climote Website Test (10)
An administrator may already have
pre-loaded your target device, in which
case it will already be displayed.
Select “View” to access
If the device is not displayed, enter
the Serial Number and Device
Mobile Number and press “Add”.
The device will be added to your
device list
climote Website Test (11)
1 . Carry out standard checks
Carry out basic “Command” checks
using “Boost” and “Report”
Observe Boost is shown on the device
Check Zone settings reflect what you
set on the device. Adjust status and
rename zones if required.
“Other settings” grants temporary
access to the user’s climote web site,
but only until the user has registered
Be sure to “Save” changes on this page. They
will then be communicated to the device
At this stage the unit is commissioned and ready for user registration and training. See
Customer Training section.
1 . Set Device on Installer Site Home Page
1.
Once you have logged on your installer home page is displayed.
2.
Select “View” for the device you are installing
