Cisco Small Business SPA8000 Bedienungsanleitung

FOR MORE INFO VISIT:

CALL US

EMAIL US

intermedia.net

+1.800.379.7729

sales@intermedia.net

Cisco SPA8000 8-Port Telephony Gateway

SIP Trunking Configuration Guide

2| Cisco SPA8000 8-Port Telephony Gateway SIP Trunking Configuration Guide

INTRODUCTION

These Notes describe the procedures for configuring Session Initiation Protocol

(SIP) Trunking between service provider Intermedia.net Inc. (Intermedia) and a

Cisco SPA8000 8 Port Analog Gateway. The Interop was performed with an

Iwatsu ADIX-VS Phone System (Analog PBX) as the analog end point to the

gateway. The Iwatsu ADIX-VS phone system is an analog PBX connecting with

RJ11 to the SPA8000. This Interop is not limited to this analog phone device.

The Intermedia SIP Trunking service referenced within these Notes is designed

for business customers. The service enables local and long distance PSTN

calling via standards-based SIP trunks directly as an alternative to legacy

analog or digital trunks, without the need for additional TDM enterprise

gateways and the associated maintenance costs.

PREREQUISITE FOR CONFIGURING CISCO SPA8000 WITH

INTERMEDIA SIP TRUNKS

Intermedia Configuration Information

You should have the configuration information from Intermedia before you start

the install. This information will provide settings for the SIP connection(s).

The information you will receive from Intermedia will be composed of the

following information. Your order will be different from this information:

Primary codec: G.729

Secondary codec: G.711

SIP TRUNK ID dgwsid10941

PASSWORD ********

DNS NAME usbc.accessline.com

IP ADDRESS 64.28.113.10

PORT 6060

Call processing has been setup to allow up to 2 simultaneous calls.

The following 911 callback number has been configured in our

network as the default for this location; please test and make sure you

are able to present this as the 911 callback number and program it to

route appropriately on inbound.

2065172775

This can also be used for testing inbound calls and has been setup as

the default for outbound CLI. The following additional test number has

also been provisioned.

2065172789

3| Cisco SPA8000 8-Port Telephony Gateway SIP Trunking Configuration Guide

FIREWALL/ROUTER SETUP

Make sure that Ports are forwarded from your router to your internal IP address

of your IP office system.

SIP-based VOIP enabled PBX or SIP phones connected to Intermedia’s Service

via our SIP trunking service MUST be installed in a secure trusted zone behind

a Firewall and not exposed to the public internet. This means the PBX or SIP

phones should never be put into a router's DMZ (allows untrusted access).

The firewall must block all inbound internet (untrusted) traffic to the PBX or SIP

phones. The firewall can be configured to allow inbound traffic from trusted

devices from remote (satellite) locations.

You do not have to block outbound traffic from your private network to the

internet, but Network- Address-Translation, or “NAT” must be enabled. NAT

allows the Intermedia Service to send calls to the PBX or SIP Phones. If the

firewall has multiple NAT settings, you must select the NAT setting that

“Address Restricted” and not “Endpoint Independent”. If you do want to limit

outbound internet traffic on the firewall, then you need to open SIP related ports

on the firewall to allow Intermedia’s Service to function properly.

Protocol

Port(s)

UDP

6060+

UDP

30000 –50000

NOTE: The ports are the default ports that are configured by Linksys 5060,

5061, 5160, 5161, 5260, 5261, 5360, 5361. These defaults ports will work with

Intermedia’s service, unless there is some NAT router that detects 5060 as sip.

In this case then remap to 6060 range.

Basic Configuration Instruction:

Configuration of this device is performed through a web GUI built into system.

You will also use a telephone and SPA-8000's built in IVR to determine the

devices IP address.

1. Connect the equipment to the network and apply power.

2. Determine IP address.

a. Connect phone to port 1.

b. Dial **** to activate the system menu.

c. When the menu system responds, dial 110#. The system will read off

the IP address of the SPA-8000.

3. Connect the laptop to the same network the SPA-8000 is connected to.

4. Open web browser and navigate to the IP address of the SPA-8000.

5. Click on "Admin Login" on the top right hand of the page. This should

change to "User Login".

4| Cisco SPA8000 8-Port Telephony Gateway SIP Trunking Configuration Guide

6. Click on "Advanced" on the top right hand of the page. "Advanced should

turn back and "Basic" should turn blue.

7. Now to configure the SPA-8000 SIP trunk, Select the "Voice" tab on the top

of the screen and select the "T1" tab.

PBX CONFIGURATION AND SETUP

Two separate Intermedia SIP trunks were configured, one for voice with G729,

G711 and one for fax with G711 only. The SPA8000 was configured with 2

voice lines L1, L2 that work with the voice trunk T1. The fax trunk T2 is using

line L4.

SIP TRUNK CONFIGURATION - VOICE

Configure the Voice Trunk T1 with the Intermedia SIP Trunk credentials. Enter

the information as detailed below using your supplied Proxy Address and

username and password from Intermedia. The voice trunk will hunt across lines

1 and 2 in this example, enter hunt rules in the “Contact List” section.

5| Cisco SPA8000 8-Port Telephony Gateway SIP Trunking Configuration Guide

SIP TRUNK CONFIGURATION - FAX

Configure the Fax Trunk T2 with the second set of provided Intermedia SIP

Trunk credentials. Enter the information as detailed above using your supplied

Proxy Address and username and password from Intermedia. The FAX trunk

will use line 4 in this example, enter hunt rules in the “Contact List” section.

6| Cisco SPA8000 8-Port Telephony Gateway SIP Trunking Configuration Guide

7| Cisco SPA8000 8-Port Telephony Gateway SIP Trunking Configuration Guide

VOICE LINE(S) SETUP

Default codec for Intermedia SIP Trunking is G729 Primary with G711

Secondary. For each line in the trunk group configure as follows:

8| Cisco SPA8000 8-Port Telephony Gateway SIP Trunking Configuration Guide

VOICE LINE(S) SETUP (CONT)

9| Cisco SPA8000 8-Port Telephony Gateway SIP Trunking Configuration Guide

VOICE LINE(S) SETUP (CONT)

10 | Cisco SPA8000 8-Port Telephony Gateway SIP Trunking Configuration Guide

VOICE LINE(S) SETUP (CONT)

Andere Handbücher für Small Business SPA8000

Inhaltsverzeichnis

Andere Cisco Tor Handbücher

Cisco

Cisco Linksys WAG54G2 Bedienungsanleitung

Cisco

Cisco EPC2434 Bedienungsanleitung

Cisco

Cisco TELEPRESENCE ISDN GATEWAYS 2.0 Referenzhandbuch

Cisco

Cisco IC3000 Handbuch

Cisco

Cisco AS5350XM Bedienungsanleitung

Cisco

Cisco VG248 - Gateway Bedienungsanleitung

Cisco

Cisco UNIFIED COMMUNICATIONS UC320W Bedienungsanleitung

Cisco

Cisco SPA3000 Bedienungsanleitung

Cisco

Cisco AS5400 Series Bedienungsanleitung

Cisco

Cisco AS5400 Series Bedienungsanleitung

Cisco

Cisco T3 Bedienungsanleitung

Cisco

Cisco D-PCG1000 PowerKEY CAS Bedienungsanleitung

Cisco

Cisco S195 Bedienungsanleitung

Cisco

Cisco 1100 Series Handbuch

Cisco

Cisco 3522 BRI Installations- und Betriebshandbuch

Cisco

Cisco RF 1 Bedienungsanleitung

Cisco

Cisco VG420 Bedienungsanleitung

Cisco

Cisco VG200 Bedienungsanleitung

Cisco

Cisco VG400 series Bedienungsanleitung

Cisco

Cisco ASR 5000 Series Bedienungsanleitung

Cisco

Cisco SIEMENS HICOM 330E Montage- und Bedienungsanleitung

Cisco

Cisco DPC3825 Bedienungsanleitung

Cisco

Cisco SLM224G4PS Kurzanleitung

Cisco

Cisco RFGW-10 Handbuch

Beliebte Tor Handbücher anderer Marken

LST

LST M500RFE-AS Bedienungsanleitung

Kinnex

Kinnex Media Gateway Bedienungsanleitung

2N Telekomunikace

2N Telekomunikace 2N StarGate Bedienungsanleitung

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Bedienungsanleitung

Telsey

Telsey CPVA 500 - SIP Bedienungsanleitung

RTA

RTA 460A-NNA4 Technisches Datenblatt

Shaw

Shaw Gateway HDPVR Bedienungsanleitung

ABB

ABB VSN900 Kurzanleitung

Commander

Commander Pulse Bedienungsanleitung

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Bedienungsanleitung

NETGEAR

NETGEAR C6300BD Bedienungsanleitung

Amit

Amit CDW531AM Bedienungsanleitung

HMS

HMS Netbiter EasyConnect EC150 Bedienungsanleitung

Huawei

Huawei EchoLife HG620 Bedienungsanleitung

AT&T

AT&T U-verse 3801 Gebrauchs- und Pflegehandbuch

Logic IO

Logic IO RTCU MX2 turbo Bedienungsanleitung

Suttle

Suttle MediaMAX MXM-521 Bedienungsanleitung