COBHAM EXPLORER 8100 GX Bedienungsanleitung

EXPLORER 8100 GX

Quick Guide

IMPORTANT

Observe all safety requirements listed in the

beginning of the User & installation manual,

and install and use the system according to the

guidelines in the User & installation manual. The

User & installation manual is available

• in the web interface in the ACU (next section),

• on www.cobham.com/satcom (select

Cobham SYNC Partner Portal >

Downloads > Manuals).

Access the web interface

1. Switch on the Antenna Control Unit (ACU).

2. Connect your computer to LAN 1 on the

back of the ACU.

3. Open your Internet browser and enter the IP

address of the ACU. The default IP address is

ht tp://192.168.0.1.

4. On the ACU keypad, push and hold for 5

seconds and enter user name: admin (no

password) in the web interface.

Note: Change the administrator password

immediately after login!

5. To access the User & installation manual,

select HELPDESK > Support and click the

link under User manual.

Initial setup

From the web interface, select SETTINGS >

Network and make sure that LAN 5 is set up for

Static IP and the IP address 192.168.1.2.

Nofurthercongurationisnecessary, except to

calibrate the antenna and make sure the satellite

proleisactivatedasdescribedonthenextpage.

Connect the system

Connect the cables according to the wiring

diagram below. Use the following cables:

1. Ethernet cable for modem communication.

2. 75 Ohm RF cable, F-F connectors, for TX

(included with ACU).

3. 75 Ohm RF cable, F-F connectors, for RX

(included with ACU).

4. RS-232 cable (included with GMU).

5. RS-422 cable (included with GMU).

6. LNB RX cable (part of included cable harness).

7. ODU Comm (part of included cable harness).

8. BUC TX (part of included cable harness).

9. ODU Power & Comm (part of included cable

harness).

10. BUC Power & Comm (included with antenna)

11. Service port - Ethernet cable to computer e.g.

for access to web interface.

32 4 5

GMU

ACU

11 8 9

Service

port

LAN 2

and

LAN 3

user PC 10

Antenna

Pedestal

Important! Calibrate the compass

You must make a compass calibration every time

the antenna is installed. If the compass is not

calibrated the system will not work properly!

1. Parkthecarinaatarea,awayfromanylarge

magnetic objects, and make sure the antenna

is stowed.

2. Switch on the ACU.

3. When the LEDs are steady green on the ACU,

connect a computer to the ACU, access

the web interface and go to SERVICE >

Calibration.

4. Under Compass calibration, click Start.

5. WhentheStatuseldshowsReady, move

the vehicle to the next position, 90 degrees

relative to the current position, and click

Continue.

6. When all four steps are completed, the

Continue button changes to Start. The

compass calibration is now completed.

Satellite prole activated

1. In the web interface select

SETTINGS > Satellite proles.

2. VerifythattheGXsatelliteproleisactivated.

Notethatthesatelliteprolemustusea

modemprolewiththeGXModemUnit.

Start the system

1. Switch on the ACU and the GX Modem Unit

(GMU).

2. Wait until the LEDs on the front plate of the

ACU show that the system is ready to be

congured:

• Power LED: Green

• Logon LED: Off

• Fail/Pass LED: Flashing green during power-

on self test, after that steady green.

3. In the keypad, press and hold pfor 5

seconds to deploy the antenna.

4. Wait until the ACU display shows

TRACKING.

5. Check that the connected GMU is ready

(the ACU display shows MDM: NETOK).

6. When the GMU is ready you can connect

your equipment to the ACU and use it to

connect to the Internet via the GX network.

For details, refer to the User & installation

manual.

Stow the antenna

When you are not using the antenna it must be

stowed. In the ACU keypad, press and hold q

for 5 seconds.

Keypad and display

You can use the keypad and display of the ACU

for simple operations and for status information.

Keypad shortcuts:

Deploy: Press and hold pfor 5 seconds.

Stow: Press and hold qfor 5 seconds.

Restart: Press and hold pand quntil restart.

98-160056-A

Disclaimer

Any responsibility or liability for loss or damage in connection with the use of this product and the accompanying documentation is disclaimed

by Thrane & Thrane A/S. The information in this manual is provided for information purposes only, is subject to change without notice and may

contain errors or inaccuracies. Manuals issued by Thrane & Thrane A/S are periodically revised and updated. Anyone relying on this information

should acquire the most current version e.g. from www.cobham.com/communications-and-connectivity/satcom, Service and support, or from

the distributor. Thrane & Thrane A/S is not responsible for the content or accuracy of any translations or reproductions, in whole or in part, of this

manual from any other source. In the event of any discrepancies, the English version shall be the governing text.

Thrane & Thrane A/S is trading as Cobham SATCOM.

Andere COBHAM Antenne Handbücher

COBHAM

COBHAM SAILOR 600 VSAT Ka Bedienungsanleitung

COBHAM

COBHAM Sea Tel 2400 Bedienungsanleitung

COBHAM

COBHAM EXPLORER 8100 Bedienungsanleitung

COBHAM

COBHAM EXPLORER 5075GX Bedienungsanleitung

COBHAM

COBHAM SAILOR 1000 XTR Ku 8W Gebrauchs- und Pflegehandbuch

COBHAM

COBHAM Sea Tel 6011-4 Bedienungsanleitung

COBHAM

COBHAM Sea Tel 9711-56 IMA C Band Bedienungsanleitung

COBHAM

COBHAM Sea Tel Tracker 6000 Bedienungsanleitung

COBHAM

COBHAM SAILOR 800 VSAT Gebrauchs- und Pflegehandbuch

COBHAM

COBHAM Sailor 900 VSAT Bedienungsanleitung

COBHAM

COBHAM Sea Tel Bedienungsanleitung

COBHAM

COBHAM SAILOR XTR Ku Bedienungsanleitung

COBHAM

COBHAM Sea Tel 09 Series Handbuch

COBHAM

COBHAM SAILOR 900 Bedienungsanleitung

COBHAM

COBHAM SAILOR 60 GX Bedienungsanleitung

COBHAM

COBHAM Explorer 325 Bedienungsanleitung

COBHAM

COBHAM Sailor 150 FleetBroadband Bedienungsanleitung

COBHAM

COBHAM EXPLORER 3075GX Leitfaden

COBHAM

COBHAM HGA-7001 Bedienungsanleitung

COBHAM

COBHAM Saailor Fleet One Bedienungsanleitung

COBHAM

COBHAM 3.8m Offset Antenna Bedienungsanleitung

COBHAM

COBHAM EXPLORER 8100 Leitfaden

COBHAM

COBHAM HGA-6000 Bedienungsanleitung

COBHAM

COBHAM Sea Tel Bedienungsanleitung

Beliebte Antenne Handbücher anderer Marken

Alfa Network

Alfa Network APA-L01 Bedienungsanleitung

Naval

Naval PR-422CA Bedienungsanleitung

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Bedienungsanleitung

TERK Technologies

TERK Technologies TV44 Bedienungsanleitung

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Bedienungsanleitung

HP J8999A Bedienungsanleitung

MobilSat

MobilSat MSP-S Bedienungsanleitung

Steren

Steren ANT-UHF 13 Bedienungsanleitung

Novatel

Novatel 600-G Bedienungsanleitung

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Bedienungsanleitung

TRENDnet

TRENDnet TEW-AO12O Bedienungsanleitung

Radio Shack

Radio Shack 15-1837 Bedienungsanleitung

CommScope

CommScope CMAX-OMFX-43M-I53 Bedienungsanleitung

Ramsey Electronics

Ramsey Electronics DAP25 Bedienungsanleitung

Trango Systems

Trango Systems AD900-9 Bedienungsanleitung

Steren

Steren ANT-100 Bedienungsanleitung

IWCS

IWCS iriBelt II Einrichtungshandbuch

Labgear

Labgear LABHG32T Bedienungsanleitung