Chauvet DJ BOB LED Bedienungsanleitung

User Manual

Page 2 of 15 BOB LED User Manual Rev. 5

TABLE OF CONTENTS

1. Before You Begin.......................................................................................................... 3

What Is Included .............................................................................................................................3

Unpacking Instructions....................................................................................................................3

Claims..................................................................................................................................................... 3

Text Conventions ............................................................................................................................3

Symbols ..........................................................................................................................................3

Disclaimer .......................................................................................................................................3

Product at a Glance ........................................................................................................................4

Safety Notes....................................................................................................................................4

2. Introduction................................................................................................................... 5

Product Overview............................................................................................................................5

Product Overview Cont...................................................................................................................6

Product Dimensions........................................................................................................................7

3. Setup.............................................................................................................................. 8

AC Power........................................................................................................................................8

Fuse Replacement..........................................................................................................................8

Mounting .........................................................................................................................................9

Orientation.............................................................................................................................................. 9

Rigging ................................................................................................................................................... 9

Floor Mounting Diagram......................................................................................................................... 9

Hanging Mounting Diagram.................................................................................................................. 10

4. Operation......................................................................................................................11

Silk Flame Attachment..................................................................................................................11

Configuration (Standalone)...........................................................................................................11

5. Maintenance .................................................................................................................12

Product Maintenance....................................................................................................................12

6. Technical Specifications..............................................................................................13

Returns .............................................................................................................................14

Contact Us........................................................................................................................15

BOB LED User Manual Rev. 5 Page 3 of 15

1.BEFORE YOU BEGIN

What Is

Included

•BOB LED

•Hanging Chain

•Table/Floor Mounting Legs

•Connecting Hardware

•Warranty Card

•Quick Reference Guide

Unpacking

Instructions

Carefully unpack the product immediately and check the container to make sure all the

parts are in the package and are in good condition.

Claims

If the box or the contents (the product and included accessories) appear damaged from

shipping, or show signs of mishandling, notify the carrier immediately, not Chauvet. Failure

to report damage to the carrier immediately may invalidate your claim. In addition, keep the

box and contents for inspection.

For other issues, such as missing components or parts, damage not related to shipping, or

concealed damage, file a claim with Chauvet within 7 days of delivery.

Text

Conventions

Convention

Meaning

1—512

A range of values

50/60

A set of values of which only one can be chosen

Settings

A menu option not to be modified

Menu > Settings

A sequence of menu options to be followed

<ENTER>

A key to be pressed on the product’s control panel

A value to be entered or selected

Symbols

Symbol Meaning

Electrical warning. Not following these instructions may cause

electrical damage to the product, accessories, or the user.

Critical installation, configuration, or operation information. Not

following these instructions may make the product not work, cause

damage to the product, or cause harm to the operator.

Important installation or configuration information. The product

may not function correctly if this information is not used.

Useful information.

Disclaimer

Chauvet believes that the information contained in this manual is accurate in all respects. However,

Chauvet assumes no responsibility and specifically disclaims any and all liability to any party for

any loss, damage or disruption caused by any errors or omissions inthis document, whether such

errors or omissions result from negligence, accident or any other cause. Chauvet reserves the right

to revise the content of this document without any obligation to notify any person or company of

such revision, however, Chauvet has no obligation to make, and does not commit to make, any

such revisions. Download the latest version from www.chauvetlighting.com.

The works of authorship contained in this manual, including, but not limited to, alldesign, text and

images are owned by Chauvet.

Electronically published by Chauvet in the United States of America.

CHAUVET, the Chauvet logo and “BOB LED” are registered trademarks or trademarks of

Chauvet & Sons LLC. (d/b/a Chauvet and Chauvet Lighting) in the United States and

other countries. Other company and product names and logos referred to herein

may be trademarks of their respective companies.

Page 4 of 15 BOB LED User Manual Rev. 5

Product at a

Glance

Use on Dimmer

Auto Programs

Outdoor Use

Auto-ranging Power Supply

Sound-Active

Replaceable Fuse

DMX

User-Serviceable

Master/Slave

Safety Notes

Please read the following Safety Notes carefully before working with the product. The

Notes include important safety information about installation, usage, and maintenance.

•Always connect the product to a grounded circuit to avoid the risk of electrocution.

•Always disconnect the product from the power source before cleaning or replacing

the fuse.

•Avoid direct eye exposure to the light source while the product is on.

•Make sure the power cord is not crimped or damaged.

•Never disconnect the product from power cord by pulling or tugging on the cord.

•If mounting the product overhead, always secure to a fastening device using a

safety cable.

•Make sure there are no flammable materials close to the product when operating.

•

Do not touch the product’s housing when operating because it may be very hot.

•The product is not intended for permanent installation.

•Always make sure that the voltage of the outlet to which you are connecting the

product is within the range stated on the decal or rear panel of the product.

•The product is for indoor use only! (IP20) To prevent risk of fire or shock, do not

expose the product to rain or moisture.

•Always install the product in a location with adequate ventilation, at least 20 in

(50 cm) from adjacent surfaces.

•Be sure that no ventilation slots on the product’s housing are blocked.

•Never connect the product to a dimmer.

•Make sure to replace the fuse with another of the same type and rating.

•Never carry the product from the power cord or any moving part. Always use the

hanging/mounting bracket.

•The maximum ambient temperature (Ta) is 104 °F (40 °C). Do not operate the

product at higher temperatures.

•In the event of a serious operating problem, stop using the product immediately.

•Never try to repair the product. Repairs carried out by unskilled people can lead to

damage or malfunction. Please contact the nearest authorized technical assistance

center.

•To eliminate unnecessary wear and improve its lifespan, during periods of non-use

completely disconnect the product from power via breaker or by unplugging it.

•Keep this User Manual for future use. If you sell the product to someone else, be

sure that they also receive this document.

BOB LED User Manual Rev. 5 Page 5 of 15

2.INTRODUCTION

Product Overview

Mounting

Legs x 3

Air Vents

Top View

Front View

Chain

Attachment

Holes x 3

Silk Attachment

Plates x 2

Page 6 of 15 BOB LED User Manual Rev. 5

Product Overview Cont.

Hanging Loop

Magnetic

Strips

Hanging Chain

Silk Flame Attachment

Attachment

Loops

For illustrative purposes. Your product may differ slighting from the diagrams shown.

BOB LED User Manual Rev. 5 Page 7 of 15

Product Dimensions

17.5 in

445 mm

17.5 in

445 mm

12.5 in

318 mm

5.5 in

140 mm

11 in

279 mm

27 in

686 mm

Page 8 of 15 BOB LED User Manual Rev. 5

3.SETUP

AC Power

The BOB LED has a fixed power supply and it can work with an input voltage of 120 VAC,

60 Hz or 230 VAC, 50Hz. To determine the product’s power requirements (

circuit breaker,

power outlet, and wiring), use the current value listed on the label affixed to the product’s

back panel, or refer to the product

’s specifications chart. The listed current rating indicates

the product’s average current draw under normal conditions.

•Always connect the product to a protected circuit (circui

t breaker or

fuse). Make sure the product

has an appropriate electrical ground to

avoid the risk of electrocution or fire.

•

To eliminate unnecessary wear and improve its lifespan, during periods

of non-use completely disconnect the product from power via br

eaker

or by unplugging it.

Never connect the product

to a rheostat (variable resistor) or dimmer

circuit, even if the rheostat or dimmer channel serves only as a 0 to 100%

switch.

Fuse

Replacement

1. Disconnect the product from power.

2. With a Phillip's head screwdriver, unscrew the fuse holder cap from the housing.

3. Remove the blown fuse.

4. Replace with a fuse of the same type and rating.

5. Screw the fuse holder cap back in place and reconnect power.

Disconnect the product from the power outlet before replacing the fuse.

Fuse Holder

Power Cord In

BOB LED User Manual Rev. 5 Page 9 of 15

Mounting

Before mounting the product

, read and follow the safety recommendations indicated in the

Safety Notes.

Orientation

The BOB LED may be used with the chain suspensions or with the 3 table/floor mounting

legs that are provided with the fixture. Make sure there is adequate room for ventilation

when mounting this product.

Rigging

•Before deciding on a location for the product, always make sure there is easy access

to the product for maintenance purposes.

•Make sure that the structure onto which you are mounting the product can support the

product’s weight. See the Technical Specifications for weight information.

Floor

Mounting

Diagram

Attach legs w

ith included hardware, using a Phillip's screwdriver. Attach

legs one at a time.

Legs for Table/Floor

Mounting (with

included hardware)

Page 10 of 15 BOB LED User Manual Rev. 5

Hanging

Mounting

Diagram

Attach all 3 chain sections to the chain attachment holes on flame base.

Be sure the silk flame is clear of the chain while hanging and during

operation.

Inhaltsverzeichnis

Andere Chauvet DJ DJ-Equipment Handbücher

Chauvet DJ

Chauvet DJ Swarm 5FX Bedienungsanleitung

Chauvet DJ

Chauvet DJ GOBO ZOO 2 Bedienungsanleitung

Chauvet DJ

Chauvet DJ FESTOON 2 RGB Handbuch

Chauvet DJ

Chauvet DJ OVATION FD-105WW Bedienungsanleitung

Chauvet DJ

Chauvet DJ COLORbar SMD Bedienungsanleitung

Chauvet DJ

Chauvet DJ COLORband H9 Bedienungsanleitung

Chauvet DJ

Chauvet DJ COLORband T3BT ILS Bedienungsanleitung

Chauvet DJ

Chauvet DJ SlimPAR H6 USB Montageanleitung

Chauvet DJ

Chauvet DJ Derby X Bedienungsanleitung

Chauvet DJ

Chauvet DJ GigBAR MOVE ILS Bedienungsanleitung

Chauvet DJ

Chauvet DJ EZLink Par Q1BT Bedienungsanleitung

Chauvet DJ

Chauvet DJ EZ Laser RB Bedienungsanleitung

Chauvet DJ

Chauvet DJ Intimidator Scan 305 IRC Bedienungsanleitung

Chauvet DJ

Chauvet DJ OBSESSION Bedienungsanleitung

Chauvet DJ

Chauvet DJ Obey 40 D-Fi 2.4 Bedienungsanleitung

Chauvet DJ

Chauvet DJ Hurricane Bubble Haze LT Bedienungsanleitung

Chauvet DJ

Chauvet DJ FREEDOM CHARGE 8 Bedienungsanleitung

Chauvet DJ

Chauvet DJ COREpar Q120 ILS Bedienungsanleitung

Chauvet DJ

Chauvet DJ LX-10 Bedienungsanleitung

Chauvet DJ

Chauvet DJ ILS Command Bedienungsanleitung

Chauvet DJ

Chauvet DJ INTIMIDATOR SPOT 260 Bedienungsanleitung

Chauvet DJ

Chauvet DJ Foot-C 2 Bedienungsanleitung

Chauvet DJ

Chauvet DJ Festoon Bedienungsanleitung

Chauvet DJ

Chauvet DJ MINI KINTA IRC Bedienungsanleitung

Beliebte DJ-Equipment Handbücher anderer Marken

ALPHA LITE

ALPHA LITE ALPHA 1500 Betriebsanleitung

Chauvet

Chauvet OVATION E-930VW Bedienungsanleitung

Snow Masters

Snow Masters Zig Oscillator Bedienungsanleitung

EuroLite

EuroLite 50530554 Bedienungsanleitung

Beamz

Beamz BUV243 Bedienungsanleitung

thomann

thomann Stairville DJ Lase 40-G MK-III Bedienungsanleitung

Eagletone

Eagletone 6 Eyes Flower Bedienungsanleitung

EuroLite

EuroLite FLD-1508 Bedienungsanleitung

Technical Pro

Technical Pro LG8xSEA Bedienungsanleitung

JB Systems

JB Systems Lounge Laser DMX Bedienungsanleitung

Lightmaxx

Lightmaxx Vega Halo 90 Bedienungsanleitung

Elation

Elation FUZE WASH Z350 Bedienungsanleitung

Maverick

Maverick MK3 WASH Bedienungsanleitung

Infinity

Infinity TF-260C7 Fresnel Bedienungsanleitung

Chauvet

Chauvet EVE E-50Z Bedienungsanleitung

Eliminator Lighting

Eliminator Lighting E 138 Bedienungsanleitung

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Bedienungsanleitung

KAM

KAM DMX Laser80 FScan Bedienungsanleitung