Clarke CIS788 Bedienungsanleitung

ASSEMBLY INSTRUCTIONS

ORIGINAL INSTRUCTIONS

INSTANT GARAGE

MODEL NO: CIS788

PART NO: 3503582

GC0918

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkein ternational.com or [email protected]

INTRODUCTION

Thank you for purchasing this CLARKE Instant Garage. When erected, the

CIS788 garage will be of the dimensions show below. Weight is 34 kg

packed (32 kg unpacked).

Before attempting to use this product, please read this manual thoroughly and

follow the instructions carefully. In doing so you will ensure the safety of yourself

and that of others around you, and you can look forward to your purchase

giving you long and satisfactory service.

SAFETY INSTRUCTIONS

This garage is a temporary structure and is not recommended as a permanent

building.

Choose your garages location carefully. Check for overhead utility lines,

branches, etc. DO NOT install near roofs or other structures that may shed snow,

ice or excessive run-off onto your garage. Keep away from power cables.

WARNING: READ ALL SAFETY INSTRUCTIONS TO REDUCE THE RISK OF

INJURY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

2.4m

2.1m

1.63m

5'5"

1.65m

5'6"

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or [email protected]

Erect your garage on a level surface.

Have an overview of all parts before attempting installation. Make sure all

components are available.

DO NOT use this product in environments for which it is not Intended (i.e.

extreme cold, high winds, extreme heat, heavy rainfall, etc).

Always wear safety glasses when assembling this product. Wear gloves when

working with tubing to prevent cuts or abrasions.

Proper anchoring and keeping the cover tight and free of snow and debris is

the responsibility of the user.

Damage caused by improper anchoring are not covered under warranty.

Keep all flame and heat sources away from the garage fabric. The fabric will

burn if left in continuous contact with a naked flame.

DO NOT use open flames or cooking or heating devices inside or in close

proximity to the garage, including all types of stoves, gas heaters, gas lanterns,

torches, fly killers, etc.

In order to reduce risk of burning and avoid damage, DO NOT- cook, smoke,

refuel or use any open flame devices in or around the garage.

DO NOT store flammable liquids (petrol, kerosene, propane, etc.) in the

garage, operate gas powered vehicles/equipment in or around the garage.

Keep open flames a safe distance away from the garage.

DO NOT use hard-edged tools or instruments, such as rakes or shovels, to

remove snow. These can cause punctures to the cover.

NEVER start the engine of any vehicle or machine inside a closed garage.

Ensure that there is adequate ventilation for engines and for any work with

paints, cleaners. etc.

This garage is NOT designed to support heavy snow, Snow or ice

accumulation may cause your garage to collapse. To avoid overload, brush

snow and ice off the roof top with a broom or mop.

To prevent collapse, damage to property or personal injury, NEVER clear the

roof of snow or debris from inside the garage.

DO NOT use bleach, alkaline or harsh detergents for cleaning. Doing so will

damage the material. Soap and warm water are recommended.

This temporary garage is designed to offer protection from damage caused

by the sun, light rain, light snow, tree sap and bird droppings. It is not designed

to shelter equipment from high winds, heavy rain or snow.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or [email protected]

COMPONENT PARTS LIST

No Description Illustration Qty

1Upright Pole with Dimples 6

2Corner Extension Tube 4

3Bent Corner Leg 4

4Shoulder Cross Rail 6

5Rafter Pole 6

6Bottom Cross Rail 4

7Center Extension Tube 2

83-Way Side Connector - Left 2

93-Way Side Connector - Right 2

10 4-Way Side Connector 2

11 3-Way Peak Connector 2

12 4-Way Peak Connector 1

13 4-Way Cross Rail Clamp 4

14 3-Way Cross Rail Clamp 8

15 Ratchet Tie Down 8

16 M6x45 Bolt 8

17 M6 Nut 8

18 M6 Washer 8

19 Roof Tarp 1

20 Front Door Panel (with zipper) 1

21 Back Panel 1

22 Anchor 4

23 Cable (1' / 30 cm) 4

24 Cable Clamp 4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or [email protected]

ASSEMBLY

1. Place all parts from the packaging in a clear area and arrange them on

the ground in front of you.

2. Remove all packaging materials and place them back in the box. Do not

dispose of the packaging materials until assembly is complete.

3. Check for completeness and for any transport damage.

Diagram A

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or [email protected]

STEP 1: PREPARING THE ROOF PARTS

Select a suitable location for the garage. The layout of the roof parts is shown in

Diagram B.

Note the differences between

the connectors shown in

Diagram C. (connectors are

also individually numbered).

Note: When installed, the

welded socket for the cross rail

must be below the bend.

Parts #8, #9 & #10are side

(shoulder) connectors.

Parts #11 & #12 are top (apex)

connectors.

Diagram B 9511 8

10 10

4 4 4

444

11 12

Diagram C

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkein ternational.com or [email protected]

STEP 2: ASSEMBLING THE ROOF

Diagram D 11 12 11

Attach the shoulder cross rails (4) to the 3-way side connectors (8, 9) and

4-way side connectors (10). Insert the connectors (8, 9, 10) into the rafter

poles (5) to complete the assembly of the roof (Diagram D).

NOTE:

●Be sure that all tubes are fully inserted. Use a rubber

mallet if necessary.

●When using the connectors, be sure to remove the

protective caps ﬁrst.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or [email protected]

STEP 3: ATTACHING THE LEGS

There are 6 legs for the whole shelter.

1. Follow Diagram E. Connect the tubes #1,2 & #3 to create the 4 corner

legs.

2. Connect tubes #1 & #7 to create the 2 center legs.

3. Insert the centre legs and corner legs into the side connectors as in

Diagram E.

4. Repeat to assemble the other side as shown in Diagram E.

Diagram E

1 1

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or [email protected]

STEP 4: SQUARE AND ANCHOR THE FRAMES

1. Check that the width measurements of the frame are 8' at both the front

and back corners, as well as across the center.

2. Take a diagonal measurement as shown in Diagram F. When these two

measures are equal the frame is square. Adjust the frame until they are

equal to within 1".

3. Once equal, check the width measurement again to ensure all widths are

equal at 8'.

4. Next, install the anchors

(Parts #22, #23 & #24) at the

4 corner legs by screwing

the removable anchor

(#22) into the ground on

the inside of the structure.

5. Secure with cable (#23)

and cable clamp (#24) (as

shown in Diagram G).

Diagram F

Diagram G

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or [email protected]

STEP 5: INSTALLING THE FRONT AND BACK COVERS

The front cover has a zippered door to allow entry to the garage. Be sure to

locate this cover at the desired end and ensure the zipper is in the closed

position while installing.

The back cover is a solid piece of fabric.

The covers are installed in the same fashion.

1. Thread the strap through the spindle of the ratchet to make sure the strap

will stay in the sleeve when assembled, Raise and lower the handle two or

three times to wind the strap onto the spindle (as shown in Diagram I1&I2).

2. Begin with the front cover and first locate the webbed strap that runs

around the perimeter at the cover.

The webbing is exposed at the peak, the shoulders and the feet of

the cover.

Diagram H

Diagram I

I 1 I 2

Andere Handbücher für CIS788

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Clarke Zelt Handbücher

Clarke

Clarke CIG1432 Bedienungsanleitung

Clarke

Clarke CIS 1212 Bedienungsanleitung

Clarke

Clarke 3503500 Bedienungsanleitung

Clarke

Clarke CIG81020 Bedienungsanleitung

Clarke

Clarke CIS8612 Bedienungsanleitung

Clarke

Clarke CIG81015 Bedienungsanleitung

Clarke

Clarke J45618 Bedienungsanleitung

Clarke

Clarke CIG1640 Bedienungsanleitung

Clarke

Clarke 3503578 Bedienungsanleitung

Clarke

Clarke CIS81212 Bedienungsanleitung

Clarke

Clarke CIS 612 Bedienungsanleitung

Clarke

Clarke CIG81020 Bedienungsanleitung

Clarke

Clarke CC15 Bedienungsanleitung

Clarke

Clarke GC0422 Bedienungsanleitung

Clarke

Clarke CIG81220 Bedienungsanleitung

Clarke

Clarke CIG81212 Bedienungsanleitung

Clarke

Clarke PUC 88 Bedienungsanleitung

Clarke

Clarke CIG91015 Bedienungsanleitung

Clarke

Clarke CIS 88 3503506 Bedienungsanleitung

Clarke

Clarke CIG 1220 Bedienungsanleitung

Clarke

Clarke CC10 Bedienungsanleitung

Clarke

Clarke CIS8612 Bedienungsanleitung

Clarke

Clarke CIG81216 Bedienungsanleitung

Clarke

Clarke CIG81224 Bedienungsanleitung

Beliebte Zelt Handbücher anderer Marken

OZTENT

OZTENT JV SIGNATURE EDITION Bedienungsanleitung

GigaTent

GigaTent Summer Chalet Mini Tent Bedienungsanleitung

ShelterLogic

ShelterLogic 107153 Bedienungsanleitung

Outsunny

Outsunny 84C-230 Bedienungsanleitung

Napier

Napier SPORTZ COVE 61 Series Bedienungsanleitung

EuroTrail

EuroTrail ATLANTIS PRO Bedienungsanleitung

Reimo

Reimo Marina Bedienungsanleitung

TiiTENT

TiiTENT TB300 Bedienungsanleitung

Coleman

Coleman 2000033134 Installationsanleitung

Ozark Trail

Ozark Trail W784.1 Kurzanleitung

SlingFin

SlingFin CrossBow 2 Bedienungsanleitung

Coleman

Coleman 9600-141 Bedienungsanleitung

Palram

Palram Arizona 5000 Wave - WINGS Bedienungsanleitung

COVERPRO

COVERPRO 56184 Montageanleitung

Vango

Vango Zenith 100 Bedienungsanleitung

Costway

Costway PATIOJOY OP70818 Bedienungsanleitung

Coleman

Coleman MONTANA 14'x7' Bedienungsanleitung

Crivit Outdoor

Crivit Outdoor 96716 Bedienungsanleitung