The CS-PIN-10 is a simple arming station that allows
local control of the security system. It is battery
powered and requires no installation tools. Many
can be installed throughout the home to provide
convenient system control.
Features
• Secure 4 to 10 digit disarming
• Supports 1-button arming
• Small yet comfortable
Enroll by placing the panel into wireless enrollment
mode and then sending an enrollment signal from the
PINPad. Alternatively, the PINPad can be enrolled by
scanning its bar code using the install Assist App.
Option for sending an Enrollment Signal
• Press 1and 3buttons simultaneously
Install using the 3M VHB® tape on the back of the
PINPad to adhere it to a wall.
• See Pro Tips for recommendations about using
3M VHB tape.
• Two #4 or #6 screws may be used instead of,
or in addition to, the 3M VHB tape.
• The mounting plate can also be rotated 180°
for table top use (See Pro Tips).
Operate using the PINPad buttons. The PINPad LED
will blink when a button is activated.
Disarm by entering a valid 4-10 digit user code on
the number pad.
Arm Away by pressing the AWAY button until the
PINPad LED ashes red.
Arm Stay by pressing the STAY button until the
PINPad LED ashes red.
Trigger a panic alarm by pressing the STAY &
AWAY buttons together until the Red PINPad LED
ashes repeatedly.
Use the panel installation guide to verify proper system setup.
Enrollment Buttons
Arm Stay Arm Away
LED
Mounting Screw Holes
VHB Tape
VHB Tape
I
N
S
T
A
L
L
G
U
I
D
E
CS-PIN-10
Wireless Pinpad
