Celestron StarSense Explorer DX 102AZ Bedienungsanleitung

ENGLISH | 1

Unpack your telescope and verify that all parts are

present. Your StarSense Explorer DX includes:

a telescope tube, a tripod and mount head, an

accessory bag, slow motion controls, an accessory

tray, two eyepieces, an erect image diagonal, a

ﬁnderscope, a StarSense phone dock, StarSense

Explorer app code card, and a hex key (hidden inside

the slot in the front of the mount head).

To set up the tripod, spread the legs outward until

they are fully extended and push down the center leg

brace.

ITEM #22460

Extend the legs of the tripod by loosening the three

hand knobs on each leg. Pull each leg section all

the way out and tighten the hand knobs to secure

them in place.

ENGLISH

102AZ

Quick Setup Guide

Place the accessory tray on top of the center brace

and line up the three holes. Insert the three thumb

screws through the bottom of the leg brace and

thread them into the tray.

To attach the slow-motion knobs to your mount,

ﬁrst locate the supplied hex key hidden inside the

slot in the front of your mount.

Place the slow-motion control knob over the

D-shaped gear shaft and push inward to make sure

it is fully seated. Use the hex key to tighten the

setscrews onto the gear shaft. Return the hex key to

its storage position in the front of the mount.

Hold the telescope tube next to the mount with the

dovetail bar on the tube facing the clamp on the top

of the mount arm.

Slide the dovetail bar into the clamp at the top of

the mount and tighten the hand knob on the bottom

of the clamp to secure the telescope in place.

Locate the erect image diagonal and remove the

plastic covers. Insert the barrel of the diagonal into

the focuser and secure in place by tightening the set

screws.

Insert the barrel of the 25 mm eyepiece into the

diagonal and tighten the set screw.

567

8910

2 | ENGLISH

To install the StarSense phone dock, insert the

bayonet mount on the side of the dock into the

port on the side of the mount opposite the dovetail

clamp.

Slide the ﬁnderscope bracket into the dovetail slot

on the telescope tube near the focuser. The large

window on the ﬁnder should be facing the front

of the telescope. Secure the bracket by tightening

the setscrew on the dovetail slot.

Line up the arrow on the dock with the alignment

mark on the mount and press inward while turning

the dock counterclockwise until the orange release

button snaps into place in the hole on the dock.

To remove the dock, press the orange release button

and turn the dock clockwise until the bayonet mount

releases.

Remove the lens cap from the front of the

telescope. To observe, look through the eyepiece

as shown above. Focus the image by turning the

knobs below the focuser.

There is a small clear plastic tab inserted between the

battery and the contact. This was included to prevent

the battery from discharging during shipment. Pull

this out to allow your battery to work.

Downloading and

Activating the App

Before you take your telescope outside, download

the StarSense Explorer app to your mobile device.

Search for “Celestron StarSense Explorer” in the

Apple App Store or Google Play. The app is large,

so we recommend downloading it while connected

to Wi-Fi.

Download the app from the

before your first observing session

When prompted, enter the unique unlock code below to

enable telescope control on your device.

Once you have downloaded the app, locate the

orange postcard in your telescope box. Launch the

app. When prompted, enter the activation code on

the postcard to activate the app. Your code will

unlock up to 5 devices.

14 16

131211

ENGLISH | 3

The StarSense Explorer DX mount has slip clutches

in both axes. To make large movements with the

telescope, simply hold a tripod leg with one hand

and use the other hand on the telescope tube to

push the telescope in the desired direction.

To make ﬁne adjustments or to track celestial

objects, turn both slow motion knobs as required.

Moving the

Telescope

CENTER THE TARGET IN THE EYEPIECE

Look through the telescope using your lower

powered eyepiece. Move the telescope until the

object you chose lies in the center of the view. If the

image is blurry, gently turn the focus knobs on either

side of the telescope until it comes into sharp focus.

NOTE: The image in your telescope may appear

inverted. This is perfectly normal in an

astronomical telescope.

Aligning the

Finderscope

The ﬁnder is one of the most important parts of your

telescope. It helps you locate objects and center

them in the eyepiece. The ﬁrst time you assemble

your telescope, you need to align the ﬁnder to the

telescope’s main optics. It’s best to do this during

the day*.

*SOLAR WARNING! Never attempt to

view the Sun through any telescope without

a proper solar ﬁlter!

CHOOSE A TARGET

Take the telescope outside during the day and ﬁnd

an easily recognizable object, such as a streetlight,

car license plate or sign. The object should be as far

away as possible, but at least a quarter mile away.

ADJUST THE FINDERSCOPE

Without moving the telescope, use the two

adjustment knobs to move the ﬁnder around until

the red dot appears over the same object you are

observing in the telescope’s 25 mm eyepiece.

YOUR FINDERSCOPE IS NOW ALIGNED!

It should not require realignment unless it is bumped

or dropped.

LOOK THROUGH FINDERSCOPE

Once the object is centered in your 25 mm eyepiece,

look through the ﬁnderscope and locate the red dot.

25 mm Eyepiece

Focus Knobs

1 2

3 4 5

1 2

4 | ENGLISH

Your First

Night Out

Congratulations! Your telescope is now set up

and you are ready to explore the cosmos. Take the

telescope outside, insert your 25 mm eyepiece,

remove the lens cap, insert your smartphone into the

holder, and launch the StarSense Explorer app. The

tutorial in the app will walk you through the steps on

ﬁnding your ﬁrst astronomical target.

Attaching the

Smartphone

Remove the large cap covering the mirror on the front

of the StarSense dock.

Pull open the spring loaded slider on the top of the

phone dock and set the phone into the holder so

it is ﬂush with the bottom lip of the phone holder.

Slowly release the slider to secure the phone in

place. Most phones ﬁt into the dock with the case

on. However, you may need to remove your phone

case if it is especially bulky or unable to ﬁt into the

clamp (i.e. folio style cases).

For more information on this product, please visit the respective product page

on celestron.com

SOLAR WARNING:

Never attempt to view the sun through any telescope without a proper solar ﬁlter.

Need assistance?

Contact Celestron Technical Support celestron.com/pages/technical-support

08-19

www.celestron.com/pages/warranty

1 2

Andere Celestron Teleskop Handbücher

Celestron

Celestron C11-SGT Bedienungsanleitung

Celestron

Celestron 52265 Bedienungsanleitung

Celestron

Celestron 52234 Handbuch

Celestron

Celestron Regal F-ED 52301 Bedienungsanleitung

Celestron

Celestron Travel Scope 70 Bedienungsanleitung

Celestron

Celestron 21063 Bedienungsanleitung

Celestron

Celestron FirstScope 114 Bedienungsanleitung

Celestron

Celestron 60LCM Bedienungsanleitung

Celestron

Celestron StarSense Explorer DOB Bedienungsanleitung

Celestron

Celestron 80AZS Bedienungsanleitung

Celestron

Celestron C5+ Bedienungsanleitung

Celestron

Celestron AstroMaster 70AZ Bedienungsanleitung

Celestron

Celestron PowerSeeker 50AZ Bedienungsanleitung

Celestron

Celestron NexStar 114SLT Bedienungsanleitung

Celestron

Celestron Cometron CO-60E Bedienungsanleitung

Celestron

Celestron CPC 925 Bedienungsanleitung

Celestron

Celestron NEXSTAR 4 Bedienungsanleitung

Celestron

Celestron NexStar 60 Bedienungsanleitung

Celestron

Celestron C5+ Bedienungsanleitung

Celestron

Celestron 21065 Bedienungsanleitung

Celestron

Celestron Novice 60 Bedienungsanleitung

Celestron

Celestron NexStar 102GT Bedienungsanleitung

Celestron

Celestron PowerSeeker 114EQ Bedienungsanleitung

Celestron

Celestron 94223 Bedienungsanleitung

Beliebte Teleskop Handbücher anderer Marken

Meade

Meade 81005 Condor Bedienungsanleitung

Meade

Meade 114 EQ-DS Bedienungsanleitung

Meade

Meade LX200 CLASSIC Bedienungsanleitung

Leica

Leica 82 HD Bedienungsanleitung

EASTCOLIGHT

EASTCOLIGHT 9920 Bedienungsanleitung

zoomion

zoomion Genesis 200 EQ Bedienungsanleitung

Orion

Orion 7832 Bedienungsanleitung

Carson

Carson Skelescope SK-100 Bedienungsanleitung

SKY-WATCHER

SKY-WATCHER VIRTUOSO Bedienungsanleitung

Orion

Orion EZ Finder 7228 Bedienungsanleitung

cassini

cassini C-JRS Bedienungsanleitung

nedis

nedis SCTE5060WT Bedienungsanleitung

Meade

Meade Polaris 60EQ-D Bedienungsanleitung

PlaneWave

PlaneWave CDK700 Bedienungsanleitung

William Optics

William Optics Synta Crayford Bedienungsanleitung

Orion

Orion FUNSCOPE Bedienungsanleitung

Levenhuk

Levenhuk Skyline Travel Bedienungsanleitung

Meade

Meade 6600 Bedienungsanleitung