Cisco 7925G - Unified Wireless IP Phone VoIP Bedienungsanleitung

Americas Headquarters:

Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

Cisco Unified Wireless IP Phone 7925G

Accessory Guide

This guide describes the accessories that you can order for your Cisco Unified Wireless IP Phone 7925G.

Contents

This document contains these sections:

• Cisco Accessories, page 2

• Third-Party Accessories, page 8

• Part Numbers for Cisco Accessories, page 9

• Guidelines for Using Accessories and the Phone, page 10

• Related Documentation, page 10

• Obtaining Documentation and Submitting a Service Request, page 11

• Cisco Product Security Overview, page 11

Cisco Unified Wireless IP Phone 7925G Accessory Guide

OL-16135-02

Cisco Accessories

This section describes the accessories that you can order from Cisco:

• Batteries, page 2

• AC Power Supply, page 2

• Multi-Charger for Phones and Batteries, page 4

• Lock Set for the Phone, page 4

• Carry Cases, page 5

• USB Cable, page 7

Batteries

Batteries for the Cisco Unified Wireless IP Phone 7925G are not included with the phone and must be

ordered separately. See your local representative for more information.

Table 1 describes the battery types. Refer to the Cisco Unified Wireless IP Phone 7925G Phone Guide

for instructions on installing your battery.

Caution Use only batteries that are approved by the Cisco Unified Wireless IP Phone 7925G manufacturer. Use

of unapproved batteries might be dangerous, and will invalidate the warranty on your phone.

Note Using a Bluetooth wireless headset affects battery life and reduces the talk time. In addition, how the

system administrator configures the phone also affects its battery life. For more information, see your

system administrator.

AC Power Supply

The power supply with AC plug adapter shown in Figure 1 enables you to quickly charge your phone

battery. You can use the phone while you are charging the battery.

Ta b l e 1 Battery Types for the Cisco Unified Wireless IP Phone 7925G

Type Technology Talk Time Standby Time Battery Part Numbers

Standard Lithium ion Up to 9.5 hours Up to 180 hours CP-BATT-7925G-STD=

Extended Lithium ion Up to 13 hours Up to 240 hours CP-BATT-7925G-EXT=

Cisco Unified Wireless IP Phone 7925G Accessory Guide

OL-16135-02

Cisco Accessories

Figure 1 AC Power Supply

Table 2 provides approximate battery charging times for the two battery types and power supply

configurations. You can check the battery charging state on the phone display.

Caution Use only Cisco specified AC power supplies for the Cisco Unified Wireless IP Phone 7925G.

187528

1Lift mini-USB port cover at bottom of phone.

2Swing port cover to one side.

3Insert the AC power supply mini-USB connector in the port.

4Insert the AC plug adapter in the slot on the power supply.

5Insert the AC power supply in a wall outlet.

6Indicator light—LED is red while battery is charging and turns green when

battery is charged.

Ta b l e 2 Approximate Battery Charging Times

Battery Type

Power Supply Connected to

Phone

Phone Connected to Computer with USB

Cable

Standard 2 hours 5 hours

Extended 3 hours 7 hours

Cisco Unified Wireless IP Phone 7925G Accessory Guide

OL-16135-02

Cisco Accessories

Multi-Charger for Phones and Batteries

The Cisco Unified Wireless IP Phone 7925 Multi-Charger can charge up to six phones and six batteries

at the same time. See Figure 2.

For more information, see the Cisco Unified Wireless IP Phone 7925G Multi-Charger Installation

Guide.

Figure 2 Cisco Unified Wireless IP Phone 7925G Multi-Charger

Lock Set for the Phone

The lock set includes the cable, the C-ring, and the combination lock.

The security slot can accommodate a lock up to 20 mm. Compatible laptop cable locks include the

Kensington laptop cable lock and other manufacturer’s cable locks that fit into the security slot on the

left side of the desktop charger.

Note Cisco does not supply a laptop cable lock; you must purchase a cable lock from your local electronics

supply source.

To install the lock on the phone, see Figure 3 and follow these steps:

Procedure

Step 1 Put the cable (with loops at each end) around a post or cable that is used to lock your computer.

Step 2 Put the two loops at the ends of the cable in the C-ring.

Step 3 Insert the C-ring in the slot on the back of the phone.

Step 4 Using the combination lock, fasten the two ends of the C-ring together to secure the phone.

Cisco Unfied Wireless IP Phone

7925G Multi-Charger

Cisco Unified Wireless IP Phone 7925G Accessory Guide

OL-16135-02

Cisco Accessories

Figure 3 Lock Set for the Phone

Carry Cases

Carry cases make it easy to keep the Cisco Unified Wireless IP Phone 7925G with you and provide some

protection for the phone. These two types of carry cases are available for the phone:

• Holster Carry Case, page 5

• Leather Carry Case, page 6

Holster Carry Case

The holster carry case is a hard plastic case that holds the phone and has a clip on the back that rotates

180 degrees. See Figure 4. Use the clip to secure the phone to a belt or pocket.

1Security cable—Insert cable loops through the C-ring.

2C-ring—Insert C-ring with cable loops through slot on back of phone.

3Combination lock—Use lock to secure ends of C-ring around cable loops

and phone.

187685

Cisco Unified Wireless IP Phone 7925G Accessory Guide

OL-16135-02

Cisco Accessories

Figure 4 Holster Carry Case

Leather Carry Case

A leather carry case makes it easy to keep the phone with you and provide protection for the phone. See

Figure 5.

Features of the leather carry case include:

• A clear plastic window that allows you to view the screen and provides easy access to the keys and

buttons.

• Openings for the microphone, headset port, and mini-USB port allow you to use and charge the

phone without removing the leather carry case.

• A removable belt clip on the back that rotates 360 degrees.

• A security cord with a ring on one end that slides onto the D-ring on the back of the carry case. You

can fasten the other end of the cord to a belt loop to secure the phone.

Note After you insert the phone in the leather carry case, you may need to adjust the alignment so the

microphone (at bottom of phone) is not covered. See Figure 6.

Cisco Unified Wireless IP Phone 7925G Accessory Guide

OL-16135-02

Cisco Accessories

Figure 5 Leather Carry Case with Phone

Figure 6 Leather Case Opening for Microphone and Mini-USB Port

USB Cable

You can use a standard USB cable to connect your Cisco Unified Wireless IP Phone 7925G to a computer

to configure a new phone for the first time or to charge the phone battery. See Figure 7.

1Microphone 2Mini-USB port with cover

273092

Cisco Unified Wireless IP Phone 7925G Accessory Guide

OL-16135-02

Third-Party Accessories

Figure 7 USB Cable Connecting the Phone to a PC

Third-Party Accessories

Accessories such as chargers for the phone and batteries, and cover cases for the Cisco Unified Wireless

IP Phone 7925G are available from third parties.

For more information, go to this URL: www.zcover.com

Note Third-party accessories are not tested by Cisco. It is recommended that you test them in your

environment before providing them to users.

Headsets

The Cisco Unified Wireless IP Phone 7925G supports the use of third-party wired and Bluetooth wireless

headsets.

For wired headsets, the phone requires a 2.5 mm, 3-band / 4 conductor plug headset or ear bud.

Wireless Bluetooth Headsets

Using Bluetooth wireless headsets increases battery power consumption on your phone and results in

reducing talk time for the battery.

1Mini-USB connector for the phone.

2Standard USB connector for the PC.

3Indicator light—LED is red while battery is charging and

turns green when battery is charged.

187639

Cisco Unified Wireless IP Phone 7925G Accessory Guide

OL-16135-02

Part Numbers for Cisco Accessories

For a Bluetooth wireless headset to work, it does not need to be within direct line-of-sight of the phone,

but some barriers, such as walls or doors, and interference from other electronic devices, could affect the

connection.

Obtaining Headsets

The audio portion of a headset must sound good to the user and to the party on the far end. Sound is

subjective and Cisco cannot guarantee the performance of any headsets, but some of the headsets on the

sites listed below have been reported to perform well on Cisco Unified Wireless IP Phones.

For information about headsets, go to the following URLs:

http://www.plantronics.com

http://www.jabra.com

http://www.jawbone.com

Note It is recommended that you test your headsets in your own environment to determine suitable

performance.

Part Numbers for Cisco Accessories

Table 3 lists all accessories that you can order from Cisco and their part numbers.

To purchase these accessories, contact your local dealer or corporate representative.

Ta b l e 3 Cisco Unified Wireless IP Phone Accessories

Phone Accessories Part Number

Standard battery CP-BATT-7925G-STD=

Extended battery CP-BATT-7925G-EXT=

Holster carry case CP-HOLSTER-7925G=

Leather carry case CP-CASE-7925G=

USB cable for phone CP-CAB-USB-7925G=

Phone lock set CP-LOCK-7921G=

Phone power supply for Australia and New

Zealand

CP-PWR-7925G-AU=

Phone power supply for Central Europe CP-PWR-7925G-CE=

Phone power supply for China CP-PWR-7925G-CN=

Phone power supply for Argentina CP-PWR-7925G-AR=

Phone power supply for Japan CP-PWR-7925G-JP=

Phone power supply for North America CP-PWR-7925G-NA=

Phone power supply for United Kingdom CP-PWR-7925G-UK=

Multi-Charger bundle (includes multi-charger,

power supply, and AC power cord)

CP-MCHGR-7925G-BUN

Multi-Charger, spare (no power supply) CP-MCHGR-7925G=

Cisco Unified Wireless IP Phone 7925G Accessory Guide

OL-16135-02

Guidelines for Using Accessories and the Phone

Follow these guidelines when using accessories and your Cisco Unified Wireless IP Phone 7925G:

• Use only chargers, batteries, and accessories that are approved by the Cisco Unified Wireless IP

Phone 7925G manufacturer. Use of unapproved chargers, batteries, and accessories might be

dangerous, and will invalidate the warranty on your phone.

• Do not adhere a clip to the back of the phone or insert a clip between the phone and battery cover

because it can damage the battery.

• When disconnecting the power cord of any accessory, grasp and pull the plug. Do not pull the cord.

• Keep accessories out of reach of young children.

• Clean the phone with a soft dry cloth or a moist wipe.

• The phone is resistant to dust and spills, but you can further protect your phone with a cover case.

Beliebte IP-Telefon Handbücher anderer Marken

Alcatel

Alcatel 4028 Bedienungsanleitung

Polycom

Polycom Polycom VVX 600 Bedienungsanleitung

Polycom

Polycom SoundPoint IP 450 Bedienungsanleitung

Polycom

Polycom SoundPoint IP 650 Bedienungsanleitung

Proximus

Proximus Maestro 3016 IP Bedienungsanleitung

Fanvil

Fanvil X4 Bedienungsanleitung

Snom

Snom 320 Bedienungsanleitung

Yealink

Yealink Yealink SIP-T46G Bedienungsanleitung

Avaya

Avaya 4625SW Bedienungsanleitung

Yealink

Yealink SIP-T52S Bedienungsanleitung

Nortel

Nortel 1140E Bedienungsanleitung

Nexotek

Nexotek NT-P500 Bedienungsanleitung

Avaya

Avaya Integral 5 R3.0 Bedienungsanleitung

GE 28320EE2 - Dect 6.0 InfoLink 2 Bedienungsanleitung

Avaya

Avaya 4600 Series Service-Handbuch

Mitel

Mitel MIVOICE OFFICE 400 6940 SIP Bedienungsanleitung

Nortel

Nortel i2050 Bedienungsanleitung

Fiberme

Fiberme FAP260 Series Bedienungsanleitung