Clockaudio CAP002 Bedienungsanleitung
Line level Pre Amplifier CAP002
The CAP002 is designed for use with an electret condenser microphone. When connected it will boost
the microphone audio output to a level that can be used to connect to a typical auxiliary line level
input commonly found on amplifiers / mixers or recorders requiring 0.5 Volts RMS (refer to your
external equipment instruction manual).
Power requirements
An external 12V to 24 DC or 24V AC supply with 100mA capacity (not supplied) is required / available
from most high street electrical retail outlets. Some DC adaptors are supplied with a plug already
attached these will need to be removed. Important that you careful check to ensure correct +/- polarity
of the 2 cables when connecting to the CAP002 pin 1 and 2 of PL2 screw terminals.
Connections
Microphone
CAP002 BOARD
To Mixer Input
AC/DC power adaptor
(not supplied)
Microphone input Connections
Connect your microphone to the PL2 screw terminals:
Connect Phase cold (-) to pin 4.
Connect phase hot (+) to pin 3.
Power supply connections
Connect the supply to the PL2 screw terminals:
Connect (-) Voltage to pin 2.
Connect (+) Voltage to pin 1.
Audio output / Mixer / Auxiliary amplifier Connections
Connect your mixer input / Audio amplifier input to PL1 screw terminals:
Connect ground to pin 1.
Connect phase cold (-) to pin 2.
Connect phase hot (+) to pin 3.
Changing the audio output level (R5)
The audio output level from the CAP002 is preset to give optimal sound level and in most cases will
not need to be replaced. However, if you are experiencing any distortion or clipping then the output
gain resistor (R5) can be adjusted giving more headroom. Increasing headroom offers a more natural
recording sound and allows for transient peaks, however mic gain is compromised:
1K Ohm = Fitted as standard maximum gain / minimum headroom
2K Ohm = +6dB more headroom
3.9K Ohm = +12dB more headroom.
18.2K Ohm = +18dB more headroom.
100K Ohm will give maximum headroom (microphone level) / minimum gain
Multi power supply connections to CAP002
A single AC power adaptor can be used to power several CAP002 Line amplifiers. Simply parallel
connect the wires from your AC adaptor to each of the CAP002 DC + / - power input screw terminals
of PL2 making sure of correct polarity. See below diagram showing 3 CAP002 running of a single
supply:
DC Supply from AC adaptor
Positive +
Negative -
The Current taken by each CAP002 is very small approx 5mA. An AC power adaptor with 100mA
capability will be able to power up to 20 CAP002 circuits.
Cb311016
Inhaltsverzeichnis
Andere Clockaudio Verstärker Handbücher
