Chamberlain 972LM Bedienungsanleitung

SECURITY✚

Garage Door Opener

"Smart" (learn)

Button Indicator Light

KG KG

123

Children operating or playing with a garage door

opener can injure themselves or others. The garage

door could close and cause serious injury or death.

Do not allow children to operate the wall push

buttons or remote controls.

A moving garage door could injure or kill someone

under it. Activate the opener only when you can see

the door clearly, it is free of obstructions, and is

properly adjusted.

WARNING

Model 972LM Security✚

2-Channel Remote Control

OWNER'S MANUAL

Figure 2

NOTICE: To comply with FCC rules, adjustment or modifications of this receiver

and/or transmitter are prohibited, except for changing the code setting or

replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.

Figure 1

Left

Push button

Model 972LM

SECURITY✚

Remote Control

The 972LM remote control can activate two separate

garage door openers, gate openers, entryways and/or light

controls. (Instructions for programming light products are

included with those accessories.)

The left push button works only with receivers having a

yellow indicator light.

The rolling code between this channel

and the receiver changes with each use, randomly

accessing over 100 billion new codes.

The push button on the

right

is for use when several

persons are operating one receiver. Its code can be

matched to other

CGI manufactured fixed code or billion

code remotes.

The code between this channel and the

receiver remains constant until reprogrammed.

Instructions are described and illustrated below.

WHEN USED WITH SECURITY✚

GARAGE DOOR OPENERS

To program the opener to accept the remote control

code:

Press and hold the left

remote control push button. See

Figure 1.

2. Press and release the “Smart” (learn) button on the

opener panel. See Figure 2. The indicator light on the

panel will begin to blink and the opener lights will flash

once.

Release the remote push button.

Now the opener will operate when the left push button is

pressed.

Adding a remote can also be done from the door control, as

follows:

With the door closed, press and hold the left

push button.

2. Press and hold the Light button on the door control.

3. Press and hold the door control push bar.

4. After the opener lights flash, release all buttons.

Test by pressing the left remote push button.

TO ERASE ALL REMOTE CONTROL CODES

FROM THE RECEIVER

Press and hold the “Smart” button on the opener panel until

the indicator light turns off (about 6 seconds). All transmitter

codes inside the

receiver

are now erased. Then follow the

steps above to re-program each remote control.

WHEN SEVERAL REMOTES OPERATE ONE DEVICE

To match the 972LM to another CGI manufactured

remote’s code (Remote Control X):

1. With the 972LM bottom side up,

press and hold both

push buttons

until the yellow indicator light begins to

blink. It will blink for 30 seconds; during this time it is in

“learn” mode.

2. While it is in learn mode, hold both transmitters back to

back with the FCC labels touching, then

Press and hold the Remote Control X push button

as you

slowly slide the remotes across each other until the

972LM indicator light blinks very rapidly, indicating it has

learned the code. See Figure 3. (If Remote Control X is

also a 972LM, you must press and hold its

right hand

button.)

Now the device will operate when the

right hand

push

button is pressed.

This code will remain inside the

remote control

until

replaced with a new code by repeating the above steps.

Remote Control X

Yellow

Indicator

Light

FCC

Label

Figure 3

Side two contains battery and replacement parts

information.

Replacement Parts

Model 972LM Security✚remote case . . . . . .41A5059-2

(circuit board not included)

3V2032 Lithium battery (2 required) . . . . . . . . . . .10A20

Visor clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137

FOR SERVICE DIAL OUR TOLL FREE NUMBER:

1-800-528-2817

The Remote Control Batteries

The lithium batteries should produce

power for up to 5 years. To

replace, pry open case with visor

clip or screwdriver, as shown.

Insert batteries

positive side up (+).

Dispose of old batteries properly.

Keep batteries away from small children. If

swallowed, promptly notify doctor.

WARNING

Andere Chamberlain Fernbedienung Handbücher

Chamberlain

Chamberlain 82LM Bedienungsanleitung

Chamberlain

Chamberlain PASSPORT CPT4 Bedienungsanleitung

Chamberlain

Chamberlain KLIK3C-BL Bedienungsanleitung

Chamberlain

Chamberlain KLIK3U-BK Bedienungsanleitung

Chamberlain

Chamberlain 33LMC Bedienungsanleitung

Chamberlain

Chamberlain 750 Bedienungsanleitung

Chamberlain

Chamberlain LiftMaster 375UT Bedienungsanleitung

Chamberlain

Chamberlain 375UT Bedienungsanleitung

Chamberlain

Chamberlain POWER DRIVE Whisper Drive 950CD Bedienungsanleitung

Chamberlain

Chamberlain CPTKx Bedienungsanleitung

Chamberlain

Chamberlain Passport CPT series Bedienungsanleitung

Chamberlain

Chamberlain 371LM Bedienungsanleitung

Chamberlain

Chamberlain 54332EML Bedienungsanleitung

Chamberlain

Chamberlain LiftMaster Professional 33LM Bedienungsanleitung

Chamberlain

Chamberlain LiftMaster Security+ 973LM Bedienungsanleitung

Chamberlain

Chamberlain 956D Bedienungsanleitung

Chamberlain

Chamberlain PPLV1 Bedienungsanleitung

Chamberlain

Chamberlain 890MAX Bedienungsanleitung

Chamberlain

Chamberlain 99LM Bedienungsanleitung

Chamberlain

Chamberlain 312HMC Bedienungsanleitung

Chamberlain

Chamberlain MC100AML Bedienungsanleitung

Chamberlain

Chamberlain LiftMaster Professional 82LM Bedienungsanleitung

Chamberlain

Chamberlain Clicker KLIK1U Bedienungsanleitung

Chamberlain

Chamberlain 375LM Bedienungsanleitung

Beliebte Fernbedienung Handbücher anderer Marken

Panasonic

Panasonic EUR7622KB0 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen Beo4 Bedienungsanleitung

Sunwave Tech.

Sunwave Tech. RemoteComm SRC-7000 Bedienungsanleitung

Multiplex

Multiplex PROFI TX 9 Bedienungsanleitung

One Remote

One Remote RMB4 Bedienungsanleitung

FUTABA

FUTABA 9ZAP - PART2 Bedienungsanleitung

HR Matic

HR Matic HR MULTI 3 Bedienungsanleitung

Yamaha

Yamaha ACC-GNRST-30-20 Bedienungsanleitung

EisSound

EisSound KBSOUND Bedienungsanleitung

Marantz

Marantz RC101 Bedienungsanleitung

Conrad

Conrad FS20 TC6 Bedienungsanleitung

Anritsu

Anritsu MP1777A Bedienungsanleitung

Niles

Niles WVC100 Fehlerbehebungshandbuch

RCA

RCA RCU1300 Bedienungsanleitung

Bang & Olufsen

Bang & Olufsen BEO6 Bedienungsanleitung

GE 94901 Bedienungsanleitung

Onbon

Onbon YQ1-75 Bedienungsanleitung

FUTABA

FUTABA R7108SB Montageanleitung