Cocoon BT42740 Bedienungsanleitung
Model Number: BT42740
INSTRUCTION MANUAL
MOTORCYCLE HELMET
BLUETOOTH KIT
2
After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
WARRANTY DETAILS/SUPPORT
This product is warranted against defects for a period of one year if
the product is faulty, Winplus will repair or replace the product (at its
discretion) at no cost to you provided the product has been used in
accordance with instructions provided. The benets under our Warranty
are in addition to other rights and remedies under consumer law in
relation to these goods. Our goods come with guarantees that cannot
be excluded under the Australian. Consumer Law. You are entitled to a
replacement or refund for a major failure and for compensation for any
other reasonably foreseeable loss or damage. You are also entitled to
have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
For additional support including helpful guides and videos, visit the
Cocoon support website at www.winplus.com.au/cocoon.html
Telephone: 1300 663 907
Email: customercar[email protected]
Website: www.winplus.com.au
Address: Winplus Australasia Pty Ltd, PO Box 537
Bayswater Business Centre Vic 3153
3
After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
CONTENTS
Warranty Details / Support
Contents
General Safety Instrutions
Parts List / Technical Specications
Product Features
Instructions
Fitting the Bluetooth Receiver to Your Helmet
Charging the Bluetooth Receiver
Powering On and O
Pairing to Your Bluetooth Enabled Mobile Phone
To Answer an Incoming Mobile Phone Call
Ending a Mobile Phone Call
Rejecting a Mobile Phone Call
Redial the Last Number
Pairing One Motorcycle Bluetooth to Another Motorcycle
Bluetooth to Use as an Intercom
To Start a Conversation via Intercom
To End a Conversation via Intercom
To Play Music via Bluetooth MP3 Player
To Answer a Call While Listening To Music
Troubleshooting
Repair & Refurbished Notice
2
3
4
5
6
7-13
7
9
9
10
10
11
11
11
11
12
12
12
13
14
15
4
After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
GENERAL SAFETY INSTRUCTIONS
Read this manual thoroughly before rst use and keep it in a safe place
for future reference, along with the warranty card, purchase receipt
and carton. The safety precautions enclosed herein reduce the risk
of re, electric shock and injury when correctly adhered to. Follow all
instructions and take notice of all warnings to reduce the risk of re or
electric shock.
•Do not remove the cover or the back of this product. There are
no user-serviceable parts inside this product.
•Do not repair the unit yourself. Only have it serviced by qualied
personnel. Supervise young children to ensure they do not play
with the product.
•Do not submerge the product in liquids.
•Do not place the product near other items that may damage it,
such as naked ame sources (lit candles) or excessive heat
(bar radiator).
WARNING: Using headphones while operating a motorcycle, motor
vehicle, watercraft or bicycle can be dangerous. Use caution while
using your Motorcycle Helmet Bluetooth kit when you are engaging
in any activity that requires your full attention.
5
After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
PARTS LIST
• 1 x Motorcycle Bluetooth Headset & Microphone
• 1 x USB Charging Cable
• 1 x 240V Power Adaptor
• 1 x Helmet Mount Clip
• 2 x Hook & Loop Pad Earphone Mounts
• 1 x Instruction Manual
• 1 x Warranty Card
• 2 x Warranty Stickers
TECHNICAL SPECIFICATIONS
Bluetooth Version: 2.1
Frequency: 2.4GHz
Supports: A2DP and AVRCP
Supported Bluetooth Proles: Bluetooth Headset and Hands free
Proles with Automatic Detection
Operating Range: Up to 10m for cell phones: up to 500m
for intercom function.
Weight: 45grams (excluding accessories)
Size: 83mm(L) x 54mm(W) x 30mm(H)
Battery type: Rechargeable Lithium Polymer 300mAh
Stand by: Up to 300 hours
Talk Time
- Phone: Up to 10 hours
- Intercom: Up to 5 hours
Charging Time: 4 hours
Headset: High Power ultra slim speaker with
integrated boom
Power Adaptor: DC 5V 500mA
6
After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
PRODUCT FEATURES
Complete system for all your communication needs while riding your
motorbike.
The Bluetooth® function will keep you connected to your mobile
phone, play music and connect with Bluetooth GPS systems.
The intercom means you can communicate with your pillion or other
riders within 500m while you ride. With simple set up and clear sound
quality you will always be in touch
Motorcycle Bluetooth®
1. Bluetooth Receiver
2. Multi-function Button (MFB)
3. Power/Intercom Button
4. Jog Wheel
5. Charger & Headset Socket
6. Headset Plug
7. Microphone
8. Ear Speaker
7
After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
INSTRUCTIONS
Fitting the Bluetooth Receiver to Your Helmet
1. Using the provided screw driver, loosen the
Headset Clip screws.
2. Slide the Headset Clip onto the left side of the helmet
(when on your head). Take care to place the inside of
the Headset Clip under the helmet padding.
3. Adjust the clip until you nd the best location for your
helmet. Ensure that the slots in the Headset Clip mount
are facing away from the helmet.
4. Tighten the screws to hold the clip rmly in place.
WARNING: Excessive tightening may damage the clips.
5. Slide the Bluetooth receiver down into the slots on
the Headset Clip mount. Make sure that it is locked
in securely.
6. To attach the ear speaker & microphone headset,
test which part of the helmet will be the best location
by putting your helmet on and locating the place
closest to your ears. You will need to put the helmet on
a few times to nd the optimum position to apply
the pad. When the correct position is found, remove
the adhesive protective strip and apply the felted
earphone pad.
8
After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
7. Attach ear speaker to the felted pad. Run
the Microphone Arm along the inside wall
of the helmet, to where your mouth will be.
The Microphone Arm is exible and should
be adjusted so it sits in the best position
in front of your mouth. Some helmets
have removable padding; if yours does,
it is recommended to run the speaker and
microphone under the padding.
8. Connect the headset to the Bluetooth
receiver. The plug can only be inserted in
one orientation
WARNING: Inserting the plug backwards will
cause damage to the Bluetooth Receiver. Use
caution when assembling.
9. Secure the cord of the Headset Plug inside
the helmet. Tuck any extra wire into the
helmet. Ensure that only a few centimetres of
the cord comes out.
You have successfully mounted the Motorcycle
Helmet Bluetooth.
9
After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
Charging the Bluetooth Receiver
Before using this device, fully charge the Bluetooth Receiver. This should
take around 4 hours.
1. Insert the USB plug of the charging cable into the small USB jack
on the headset. Insert the other end of the charging cable into the
Power Adaptor or your computer’s USB port.
2. While charging, the red LED on the Bluetooth receiver will
illuminate, when the charging is nished, the red LED will
switch o.
Tip: To maintain long life from the internal lithium battery, charge
your device at least once a month.
Powering On and Off
1. To turn the device on, press the power/intercom button for 3
seconds until you hear a beep. A blue light will ash quickly 3
times and then continue short ashes at regular intervals.
2. To turn the device o, press the power/intercom button for 5
seconds until you hear a beep. The Bluetooth receiver and LED
lights will turn o.
10
After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
Pairing to Your Bluetooth Enabled Mobile Phone
1. Place your Bluetooth enabled phone and the Bluetooth receiver
near each other. Within 1m is recommended.
2. Make sure the Bluetooth receiver is turned on.
3. Press and hold down the power/intercom button for approximately
8 seconds until the receiver beeps twice. The red and blue LEDs will
ash alternately. The receiver is now actively searching for Bluetooth
devices.
4. Activate Bluetooth on your mobile phone and search for the device.
Refer to your phones instructions if you are unclear on how to
search for Bluetooth devices.
5. Choose the Bluetooth device named FDC-01 and choose to pair this
device. If you are asked for a password, enter 0000.
6. The red & blue LEDs will then change to display blue only and the
headset will beep once to conrm pairing was successful.
To Answer an Incoming Mobile Phone Call
1. Press the Multi Function button on the receiver while the phone is
ringing
2. Use the jog wheel to increase or decrease the headset volume.
Tip: The incoming call will answer automatically once the phone
has rung for 8 seconds.
Andere Handbücher für BT42740
1
Inhaltsverzeichnis
Andere Cocoon Motorradzubehör Handbücher
Beliebte Motorradzubehör Handbücher anderer Marken
SRC
SRC B-TRK502-01-01-SL Bedienungsanleitung
3M
3M Speedglas 9100 MP Bedienungsanleitung
hepco & becker
hepco & becker 6307520 00 01 Bedienungsanleitung
HOMCOM
HOMCOM AA0-077 Bedienungsanleitung
hepco & becker
hepco & becker 6307558 00 01 Bedienungsanleitung
Wunderkind Custom
Wunderkind Custom 106503-F15 Benutzerhandbuch
