Code Alarm Ca6154 Professional Series Bedienungsanleitung

CCJCc:~~Ja~m

i=»~OFESSIONAI

SE~IES

Security and Remote Start Installation Guide

for

models:

ca6154

Table

Contents

Before You Begin.........................................................................................4

Wire Connection Guide...............................................................................5

4 Pin Main Harness...................................................................................7

6 Pin Start Harness ...................................................................................8

6 Pin Output Harness..............................................................................10

8 Pin Input Harness.................................................................................

4 Pin Alternate Output Harness...............................................................14

3 Pin Door Lock Output Harness.............................................................15

Additional Ports.........................................................................................19

Antenna I LED I Programming Port........................................................19

DBI Port...................................................................................................19

Telematic Interface Port...........................................................................19

Set Up &Programming .............................................................................20

Transmitter Programming........................................................................20

Manual Feature Programming.................................................................20

Programming Feature Banks ..................................................................

Tach Programming ..................................................................................24

Smart Tachless Mode..............................................................................24

Adjusting the Shock Sensor....................................................................25

Testing the Shock Sensor........................................................................25

Chirp Delete -UserAccessible................................................................25

Dome Light Delay I Theater Dimming .....................................................25

2 ca6154 Install revA

Feature Descriptions.................................................................................26

Transmitter

Button

Functions..................................................................

Security TriggerZones..............................................................................34

Remote Start Shutdown Diagnostics ......................................................34

System

Layout

...........................................................................................35

BEfoRE

YOU

·.,

BEGIN

' • .

· -

.:-_=_

- .

~---

•

:,.:

...

FORAUTOMATIC TRANSMISSION VEHICLES ONLY.

•

....

PROFESSIONAL INSTALLATION

STRONGLY RECOMMENDED

Roll down window to avoid locking keys

vehicle

during installation

Avoid mounting components or routing wires near

hot surfaces

Avoid mounting components or routing wires near

moving parts

Tape or loom wires under hood for protection and

appearance

Use a Digital Multi Meter for testing and verifying

circuits. DO NOT USE A TEST LIGHT, OR

"COMPUTER SAFE PROBE" as these can set off air

bags or damage vehicle computers.

Technical

Support

{800) 421-3209

http://avxtech1.com

ca6154 Install revA

z WHITE/RED PARKING LIGHT INPUT

WHITE PARKING LIGHT OUTPUT

z BLACK GROUND

-.;~"

BROWN SIREN OUTPUT (

+ )

PURPLE STARTER

OUTPUT-

MOTOR SIDE

.....

RED BATTERY 12V (

ct:

ORANGE ACCESSORY 1 (

+ )

.....

C/)

z PINK/WHITE IGNITION 2 (

RED/WHITE BATTERY 12V (

PINK IGNITION 1 (

R-J:

OufptJJ

l!la

t:J1e~

' ·

...

' ' -

______

---

_:-

- : :-

_:-

.' ; '

-·

·-

. ... .

·-;

. .

.. .

BROWN/BLACK HORN OUTPUT ( - )

BLUE/BLACK START STATIJS

ACTIVE OUTPUT ( - )

::>

a..

VIOLET/BLACK AUX 1 OUTPUT ( - )

::>

RED/WHITE TRUNK RELEASE OUTPUT ( - )

a..

LT GREEN/BLACK FACTORY DISARM

PULSE BEFORE START ( - )

ORANGE GROUND

WHEN

ARMED

OUTPUT ( - )

I-

c..

-(.)

c..

M...J

;

;:.

···

lnput

arness

,,_;_;::.:::~>--:

(~=::-

>::~:(

-',·

BLUE/WHITE INSTANT TRIGGER INPUT ( - )

GREEN DOOR TRIGGER INPUT

)

PURPLE DOOR TRIGGER INPUT (

+ )

WHITE/BLUE EXTRENAL START INPUT ( - )

GRAY

HOOD PIN INPUT

(-)

GRAY/RED PARKING BRAKE INPUT ( - )

BROWN/RED BRAKE INPUT ( + )

PURPLE/WHITE TACH INPUT

BLACK/YELLOW PULSE DURING CRANK ( - )

GREEN/WHITE PULSE AFTER SHUTDOWN

(-)

LT BLUE FACTORY ARM

PULSE AFTER START ( - )

LT GREEN/BLACK FACTORY DISARM

PULSE BEFORE START

)

I.l~~.

·['

'·.

~oc~

OJ,~put

.:.

all'ft~s

...

;:"

_ .- -.

·-

_:_

--~,

.-,__

·_

.\---

-·

- . .

-_--=:---=,::·:·-:

:,_----_:=_.

-,;.

:··-·

-~-

:;.

BLUE UNLOCK

(-)

OPEN

GREEN LOCK

(-)

ca6154 Install revA

WHITE/RED PARKING LIGHT INPUT

WHITE

PARKING LIGHT OUTPUT

Locate the parking light output wire at the vehicle's light switch.

Verification:

This wire registers positive voltage when the parking lights are

turned on.

Positive switching Parking Lights:

Connect the WHITE/RED wire to a 15Amp

max

fused battery source.

Connect the WHITE wire to the parking light output wire.

Negative switching Parking Lights:

Connect the WHITE/RED wire to a good chassis ground.

Connect the WHITE wire to the parking light output wire.

BLACK

GROUND

Connect

the

BLACK wire to a solid chassis ground point using a ring terminal and

selftapping screw (not supplied). Scrape away paint from the grounding point to

ensure a good connection. The recommended grounding point is a metal surface in

the driver's side kick panel area.

NOTE:

Do not ground the BLACK wire with any other vehicle components.

BROWN

SIREN OUTPUT (

+ )

Locate a suitable mounting location

the engine compartment for the siren,

away

from moving parts.

With the bell

the siren aiming downwards, secure the siren in place using

self

tapping screws, being careful not do drill into any hoses, wiring

components.

Connect

the

BLACK siren wire to a chassis ground using a ring terminal and

self

tapping

screw

(not supplied).

Route the BROWN siren output wire from the control module through the firewall and

connect to

the

RED wire on the siren.

NOTE:

Be sure to loom the siren wires, and seal the grommet.

·Start;

Harness

1 PURPLE STARTER OUTPUT ( + )

Locate the vehicle starter wire.

Verification: This wire registers voltage onlywhen the

key

is turned to the

START position. Cut the vehicle's starter wire

half

when

installing the

starter kill relay.

Verification

after

starterwire is cut:

KEY SIDE

starter wire registers voltage when the

key

is turned to the

START position.

MOTOR SIDE

starter wire registers no voltage.

Connect the PURPLE wire to the vehicle starter wire, use the MOTOR SIDE

the

vehicle starter wire when installing the starter kill relay.

2 RED BATTERY 12V (

Locate 1

the vehicle's constant 12 Volt battery wires at

the

ignition switch.

Verification: This wire will register

(+)voltage

all positions

the ignition

switch.

Connect the RED wire to the constant 12 Volt battery wire.

NOTE: Remove all fuses until all connections are made.

ORANGE ACCESSORY 1 ( + )

Locate the vehicle's accessory wire at the ignition switch.

Verification: This wire registers voltage when the key

turned to

ACC

(Accessory) and the ON (or RUN) position. The voltage drops out when the

key is turned to the START (or CRANK) position.

Connect the

ORANGE

wire to the vehicle's accessory wire.

ca61541nstall revA

PINK/WHITE IGNITION 2 ( + )

Locate the vehicle's 2nd ignition wire at the ignition switch (if equipped).

Verification: This wire registers voltage when the key

turned to the ON (or

RUN) position, but not the ACC (Accessory) position. The voltage does not

drop out when the key is turned to the START (or CRANK) position.

Connect the PINK/WHITE wire to the vehicle's ignition 2 wire.

Programmable output: IGN, ACC, Start.

RED/WHITE BATTERY 12V (

Locate 1

the vehicle's constant 12 Volt battery wires at the ignition switch.

Verification: This wire will register ( + ) voltage

all positions

the ignition

switch.

Connect the RED/WHITE wire to the constant 12 Volt battery wire.

NOTE: Remove all fuses until all connections are made.

PINK IGNITION 1 ( + )

Locate the vehicle's ignition wire at the ignition switch.

Verification: This wire registers voltage when the key is turned to the ON (or

RUN) position. The voltage does not drop out when the key

turned to the

START (or CRANK) position.

Connect the PINK wire to the vehicle's Ignition wire.

This wire is also used for Ignition 1 Output.

BROWN/BLACK HORN OUTPUT ( - )

Locate the vehicle's horn wire.

Verification: This wire will register at positive voltage and register

ground when the horn switch is pressed.

Connect the BROWN/BLACK wire to the vehicle's horn wire. This is a low current

output, 200mA.

BLUE/BLACK START STATUS

ACTIVE OUTPUT ( - )

This wire provides a ( - ) 200mAoutput when the remote start function is activated

and remains

until4

seconds after the remote start is shutdown.

this wire will be

used for multiple application's a 1 amp diode is required in-line with the stripe facing

the control module.

VIOLET/BLACK AUX 1

This wire provides a ( - ) 200mA output capable

driving relays. For Control

optional accessories (i.e. Power Window/Sunroof, etc.).

activate refer to the transmitter button configuration chart. Please refer to the

selectable options for timing.

RED/WHITE TRUNK RELEASE OUTPUT ( - )

Locate the vehicle's trunk release wire at the trunk release switch.

Verification: This wire will register either positive voltage

ground when

the trunk release is activated.

This is a low current 200mAoutput and in configurable

option programming.

ca6154 Install revA

Inhaltsverzeichnis

Andere Code Alarm Fernstartsystem Handbücher

Code Alarm

Code Alarm PC 7500 Bedienungsanleitung

Code Alarm

Code Alarm ca6554 Bedienungsanleitung

Code Alarm

Code Alarm ca5154 professional Series Bedienungsanleitung

Code Alarm

Code Alarm PROFESSIONAL SERIES Bedienungsanleitung

Code Alarm

Code Alarm SRT 9000 Bedienungsanleitung

Code Alarm

Code Alarm CA 5051MT Bedienungsanleitung

Code Alarm

Code Alarm CA2LCD5 Bedienungsanleitung

Code Alarm

Code Alarm CA 4055 Bedienungsanleitung

Code Alarm

Code Alarm ca5554 Professional series Bedienungsanleitung

Code Alarm

Code Alarm ca4053 Bedienungsanleitung

Code Alarm

Code Alarm SRT 6700 Bedienungsanleitung

Code Alarm

Code Alarm ca5553sst Bedienungsanleitung

Code Alarm

Code Alarm ca5154 professional Series Bedienungsanleitung

Code Alarm

Code Alarm SRT 9000 Bedienungsanleitung

Code Alarm

Code Alarm ca5354 Bedienungsanleitung

Code Alarm

Code Alarm CA 2050 Bedienungsanleitung

Code Alarm

Code Alarm CA 421 Bedienungsanleitung

Code Alarm

Code Alarm ca 2051 Bedienungsanleitung

Code Alarm

Code Alarm Professional Series CA 1050 Bedienungsanleitung

Code Alarm

Code Alarm CA 411 Bedienungsanleitung

Code Alarm

Code Alarm ca 4552 Bedienungsanleitung

Code Alarm

Code Alarm CA 5150 Bedienungsanleitung

Code Alarm

Code Alarm ca 4552 Bedienungsanleitung

Code Alarm

Code Alarm PROFESSIONAL CASECRS Bedienungsanleitung

Beliebte Fernstartsystem Handbücher anderer Marken

AstroStart

AstroStart 803U Bedienungsanleitung

Durite

Durite 0-649-20 Handbuch

EINHELL

EINHELL BT-PS 1000 Handbuch

Linear

Linear ACCESS AK-21 Technische Daten

Soundstream

Soundstream TARANTULA RS.2 Bedienungsanleitung

Jaycar Electronics

Jaycar Electronics MB3752 Bedienungsanleitung

Ultra Start

Ultra Start 72 Series Bedienungsanleitung

ADS

ADS FLASHLOGIC FLRSVW1 Bedienungsanleitung

Selecta

Selecta JS012 Bedienungsanleitung

Black Widow Security

Black Widow Security BW RAS 400 Bedienungsanleitung

Vector

Vector Power City DK080706 Beilage

Ozito

Ozito OJS-800 Bedienungsanleitung

Profi-Partner

Profi-Partner 46387 Bedienungsanleitung

EZ STARTER

EZ STARTER EZ-45 Bedienungsanleitung

Viper

Viper 4204 Bedienungsanleitung

Essex Electronics

Essex Electronics KE-1701 Bedienungsanleitung

EINHELL

EINHELL EGS 3600 Handbuch

Rooboost

Rooboost RB-1750WP Bedienungsanleitung

Code Alarm ca6154 Professional Series Bedienungsanleitung

Beliebte Fernstartsystem Handbücher anderer Marken