Celestron FirstScope 114 Bedienungsanleitung

Use the three tightening screws located at the

bottom of each leg to secure the extended legs

in place.

To set up the tripod, spread the legs outward

until they are fully extended. Extend the center

portion of each of the three tripod legs down 6-

8".

Item #31132

Quick Set-up Guide

123

All three legs should be the same length to

provide a level platform for the telescope.

Locate the equatorial mount and place the

base of the mount through the hole in the

center of the tripod mounting platform.

Properly assembled, the accessory tray should

appear as pictured above.

From underneath the tripod mounting platform,

thread the mounting bolt with washer into the

threaded hole on the bottom of the equatorial

mount.

Thread the latitude adjustment screw into the

equatorial mount until it is touching the inside

of the mount.

FirstScope 114

Your FirstScope 114 includes: optical tube w/ tube

ring attached; tripod with center support bracket;

equatorial mount; two eyepieces; StarPointer

finderscope; 5 lb. counterweight; counterweight bar;

two slow motion cables; eyepiece accessory tray;

documentation including an owner’s manual and

The Sky™ CD Software.

Item# 31044

Place the accessory tray on top of tripod's

center leg brace. Thread the tray into the

threaded hole in the center of the leg brace.

Questions or Problems with Set-up?

CONTACT:

Celestron Technical Support: 310.803.5955

Quick Set-up Guide [cont]

Locate the counterweight bar and

counterweight. Slide the counterweight half

way down the counterweight bar and tighten

the locking screw to secure in place.

Thread the threaded end of the counterweight

bar into the Dec axis of the equatorial mount.

The longer cable should attach to the Right

Ascension axis and the shorter cable attaches

to the Declination axis.

Properly assembled, the slow motion controls

should appear as pictures above. You should be

able to see the mount move when you turn the

cable knobs.

Before mounting the tube, unthread the quick

release locking bolt so that it does not obstruct

the inner portion of the equatorial mounting

platform.

Place the telescope tube on top of the

equatorial mount so that the tube ring

mounting plate slides inside the mounting

platform.

17 18

Remove the plastic cap covering the end of

the focuser.

19 20

Insert the chrome barrel of the 20mm eyepiece

into the focuser and tighten the set screw.

Locate the StarPointer finderscope. Remove

the knurled nuts on the threaded posts at the

focuser end of the telescope tube.

Orient the StarPointer so that the glass window

is facing towards the front of the tube.

Mount the StarPointer bracket by placing it

over the posts on the tube and tighten it down

with the knurled nuts.

The focuser end of the telescope should be

over the counterweight assembly. Tighten the

locking bolt to hold the telescope securely in

place.

Slide the chrome end of the slow motion

control cables onto equatorial mount gear

shaft.

Loosen the set screw on the focuser so that it

does not obstruct the inner diameter of the

focuser.

Long

Cable

Short

Cable

Remove the lens cap from the front of the

telescope. To observe, look through the

eyepiece as shown above.

For detailed usage information please consult your owner’s manual.

Andere Handbücher für FirstScope 114

Dieses Handbuch passt für folgende Modelle

Andere Celestron Teleskop Handbücher

Celestron

Celestron PowerSeeker 21008 Bedienungsanleitung

Celestron

Celestron Tabletop 76 Bedienungsanleitung

Celestron

Celestron NexStar SE Series Bedienungsanleitung

Celestron

Celestron COMETRON 114AZ Bedienungsanleitung

Celestron

Celestron PowerSeeker 114EQ Bedienungsanleitung

Celestron

Celestron EdgeHD 800 Bedienungsanleitung

Celestron

Celestron 52222 Bedienungsanleitung

Celestron

Celestron Advanced VX 91519 Bedienungsanleitung

Celestron

Celestron XLT series Bedienungsanleitung

Celestron

Celestron 11074-XLT Bedienungsanleitung

Celestron

Celestron Ultima 8 Bedienungsanleitung

Celestron

Celestron FirstScope 76EQ Technisches Datenblatt

Celestron

Celestron Travel Scope 70 Bedienungsanleitung

Celestron

Celestron PowerSeeker 127AZ Bedienungsanleitung

Celestron

Celestron NexStar GPS 93507 Bedienungsanleitung

Celestron

Celestron AstroMaster 70AZ Bedienungsanleitung

Celestron

Celestron The G-8 11023 Bedienungsanleitung

Celestron

Celestron OmniXLT AZ Bedienungsanleitung

Celestron

Celestron Celestron 90 Bedienungsanleitung

Celestron

Celestron SKY PRODIGY Bedienungsanleitung

Celestron

Celestron Travel Scope 50 Bedienungsanleitung

Celestron

Celestron 80ED Bedienungsanleitung

Celestron

Celestron Discovery expedition Travel Scope 60 Bedienungsanleitung

Celestron

Celestron C102-AZ Bedienungsanleitung

Beliebte Teleskop Handbücher anderer Marken

Meade

Meade 81005 Condor Bedienungsanleitung

Meade

Meade 114 EQ-DS Bedienungsanleitung

Meade

Meade LX200 CLASSIC Bedienungsanleitung

Leica

Leica 82 HD Bedienungsanleitung

EASTCOLIGHT

EASTCOLIGHT 9920 Bedienungsanleitung

zoomion

zoomion Genesis 200 EQ Bedienungsanleitung

TEC

TEC APO 140 Bedienungsanleitung

Orion

Orion 7832 Bedienungsanleitung

Carson

Carson Skelescope SK-100 Bedienungsanleitung

SKY-WATCHER

SKY-WATCHER VIRTUOSO Bedienungsanleitung

Orion

Orion EZ Finder 7228 Bedienungsanleitung

cassini

cassini C-JRS Bedienungsanleitung

nedis

nedis SCTE5060WT Bedienungsanleitung

Meade

Meade Polaris 60EQ-D Bedienungsanleitung

PlaneWave

PlaneWave CDK700 Bedienungsanleitung

William Optics

William Optics Synta Crayford Bedienungsanleitung

Orion

Orion FUNSCOPE Bedienungsanleitung

Levenhuk

Levenhuk Skyline Travel Bedienungsanleitung