Motion Mode 1- Default Channel 1 (FULL_M1):
The default channel (channel 1) is shown on-screen unless motion is detected on another channel. If motion is detected, that channel will appear on-screen during motion.
The default channel will return on-screen after 2~3 seconds after motion stops.
2
1 1
2~3 sec.
Motion Mode 2 - Motion Remain (FULL_M2):
When motion is detected, the relevant channel is shown on-screen, and will remain on-screen even after motion has ended on that channel. On-screen image will switch to
any channel that has motion, and remain on that channel.
2
1
Dual Mode (DUAL-S):
Only 2 channels will be displayed. Each channel will be condensed horizontally in order to fit on-screen together. Cameras can be shown full-screen by use of joystick or
with an attached RS-485 communication device.
Press UP for Channel 1
Press DOWN for Channel 2
Press ENTER (center press) for Dual View.
Channels 3 & 4 will not be shown, and left and right buttons will not function in this mode.
1
2
1
1
2
34
enter
1
Dual Mode - Not Condensed (DUAL-N):
Only 2 channels will be displayed. Each channel will display normal height on the screen (the edges of the camera image will be cropped o, the image will not be
condensed). Cameras can be shown full-screen by use of joystick or with an attached RS-485 communication device.
Press UP for Channel 1
Press DOWN for Channel 2
Press ENTER (center press) for Dual View.
Channels 3 & 4 will not be shown, and left and right buttons will not function in this mode.
1
2
1
1
2
34
enter
1
Dual Mode - Motion (DUAL_M):
Only 2 channels will be displayed. Each channel will be condensed horizontally in order to fit on-screen together. Channel 1 & Channel 2 can be shown on-screen by moving
the joystick up or down. Pressing ENTER will return to both channels on-screen. Channels 3 & 4 will not be shown, and left and right buttons will not function in this mode.
1
2
12
1
2~3 sec.
