Christie LW650 Bedienungsanleitung

LW650 Lamp/Filter Replacement Instruction Sheet 1 of 3

020-000185-01 Rev. 1 (03-2009)

LW650 Lamp/Filter Replacement

Instruction Sheet

INTRODUCTION

These instructions outline the details for Lamp and Filter replacement in the LW650 projector (Model

No. 121-002103-01). NOTICE: Use only a Christie approved Lamp and Filter Kit for your specific

projector model.

KITS REQUIRED

003-120483-01 (Replacement Lamp)

003-002722-01 (Replacement Air Filter)

INSTRUCTIONS

LAMP REPLACEMENT

When the projected image darkens or color reproduction becomes poor, the lamp needs to be replaced.

NOTE: If the projector is ceiling mounted, or if the lamp bulb has broken, the lamp unit should also be

replaced.

Always power down and disconnect/disengage all power sources to the

projector before servicing or cleaning.

Allow the projector to cool for at least 45 minutes before the lamp cover is

opened. The inside of the projector can become very hot and may cause injury.

Do Not operate the projector while any of the lamps are removed. This may

result in malfunctions, fire hazard, or other possible accidents.

NOTICES: 1) Switch the lamp OFF before opening the lamp cover. 2) For continued safety, replace

with a lamp assembly of the same type. 3) Do not drop the lamp assembly or touch a glass bulb! The

glass can shatter and may cause injury.

2 of 3 LW650 Lamp/Filter Replacement Instruction Sheet

020-000185-01 Rev. 1 (03-2009)

1. Loosen the lamp cover screw (Figure 1-Top). Slide the cover to

remove it from the projector.

2. Loosen the 3 screws (Figure 1-Bottom) that attach the lamp unit

to the projector.

3. Use the handles to remove the lamp unit from the projector

(Figure 1-Bottom).

4. Set the new lamp unit into place and tighten the 3 screws that

attach it to the projector.

5. Slide the lamp cover back into place, and tighten the lamp cover

screw.

RESETTING THE LAMP TIME VALUE

1. Switch the power button to ON.

2. Press the MENU button (on the control panel or the

remote control) to access the ADVANCED MENU. Use

the ▲/▼cursor buttons on the EASY MENU to select

the “ADVANCED MENU”, then press the ►cursor

button.

3. Select “OPTION” using the ▲/▼cursor buttons in the

left column, then press the ►cursor button.

4. Select the “LAMP TIME” using the ▲/▼cursor buttons

in the right column, then press the ►cursor button.

5. Use the ►cursor button according to the dialog, Select

“OK” to reset the LAMP TIME value.

NOTES: 1) The LAMP TIME value shown on the OPTION

menu is the use time since the last time the LAMP TIME was

reset. Refer to the value for proper maintenance. 2) Do not

reset the LAMP TIME without replacing a lamp.

Figure 1 Lamp Replacement

Figure 2 Lamp Time Reset

LW650 Lamp/Filter Replacement Instruction Sheet 3 of 3

020-000185-01 Rev. 1 (03-2009)

REPLACING THE FILTER CARTRIDGE

Always power down and disconnect/disengage all power sources to the

projector before servicing or cleaning.

Allow the projector to cool for at least 45 minutes before the lamp cover is

opened. The inside of the projector can become very hot and may cause injury.

NOTE: To maintain normal internal ventilation replace the filter unit periodically.

1. Use a vacuum cleaner to remove dust on and

around the filter cover (Figure 3-Top-Left).

2. Lift and pull the bottom clips to remove the filter

cover (Figure 3-Top-Right).

3. Pinch and pull the filter clips to remove the filter

unit (Figure 3-Bottom-Left).

4. Use a vacuum cleaner to remove dust on and

around the intake vents of the projector (Figure 3-

Bottom-Right).

5. Install the new filter unit into the place.

6. Install the filter cover.

NOTICES: 1) Make sure the filter cartridge is

correctly inserted into the projector otherwise, the

projector cannot be turned on. 2) Do not block the air

vents. Doing so may result in malfunction of the projector. 3) When using the projector under dusty or

smoky conditions, dust may accumulate on a lens, liquid crystal panels, or optical elements inside the

projector. Such conditions may degrade the quality of the projected image. When the symptoms above

are noticed, contact your authorized dealer or service station for proper cleaning.

RESETTING THE FILTER COUNTER

1. Switch the power button to ON.

2. Press the MENU button (on the control panel or the remote

control) to access the ADVANCED MENU. Use the ▲/▼

cursor buttons on the EASY MENU to select the

“ADVANCED MENU”, then press the ►cursor button

(Figure 4).

3. Select the “FILTER TIME” using the ▲/▼cursor buttons in

the right column, then press the ►cursor button.

4. Use the ►cursor button according to the dialog, Select “OK”

to reset the FILTER TIME value.

NOTES: 1) The FILTER TIME value shown on the EASY menu is

the use time since the last time the FILTER TIME was reset. Refer

to the value for proper maintenance. 2) Do not reset the FILTER

TIME without replacing a filter.

Filter cover clips

Filter unit clips

Figure 3 Filter Replacement

Figure 4 Filter Time Reset

Andere Handbücher für LW650

Inhaltsverzeichnis

Andere Christie Projektor Handbücher

Christie

Christie G Series Kurzanleitung

Christie

Christie LX501 Bedienungsanleitung

Christie

Christie M Series Bedienungsanleitung

Christie

Christie Griffyn Series Montageanleitung

Christie

Christie CP4230 Bedienungsanleitung

Christie

Christie Roadster S9 Bedienungsanleitung

Christie

Christie LX501 Bedienungsanleitung

Christie

Christie Mirage 4K40-RGB Gebrauchs- und Pflegehandbuch

Christie

Christie DS+60 Bedienungsanleitung

Christie

Christie DWU951 Bedienungsanleitung

Christie

Christie CP2308-G Montageanleitung

Christie

Christie CAPTIVA DHD400S Bedienungsanleitung

Christie

Christie DHD700 Bedienungsanleitung

Christie

Christie CP2308-C Benutzerhandbuch

Christie

Christie LWU505 Bedienungsanleitung

Christie

Christie GraphXMASTER DLV1400-DX Bedienungsanleitung

Christie

Christie LW600 Bedienungsanleitung

Christie

Christie Cinema 4K-RGB CP4315-RGB Bedienungsanleitung

Christie

Christie LWU720i Bedienungsanleitung

Christie

Christie Roadster S+12K Leitfaden

Christie

Christie Mirage 4K40-RGB Montageanleitung

Christie

Christie Solaria CP2210 Bedienungsanleitung

Christie

Christie LW555 Bedienungsanleitung

Christie

Christie DWU1052 Bedienungsanleitung

Beliebte Projektor Handbücher anderer Marken

iEmmet

iEmmet MP-312 Bedienungsanleitung

Epson

Epson VS400 Bedienungsanleitung

Sony

Sony VPL-HS10 Marketing Specifications & Features Bedienungsanleitung

Sony

Sony VPL-HW65ES Service-Handbuch

Toshiba

Toshiba TLP-791U Bedienungsanleitung

Philips

Philips LC1341 Referenzhandbuch

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Bedienungsanleitung

NEC

NEC NP600S EDU Bedienungsanleitung

BenQ

BenQ SH753P Bedienungsanleitung

Eiki

Eiki EK-623U series Bedienungsanleitung

Epson

Epson PowerLite Pro Cinema 6020UB Bedienungsanleitung

Epson

Epson PowerLite Home Cinema 705HD Bedienungsanleitung

Navitar

Navitar FX Bedienungsanleitung

InFocus

InFocus LitePro 560 Bedienungsanleitung

Sony

Sony SRX-R815P Bedienungsanleitung

Vivitar

Vivitar DP1500 X Bedienungsanleitung

Acer

Acer C20 Series Bedienungsanleitung

Asus

Asus ZenBeam Latte Bedienungsanleitung