Clevertronics Trade Series Handbuch

1942573

V1.1

5 July 2023

Instruction Sheet Template - V1.3 –Updated 20/01/2022

THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK

Trade Series Weatherproof Supalite

Installation & Maintenance Instruction Leaflet

Victoria (Head Office & Manufacturing)

Website: www.clevertronics.com.au

Email: info@clevertronics.com.au

Phone: +61 3 9559 2700

Fax: +61 3 9559 2799

New South Wales

Phone: +61 2 8805 6400

Fax: +61 2 8805 6444

Queensland

Phone: +61 7 3442 9700

Fax: +61 7 3442 9777

South Australia/Northern Territory

Phone: +61 8 8301 8800

Fax: +61 8 8351 8286

Western Australia

Phone: +61 8 9207 0000

Fax: +61 8 9207 0088

New Zealand

Phone: +64 800 548 448

Designed in Australia to comply with the requirements of

AS2293.3: 2018, AS CISPR15: 2017

Models:

EWFLED

Spare Parts:

1560156

Replacement Battery

1100550

Replacement LED Head

8002976

Replacement EM Driver

Important:

It is illegal for anyone, except for a licensed electrician to install or maintain this product. Before installation,

ensure that the electricity supply has been switched off and isolated. Installation must be carried out in

accordance with the relevant Australian and International Standards.

This luminaire (with reinforced insulation between control/LED terminal and AC Supply) contains non-

user replaceable light source –to be replaced (if required) by the manufacturer or his service agent or a

similar qualified person.

1942573

V1.1

5 July 2023

Instruction Sheet Template - V1.3 –Updated 20/01/2022

Installation:

The Weatherproof Supalite (EWFLED) is Wall Mounted Product. The enclosure base of the EWFLED is

attached to the wall using screws installed through the four mounting points that are located outside of the

IP area. Please follow the steps below to install the Weatherproof Flood Light:

•Remove the enclosure cover.

•Determine power entry.

•Drill power access hole in the box base. This can be from side of back.

•Position the box base in the mounting position.

•Mark the 4 holes for mounting. Install the base using appropriate fixings (not supplied).

•Connect the 240VAC supply to the terminal blocks

•If the cable entry is within the IP area, make sure to use an appropriate Cable gland or seal the

hole using non corrosive sealant.

•Connect the battery to the driver PCA.

•Reinstall the enclosure cover.

•Adjust the LED heads into position. Two screws are provided for each head to move them into

position. The front screw adjusts the L/R position (roll) and the side screw adjusts the U/D (tilt)

position.

•This luminaire contains non-user replaceable light source and battery.

Dimensions:

Testing:

When the EWFLED is connected to the un-switched active, it must be allowed to charge the battery for

at least 24 hours. The emergency lamp only illuminates during a power fail. Conduct the following tests:

•The emergency lamp must illuminate for at least 2 hours after disconnection from the mains. The

results of all tests are required to be recorded in a service logbook, which is to be kept on-site at all

times. If the unit fails to illuminate for the requisite time, remedial action must be taken to repair the

situation and once completed, the unit must pass a subsequent test.

•Press and hold Test Button or switch Off Mains Supply, check that the emergency lamp is On.

•Release the Test Button or Switch On Mains Supply, check that the emergency lamp is Off (Non-

maintained operation).

Trouble Shooting:

Below are a list of common problems and their possible causes.

Fault: The Green LED Test Switch indicator is not illuminated.

Check: A.C. is connected and is turned on.

Battery is connected

Test Switch for damage.

Fault: Lamp does not illuminate in emergency mode.

Check: A.C. is connected.

Lamp is correctly inserted.

Battery is connected

Fault: Lamp illuminates in emergency mode, but only stays on for a short period.

Check: Battery has been allowed to charge for at least 24 hours.

Battery for damage.

Fault: Green LED flashes once every 5 seconds-Battery is disconnected

Check: Battery is connected

Fault: Green LED blinks off once every 5 seconds-Charging very flat battery

Check: Allow 20min to recover battery then re-check

Fault: Green LED flashes at 2Hz (Fast Flash)-Faulty Battery

Check: Replace battery

Caution:

On many building sites, power circuits may be cut off in an uncontrolled and repetitive basis during

construction. As a result, any Exit & Emergency Units, on these circuits, will have their batteries

discharged or “cycled”. The battery in this fitting has been selected to give excellent long-life

performance in a controlled AS2293 testing environment. Excessive battery cycling will reduce through-

life performance and may lead to premature battery failure. Battery warranty claims, as a result of such

abuse, are specifically EXCLUDED from Clevertronics warranty terms.

Warranty:

For Product Warranty information and Terms and Conditions of Sales please refer to our website

http://clevertronics.com.au/terms-conditions-sale-australia-nz/

Dieses Handbuch passt für folgende Modelle

Andere Clevertronics Beleuchtungsausrüstung Handbücher

Clevertronics

Clevertronics L10 Weatherproof Jumbo LED Exit Montage- und Bedienungsanleitung

Clevertronics

Clevertronics L10 LSBLED Series Montage- und Bedienungsanleitung

Clevertronics

Clevertronics GLIDER-SM Montage- und Bedienungsanleitung

Clevertronics

Clevertronics ARGOPRO-1200 Series Bedienungsanleitung

Clevertronics

Clevertronics CleverEVAC LP Cleverfit Pro DYRC CP Series Montage- und Bedienungsanleitung

Clevertronics

Clevertronics CleverEVAC L10 Cleverfit Pro DYRL CP Series Montage- und Bedienungsanleitung

Clevertronics

Clevertronics LP Cleverfit Pro CCFPRO Series Montage- und Bedienungsanleitung

Clevertronics

Clevertronics L10 LUBPRO Series Montage- und Bedienungsanleitung

Clevertronics

Clevertronics FBS2LED-DIF Series Bedienungsanleitung

Clevertronics

Clevertronics L10 LBLLED-REC-WM Series Bedienungsanleitung

Clevertronics

Clevertronics L10 Cleverfit Pro Montage- und Bedienungsanleitung

Clevertronics

Clevertronics L10 Cleverfit LCFLED Series Montage- und Bedienungsanleitung

Clevertronics

Clevertronics L10 Ultrablade Pro LUBPRO-SM Series Bedienungsanleitung

Clevertronics

Clevertronics CLP LIFELIGHT Pro Bedienungsanleitung

Clevertronics

Clevertronics CBULKy Series Montage- und Bedienungsanleitung

Clevertronics

Clevertronics L10 LWPLIFE PRO Series Montage- und Bedienungsanleitung

Clevertronics

Clevertronics L10 LVP2LEDM-P Series Montage- und Bedienungsanleitung

Clevertronics

Clevertronics L10 LIFELIGHT PRO LLIFE-PRO SPOT Series Montage- und Bedienungsanleitung

Clevertronics

Clevertronics L10 CleverFit Exit LCFLED Series Bedienungsanleitung

Clevertronics

Clevertronics L10 LWFLED 2IPREM Series Bedienungsanleitung

Clevertronics

Clevertronics ARGO-1200 EM Series Technische Daten

Clevertronics

Clevertronics LP CUBPRO Series Bedienungsanleitung

Clevertronics

Clevertronics L10 LIFELIGHT PRO LLIFE PRO Series Bedienungsanleitung

Clevertronics

Clevertronics LP CCIRC Series Bedienungs- und Wartungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung