Citronic PL2000 Bedienungsanleitung
PL2000
1U STEREO POWER AMPLIFIER
Order ref: 172.114UK
User Manual
Version 1.1
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
172.114UK User Manual
Introduction
Thank you for choosing the Citronic PL2000 class-D power amplifier as part of your sound reinforcement
system. These high output amplifiers are designed to offer high quality, dependable service for mobile and
installed systems. Please read this manual fully and follow the instructions to achieve the best results with your
new purchase and to avoid damage through misuse.
Warning
To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
If liquids are spilled on the casing, stop using immediately, allow unit to dry out and have checked by qualified
personnel before further use. Avoid impact, extreme pressure or heavy vibration to the case
No user serviceable parts inside –Do not open the case –refer all servicing to qualified service personnel.
Safety
•Check for correct mains voltage and condition of IEC lead before connecting to power outlet
•Ensure speaker leads are good condition with no short connections or damaged plugs
•Check impedance of speaker loads do not exceed the minimum stated load for the amplifier
•Do not allow any foreign objects to enter the case or through the ventilation grilles
Placement
•Keep out of direct sunlight and away from heat sources, damp or dusty environments
•When rack-mounting, ensure adequate support for the base of the amplifier and firm fixings for the front
•Ensure adequate air-flow and do not cover cooling vents at the front and rear of the amplifier
•Ensure adequate access to controls and connections
Cleaning
•Use a soft cloth with a neutral detergent to clean the casing as required
•Use a vacuum cleaner to clear ventilation grilles of any dust or debris build-ups
•Do not use strong solvents for cleaning the unit
Front Panel
1. Power on/off switch
2. Cooling vent
3. Channel A gain control
4. LED indicators
5. Channel B gain control
Rear Panel
6. Channel B input
7. Channel A input
8. Channel B SPK output
9. Channel A SPK output
10. Cooling fan vents
11. IEC mains power inlet & fuse
172.114UK User Manual
Setup
Connect the supplied power lead to the rear IEC inlet of the PL-series amplifier (11) and plug the other end into
a mains power socket, ensuring the correct voltage at the outlet.
Ensure that the cooling vents at front and rear (10) are not covered or obstructed in any way with adequate
space for airflow through the unit.
Operation
With CH A and CH B volume controls (3, 5) turned fully down (anti-clockwise), switch on the power (1) and the
LED POWER indicator will light (4)
Playing the input signal into CH A and CH B inputs (6, 7), gradually increase the CH A and CH B volume
controls. The amplified signal should be heard through the speakers and the SIG indicators (4) should respond
to the audio output. Increase the volume controls to the required level.
Alongside the SIG indicators are CLIP indicators, which should only light very briefly on the loudest transients or
spikes in the audio. If the CLIP LEDs light for more than a fraction of a second at a time, the volume controls
should be turned down or input signal will need to be reduced.
Before powering down, turn down the volume controls to avoid loud pops or noises through the speakers.
Specifications
Power supply
230Vac 50Hz (IEC)
Fuse
T15AL 250V
Power RMS @ 8Ω
2 x 540W
Power RMS @ 4Ω
2 x 1000W
Input connections
Combo jack/XLR balanced (L+R)
Output connections
SPK (L+R) pin 1+/1-
Frequency response
20Hz - 20kHz (±0.5dB)
THD +N
<0.05%
Damping factor
300
S/N ratio (A weighted) : line
100dB
Slew rate
20V/us
Input impedance
10k Ohms unbalanced, 20k Ohms balanced
Output circuit architecture
Class D
Protection
Temperature, short circuit, DC, overload
Indicators
Power, signal, clip
Controls
L+R level, power on/off
Dimensions
482 x 180 x 44mm
Weight
4.0kg
Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste
at the end of its useful life. The goods must be disposed of according to your local council guidelines.
Errors and omissions excepted. Copyright© 2021.
AVSL Group Ltd. Unit 2-4 Bridgewater Park, Taylor Rd. Manchester. M41 7JQ
AVSL (EUROPE) Ltd, Unit 3D North Point House, North Point Business Park, New Mallow Road, Cork, Ireland.
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Citronic Verstärker Handbücher
Citronic
Citronic QP1600 Bedienungsanleitung
Citronic
Citronic CX-1608 Bedienungsanleitung
Citronic
Citronic PPX900 Bedienungsanleitung
Citronic
Citronic P44800 Bedienungsanleitung
Citronic
Citronic CX-8088 170.353 Bedienungsanleitung
Citronic
Citronic PLX SERIES Bedienungsanleitung
Citronic
Citronic PL720 Bedienungsanleitung
Citronic
Citronic PL Series Bedienungsanleitung
Citronic
Citronic H Series Bedienungsanleitung
Citronic
Citronic D Series Bedienungsanleitung
Citronic
Citronic AEL Series Bedienungsanleitung
Citronic
Citronic D1000 Bedienungsanleitung
Citronic
Citronic CX-8086 Bedienungsanleitung
Citronic
Citronic Ultima PRO-3200 Bedienungsanleitung
Citronic
Citronic PPX Series Bedienungsanleitung
Citronic
Citronic Pro Ultima Series Bedienungsanleitung
Citronic
Citronic Powerlite PL3200 Bedienungsanleitung
Citronic
Citronic SP200 Bedienungsanleitung
Citronic
Citronic PLX2000 Bedienungsanleitung
Citronic
Citronic 172.248UK Bedienungsanleitung
