Cisco ME 3400E Bedienungsanleitung
QUICK START GUIDE
Cisco ME 3400E Ethernet Access Switch Power-Supply Modules
This document provides the high-level steps for installing the AC and the DC power-supply modules for
the Cisco ME 3400E-24TS-M and the Cisco ME 3400EG-12CS-M switches. For the complete installation
instructions, see the Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide at this URL:
http://www.cisco.com/en/US/docs/switches/metro/me3400e/hardware/installation/guide/me3400e_hig.ht
ml
For a complete list of the safety warnings in the required languages, see the Regulatory Compliance and
Safety Information for the Cisco ME 3400E Switch on the Documentation CD.
Observe these warnings when you install and power-on the power-supply module:
Warning
Do not reach into a vacant slot or chassis while you install or remove a module or a fan.
Exposed circuitry could constitute an energy hazard.
Statement 206
Warning
Do not work on the system or connect or disconnect cables during periods of lightning
activity.
Statement 1001
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this
equipment.
Statement 1030
For DC power-supply modules, observe these warnings:
Warning
An exposed wire lead from a DC-input power source can conduct harmful levels of
electricity. Be sure that no exposed portion of the DC-input power source wire extends from
the terminal block plug.
Statement 122
2
Warning
Before connecting or disconnecting ground or power wires to the chassis, ensure that power is removed from the
DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that services the DC
circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the circuit breaker in the OFF
position. Use a voltmeter to test for 0 (zero) voltage at the power terminals on the chassis.
Statement 196
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: 5 A.
Statement 1005
Warning
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring.
Statement 1022
For all power-supply modules, review these caution statements:
Caution To prevent overheating and to maintain proper air flow, either an AC or a DC power-supply module or a module
blank should be installed in both power-supply module slots at all times.
Note Before you install the AC or DC power-supply module, turn off the power supply at its source.
The power-supply module slots are on the switch rear panel, and the power connectors are on the front panel.
Install the AC Power-Supply Module
Step 1 Insert the power-supply module in the slot
on the switch rear panel, and align and
tighten the retainer screws.
Step 2 Connect the AC power cord to the
AC power input. Secure with the retainer
clip and the bushing.
Step 3 Turn on power, and verify that the
AC power-supply LED on the switch front
panel is green.
250447
PSU OK
AC
250448
250449
3
Install the DC Power-Supply Module
Step 1 Attach the ground lug to a ground wire
(connected to a ground connection), and
attach the ground lug to the switch rear
panel.
Step 2 Insert the power-supply module in the
rear-panel slot, and align and tighten the
retainer screws.
Step 3 Set the DC voltage selector on the
power-supply module:
•Telecom: –48 VDC
•Industrial: +24 VDC
Step 4 Use 16-gauge copper wire to connect the
DC input power source and connect it to
the DC power connector on the switch
front panel.
Step 5 Turn on the power.
Step 6 On the switch front panel, verify that the
DC power-supply LED is green for that
module.
Step 7 If installing only one power supply, enter
this command to suppress alerts:
If installing two, no commands are needed.
switch# no power-supply dual dc-feed
switch# end
250451
250450
PSU OK +24V -48V
DC
250452
PSU OK +24V -48V
250453
250454
Americas Headquarters
Cisco Systems, Inc.
San Jose, CA
Asia Pacific Headquarters
Cisco Systems (USA) Pte. Ltd.
Singapore
Europe Headquarters
Cisco Systems International BV
Amsterdam, The Netherlands
Cisco has more than 200 offices worldwide. Addresses, phone numbers, and fax numbers are listed on the
Cisco Website at www.cisco.com/go/offices.
Printed in China PRC
© 2008 Cisco Systems, Inc. All rights reserved.
78-18646-01
CCDE, CCENT, Cisco Eos, Cisco Lumin, Cisco Nexus, Cisco StadiumVision, Cisco TelePresence, Cisco WebEx, the Cisco logo, DCE, and Welcome to the Human Network
are trademarks; Changing the Way We Work, Live, Play, and Learn and Cisco Store are service marks; and Access Registrar, Aironet, AsyncOS, Bringing the Meeting To
You, Catalyst, CCDA, CCDP, CCIE, CCIP, CCNA, CCNP, CCSP, CCVP, Cisco, the Cisco Certified Internetwork Expert logo, Cisco IOS, Cisco Press, Cisco Systems,
Cisco Systems Capital, the Cisco Systems logo, Cisco Unity, Collaboration Without Limitation, EtherFast, EtherSwitch, Event Center, Fast Step, Follow Me Browsing,
FormShare, GigaDrive, HomeLink, Internet Quotient, IOS, iPhone, iQuick Study, IronPort, the IronPort logo, LightStream, Linksys, MediaTone, MeetingPlace, MeetingPlace
Chime Sound, MGX, Networkers, Networking Academy, Network Registrar, PCNow, PIX, PowerPanels, ProConnect, ScriptShare, SenderBase, SMARTnet, Spectrum
Expert, StackWise, The Fastest Way to Increase Your Internet Quotient, TransPath, WebEx, and the WebEx logo are registered trademarks of Cisco Systems, Inc. and/or its
affiliates in the United States and certain other countries.
All other trademarks mentioned in this document or website are the property of their respective owners. The use of the word partner does not imply a partnership relationship
between Cisco and any other company. (0809R)
Andere Handbücher für ME 3400E
3
Inhaltsverzeichnis
Andere Cisco Schalten Handbücher
Cisco
Cisco PFC4 Installations- und Betriebshandbuch
Cisco
Cisco Catalyst 3750E-48PD-F Bedienungsanleitung
Cisco
Cisco SR216 Bedienungsanleitung
Cisco
Cisco Catalyst 4500 Series Installations- und Betriebshandbuch
Cisco
Cisco SG 300-10 Bedienungsanleitung
Cisco
Cisco CDB-8U Bedienungsanleitung
Cisco
Cisco 3750 - Catalyst EMI Switch Handbuch
Cisco
Cisco Catalyst 9500 Series Bedienungsanleitung
Cisco
Cisco Catalyst 3850 Kurzanleitung
Cisco
Cisco Nexus 9508 NX-OS Handbuch
Cisco
Cisco SLM2008PT-NA Bedienungsanleitung
Cisco
Cisco SLM2008 - Small Business Smart Switch Bedienungsanleitung
Cisco
Cisco Catalyst 2900 Series XL Installationsanleitung
Cisco
Cisco Cisco Small Business Unmanaged Switch SD2008 Bedienungsanleitung
Cisco
Cisco WS-C6506 Kurzanleitung
Cisco
Cisco EZXS55W - EtherFast 10/100 Workgroup Switch Bedienungsanleitung
Cisco
Cisco 6503 - Catalyst Firewall Security Sys Kurzanleitung
Cisco
Cisco NMH Series Bedienungsanleitung
Cisco
Cisco 4503 - Catalyst Switch Administratorhandbuch
Cisco
Cisco uBR-3x10 Bedienungsanleitung
