Cisco TelePresence SpeakerTrack 60 Bedienungsanleitung

Cisco TelePresence

SpeakerTrack 60

INSTALLATION GUIDE

The SpeakerTrack 60 uses a unique dual-camera

technique to quickly view a close-up of the active

speaker in the meeting room.

78-100223-02E0 | OCTOBER 2016.

Installation

We invite you to explore the Project Workplace guide to inspire you on room design and room

setup. Go to: www.cisco.com/go/projectworkplace

Main box contents

A. 1 × Cover plate

B. 1 × Microphone panel with four

biult-in microphones

C. 2 × Precision 60 Camera

D. 1 × Base unit, with connectors

1 × Accessories box

1 × Installation Guide

Accessories

E. 2 × Camera interface plate

F. 1 × Wall bracket

G. 1 × DC Power cable w/ barrel plug,

20 cm / 7.87 in

H. 1 × DC Power cable w/ barrel plug,

45 cm / 17.72 in

I. 1 × Ethernet cable, 20 cm / 7.87 in

J. 1 × Ethernet cable, 35 cm / 13.78 in

K. 1 × Power adapter and power cable

L. 1 × Gloves

M. 1 × Torx Key (T20)

N. 1 × Allen Key

O. 2 × Thumb nut, M4

P. 4 × Pan headed screw, M4 16 mm

Q. 2 × 1/4” UNC screw

R. 1 × Template for attaching the

wall bracket (not shown)

L NM

O QP

WARNING: Use Ethernet cable only when connecting to the Ethernet port on the

camera. Do not connect a serial VISCA cable to the Ethernet port on the camera, as

this will cause severe damage to the camera.

Safety instructions

NOTE

• It is of great importance that the wall mount unit is safely installed, that the wall

is able to support the product and that the screws or mounting means used are

suitable for the wall and the weight of the product.

• This type of equipment is to be installed by the submitter’s/dealer’s qualied

installer. The installer is responsible for obtaining safety inspection of the

structural integrity of the installation by the local authority/inspection department.

• Note that the surface is hot when the camera is in operation.

Horizontal eld of view

The participants should be seated within the horizontal eld of view. Participants seated

outside the horizontal eld of view will not have optimal audio tracking.

Horizontal eld

of view 80°

Microphone range

The participants should be seated within the maximum microphone range. For optimal audio

tracking the SpeakerTrack 60 should be mounted at some distance from the side walls.

Maximum microphone range

900 cm / 354 in

Minimum distance to the side walls

120 cm / 47.25 in

Mounting height not above

183 cm / 72 in

SpeakerTrack 60 mounted above the monitor

Mounting height not below

107 cm / 42 in

SpeakerTrack 60 mounted below the monitor

Option 1: Mount the camera on the wall

The SpeakerTrack 60 can be mounted above or below the monitor. For large monitors (70” and

above), we recommend mounting the SpeakerTrack 60 below the monitor.

Select a mounting height for SpeakerTrack 60 that provides clear line of sight, to all four

edges of the microphone panel, from all appropriate positions in the meeting room.

NOTE: Obstacles placed in front of the microphone panel, or in the sight line of the

microphones, will cause severe loss in the speaker track performance.

Minimum distance to the ceiling

40 cm / 15.75 in

Option 2: Mount the camera in a recess

The recommendations for mounting the camera in a recess are the same as for mounting it

on the wall, with the following addition: If mounted in a recess, the sound from any participant

in the room must reach at least three of the four microphones on the microphone panel. To

achieve this, the recess should have slanted walls*.

SpeakerTrack 60 mounted in a recess above the monitor

• The bottom wall of the recess is slanted 17°

• The side walls of the recess are slanted 45°

• The maximum depth of the recess is 218 mm (8.56 in). If less the camera will protrude

from the wall. Follow local building regulations and accessibility requirements.

82 cm (32.3 in)

32 cm

(12.6 in)

SpeakerTrack 60 mounted in a recess below the monitor

82 cm (32.3 in)

32 cm

(12.6 in)

• The upper wall of the recess is slanted 17°

• The side walls of the recess are slanted 45°

• The maximum depth of the recess is 218 mm (8.56 in). If less the camera will protrude

from the wall. Follow local building regulations and accessibility requirements.

* CAD drawings with details and dimensions: http://www.cisco.com/go/telepresence/docs and

navigate to: Collaboration Endpoints > Collaboration Peripherals > TelePresence Peripherals >

TelePresence SpeakerTrack 60 > Technical References

Mount the wall bracket

NOTE: Read the mounting guidelines and safety instructions before you start mounting the

wall bracket (F).

Use the Template for attaching the wall bracket (R), found with the accessories, and follow

the instructions on the template when mounting the wall bracket.

78-100272-01A0 | FEBRUARY 2014.

Template for attaching wall bracket for SpeakerTrack 60

Gabarit de xation du support mural pour SpeakerTrack 60

Check that the unit is level.

Vériez que l’appareil est à niveau.

SpeakerTrack 60

rear panel

SpeakerTrack 60

panneau arrière

The monitor

center point

Template for drilling holes

(found overleaf)

Modèle pour les trous de forage

(qui se trouve au verso)

Wall bracket

Support mural

Find the center point of the

monitor and the top center point of

the SpeakerTrack 60 rear panel.

Localisez le centre du moniteur

et le centre supérieur du

SpeakerTrack 60.

Use the template on the other side of

this sheet when drilling holes for the

wall bracket. Screw dimension M6.

Utilisez le modèle au verso de cette

page pour le perçage des trous de la

xation murale. Vis dimension M6.

Select the type of attachment for

the wall bracket on the basis of the

type of material the wall is made of

(wood, concrete, gypsum).

Sélectionnez le type de xation du

support mural en fonction du type

de matériau du mur (bois, ciment,

gypse).

Template Page 1

Template Page 2

Mount the base unit

Place the microphone panel (B) on a clean and stable surface (for example a table) with the

microphone cables headed up and the textile headed down.

Remove the cover plate (A) from the base unit before this

operation. Hold the base unit (D) as illustrated and slide in

place. Make sure the guide-pins positions correctly.

Use the four pan headed screws (P) when fastening the base unit.

Use the Torx Key (M) and tighten the screws.

Use the supplied

gloves (L).

Mount the cables

Connect the cables to the connector panel on the base unit:

1. Find the Ethernet cables (I, J) and the power cables (G, H) in the accessories box.

Connect the short cables to the connectors marked R ( ) and the long cables to the

connectors marked L ( ). Lead them through the open slot to make them available for

camera mounting.

2. Connect the microphone cables coming from the microphone panel.

3. Find the power adapter and the power cable (K) in the accessories box. Connect the

power cable to the base unit.

4. Connect an Ethernet cable (not included) to the Ethernet port on the base unit. Connect

the other end directly to the codec. If you do not have any free Ethernet port on the

codec (typically if a Touch device is connected) you will need a network switch. Connect

the switch to the Ethernet port on the codec, and connect the Touch device and

SpeakerTrack 60 to the switch. We recommend using a Cisco switch.

1 2

3 4

Rear view

Connect the short Ethernet and

power cables to the right camera,

and the long Ethernet and power

cables to the left camera.

Connect the microphone

cables that comes from

the microphone panel.

Connect the

power cable.

Connect the Ethernet

cable (not included)

directly to the codec

(Eth2/Eth3).

Mount the interface plate to the cameras

Place the camera (C) on a stable surface as illustrated. Use the 1/4” UNC screw (Q) and

Allen Key (N) and mount the camera interface plate (E) to the camera.

Repeat these steps for the second camera (C).

Mount the assembly to the wall

Hold and lift the unit as illustrated. Carefully place the unit onto the wall bracket.

Check that the unit is level. If not,

you can adjust the unit sideways.

Andere Handbücher für TelePresence SpeakerTrack 60

Inhaltsverzeichnis

Andere Cisco Konferenzsystem Handbücher

Cisco

Cisco TelePresence System Codec C90 Bedienungsanleitung

Cisco

Cisco TelePresence SX10 Bedienungsanleitung

Cisco

Cisco TelePresence SX10 Bedienungsanleitung

Cisco

Cisco 3500 MCU Bedienungsanleitung

Cisco

Cisco ICS-7750 Bedienungs- und Montageanleitung

Cisco

Cisco TelePresence SX20 Service-Handbuch

Cisco

Cisco TelePresence IX5000 Einrichtungshandbuch

Cisco

Cisco TelePresence MX700 Bedienungsanleitung

Cisco

Cisco Profile Series Bedienungsanleitung

Cisco

Cisco EX90 Bedienungsanleitung

Cisco

Cisco Profile Series Bedienungsanleitung

Cisco

Cisco TelePresence System 1100 Bedienungsanleitung

Cisco

Cisco EX60 Bedienungsanleitung

Cisco

Cisco Cius Bedienungsanleitung

Cisco

Cisco TelePresence MXP Series Service-Handbuch

Cisco

Cisco TelePresence SX10 Bedienungsanleitung

Cisco

Cisco TelePresence DX70 Service-Handbuch

Cisco

Cisco 7937G - Unified IP Conference Station VoIP... Bedienungsanleitung

Cisco

Cisco EX60 Bedienungsanleitung

Cisco

Cisco TelePresence System Codec C40 Service-Handbuch

Cisco

Cisco 500 Series Bedienungsanleitung

Cisco

Cisco ONS 15454 Series Bedienungsanleitung

Cisco

Cisco 7937 Bedienungsanleitung

Cisco

Cisco TelePresence DX70 Bedienungsanleitung

Beliebte Konferenzsystem Handbücher anderer Marken

Kramer

Kramer VIA GO Bedienungsanleitung

ProSoft Technology

ProSoft Technology AN-X4-AB-DHRIO Bedienungsanleitung

Sony

Sony PCS-I150 Bedienungsanleitung

Middle Atlantic Products

Middle Atlantic Products VTC Series Bedienungsanleitung

AVT

AVT MAGIC AC1 Go Bedienungsanleitung

Prentke Romich Company

Prentke Romich Company Vanguard Plus Leitfaden

Speakerbus

Speakerbus iD 712 Bedienungsanleitung

Trelleborg

Trelleborg SafePilot CAT PRO Bedienungsanleitung

Sennheiser

Sennheiser ADN Bedienungsanleitung

ADTRAN

ADTRAN NetVanta 7100 Bedienungsanleitung

AINA

AINA PTT Voice Responder Bedienungsanleitung

Yamaha

Yamaha ProjectPhone PJP-100H Bedienungsanleitung

vissonic

vissonic VLI Series Bedienungsanleitung

Panasonic

Panasonic KX-VC500 Bedienungsanleitung

Poly

Poly Trio 8300 Bedienungsanleitung

Crestron

Crestron Mercury CCS-UCA-SMK Maßzeichnung

Tenveo

Tenveo ALL-IN-ONE Bedienungsanleitung

AXIWI

AXIWI AT-350 Bedienungsanleitung