2). To replace the grease filter, repeat the steps in reverse.
Please note:
Cleaning the grease filter in the dishwasher may lead to
discolouration. This is normal and does not constitute a fault with the
appliance.
Changing the charcoal filter (re-circulating only) - Fig. 3
To ensure best performance of your extractor, you should replace the
charcoal filter every four to six months, depending on use.
To attach a new charcoal filter, first remove the grease filter as
described above. Then oer up the charcoal filter to the inside of the
grease filter as shown in fig. 3. Oer the catches on the bottom of the
charcol filter to the grease filter frame (1) and then clip the top of the
charcoal filter into the grease filter frame around the handle area (2).
Then, replace the grease filters and cover panels.
9
Changing the light
This appliance is fitted with energy saving LED lighting that has a
considerably longer life expectancy than traditional filament bulbs.
These are not user-replaceable in the unlikely event of a failure.
Do not touch bulbs or adjacent areas during or straight after
prolonged use of the lights.
The light is designed for use during cooking and not for general room
illumination. Extended use of the light can reduce the life span of the
bulb.
Troubleshooting
If your extractor is not working:
1. Check that the mains supply has not been switched o.
2. Check that the fuse in the spur has not blown.
If your lights are not working:
1. Check that the mains supply has not been switched o.
2. Check whether the extractor still extracts on any speed. If not,
check that the fuse in the spur has not blown. If the lights still
do not work, contact CDA Customer Care:
Contact CDA Customer Care
A: Customer Care Department, The CDA Group Ltd, Harby Road,
Langar, Nottinghamshire, NG13 9HY
T: 01949 862 012 F: 01949 862 003
10
Installation
When installing this product we recommend you seek the help of
another individual. This product may have some sharp edges. Please
take care and wear adequate PPE when handling.
Installation preparation - height
When the extractor is to be installed above an electric hob, the
minimum distance between the hob and the bottom edge of the
extractor must exceed 450mm (500mm is recommended).
When the extractor is to be installed above a gas hob, the minimum
distance between the bottom edge of the extractor and hob must
exceed 650mm.
If the instructions provided with your gas hob state that the
required distance between the hob and extractor must be greater
than 650mm, then that is the distance that should be observed;
this is a legal requirement and may lead to your hob being
disconnected from the gas supply and the installation being
reported under RIDDOR (the height should be measured from the
top of the burners).
IN THE ABSENCE OF ANY INSTRUCTIONS SUPPLIED WITH THE
GAS HOB, THE MINIMUM DISTANCE BETWEEN THE HOB AND
EXTRACTOR MUST BE AT LEAST 760mm. The width of any hob
must not be greater than the width of the extractor installed above
it.
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere CDA Dunstabzugshaube Handbücher
CDA
CDA ECN62 Referenzhandbuch
CDA
CDA CST6 Bedienungsanleitung
CDA
CDA EVH9 Bedienungsanleitung
CDA
CDA 3S10BL Kurzanleitung
CDA
CDA EGA60BL Montage- und Bedienungsanleitung
CDA
CDA 3Q9 Bedienungsanleitung
CDA
CDA 3L9 Referenzhandbuch
CDA
CDA EVS90BL Kurzanleitung
CDA
CDA ECN6 Bedienungsanleitung
CDA
CDA ECR90 Kurzanleitung
CDA
CDA EVPC9 Referenzhandbuch
CDA
CDA 3D9BL Referenzhandbuch
CDA
CDA CST61SS Kurzanleitung
CDA
CDA ECR90CM Montage- und Bedienungsanleitung
CDA
CDA EVP6 Bedienungsanleitung
CDA
CDA EVPC91 Kurzanleitung
CDA
CDA CIN6 Referenzhandbuch
CDA
CDA ECPK9 Referenzhandbuch
CDA
CDA EZTK90BL Kurzanleitung
CDA
CDA CTE6 Bedienungsanleitung
