Comfort Zone T15 Bedienungsanleitung

Installation and

user manual

Supply air unit T15

Quick Start Guide

All settings and adjustments are made in the service menu unless otherwise specified.

To open the service menu

Go to Advanced settings, select General settings and press and hold the

button for 6 seconds.

Filter replacement and service access

Unscrew the four screws, remove the hatch and remove the old filter set,

install the new filter set, hang the hatch on the four screws and screw the

screws.

TABLE OF CONTENTS

1. INTRODUCTION 1

1.1 Safety information 1

1.2 Field of application 1

1.3 Symbols used in this manual 2

1.4 Nameplate and symbols on the product 2

2. SUPPLY AIR UNIT T15 3

2.2 Functional description 3

3. TRANSPORT AND STORAGE 4

3.1 Transport 4

4. INSTALLATION 5

4.1 Prepare the installation site 5

4.2 Installing the air supply unit 6

4.3 Connect the supply air unit 7

4.4 Ventilation system connection 8

4.5 Cooling and heating system connection 9

4.6 Connecting electronics 10

5. INSTALLATION ALTERNATIVES 12

5.1 Via supply air 12

5.2 In combination with heating system 13

6. SETTINGS AND START-UP 14

6.1 Starting the cooling function 14

6.2 Air flows 14

6.3 Adjust the fan speed 14

6.4 Setting the hot supply air temperature 15

6.5 Setting the maximum water flow 15

7. MAINTENANCE AND SERVICE 16

7.1 Filter replacement and cleaning 16

7.2 Venting 16

8. PROJECT PLANNING 17

8.1 Air flows 17

8.2 Fan diagram 17

9. WIRING DIAGRAM 18

10. TECHNICAL SPECIFICATIONS 19

10.1 Components for air supply unit 20

10.2 Dimensions 21

11. WARRANTY INFORMATION 22

12. CONTACT 23

1. Introduction

1.1 SAFETY INFORMATION

This manual is intended for the professional installer and as a guide for the user. The

installation must be done professionally. The installer does not need to be a certified

refrigeration technician.

The product may be used by children aged 8 years and over and by persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge

if they are supervised or instructed in its safe use and are aware of the dangers of the

product and its use.

1.2 FIELD OF APPLICATION

The ComfortZone T15 supply air unit is designed for heating and cooling ventilation

air for small houses with waterborne heating systems.

Any other use is considered improper use and may result in damage to the devices

and/or personal injury. Always follow the instructions in the accompanying manuals

and contact us if you are unsure.

The device must only be installed according to the instructions in this manual.

1.3 SYMBOLS USED IN THIS MANUAL

In this manual the following symbols are used

Warning!

This symbol indicates that the installer is at risk of harming himself or

others (seriously) or seriously damaging the product.

Careful!

This symbol indicates that the product may be damaged.

Note!

This symbol indicates a note with additional information for the installer.

Tip!

This symbol shows suggestions and advice for the installer to perform

certain tasks more easily or conveniently.

1.4 NAMEPLATE AND SYMBOLS ON THE PRODUCT

Important information about the supply air unit can be found on the nameplate and on

the symbols on the unit. The nameplate is located on the left side of the bottom plate.

Labelling

The product is CE marked, which means that Comfortzone declares that the product

complies with EU requirements for safety, health and environmental protection.

Disposal

The product must be collected separately when it is discarded. Dispose

of according to local WEEE regulations.

2. Supply air unit T15

2.1 GENERAL PRODUCT DESCRIPTION

The ComfortZone T15 supply air unit is designed for preheating and cooling the

supply air in houses with waterborne heating systems. The unit is not intended as a

heating battery in air heating systems, but its function is to preheat incoming air.

The supply air unit is complete and equipped with low-energy fan, water battery,

coarse and fine filters, supply air temperature thermostat. In the supply air unit, the

supply air is filtered and cooled or heated to the appropriate temperature.

The supply unit is equipped with a connection for a circulation air duct that increases

the air flow and the cooling capacity. Circulation air is taken from the appropriate

space in the house.

The temperature of the incoming supply air in heating mode is set with a thermostat

behind the front door. The fan speed of the supply air unit is controlled from the

exhaust air heat pump.

The supply air unit is equipped with a trap on the supply air and automatic fan stop

when the supply air temperature is below 11 degrees.

The T15 is adapted to work with ComfortZone cooling and heating exhaust air heat

pumps.

2.2 FUNCTIONAL DESCRIPTION

When the cooling function is activated, the heat pump produces cooling instead of

heating of the circulating water.

In simple terms, it can be described as the evaporator and heat exchanger changing

function. The heat exchanger acts as an evaporator and the evaporator as a heat

exchanger. This is done by means of a 4-way valve.

The cold water is transferred to the water coil in T15 where the air flows through and is

then cooled and blown out to the air vents in the house.

3. Transport and storage

3.1 TRANSPORT

Transport or store the device under the following conditions.

Temperature (°C) 5 – 50 °C

Humidity (%) < 85%, non-condensing

Warning!

Always move the supply air unit with at least two people.

Note!

Only remove the original packaging from the air handling unit at the

installation site. Secure the unit against tipping over.

4. Installation

4.1 PREPARE THE INSTALLATION SITE

The supply air unit should be located in the laundry room, utility room, storage room,

mechanical room or if space is available adjacent to the exhaust air heat pump. 800

mm of free space is needed in front of the unit for service and maintenance. The

supply air unit requires connection to a condensate drain. Recommended is T15

installed next to the heat pump at the top. If this is not possible, the heater can also be

installed in another location.

The supply air unit should not be installed in areas with a temperature lower than +5˚C

or on walls adjacent to bedrooms or similar areas where the unit's operating noise may

be transmitted through the building structure.

Make sure there is enough space.

Image 1 Required space around the heat pump and supply air unit

• At least 800 mm of space at the front to allow for maintenance.

• At least 10 mm of space around the supply air unit, walls or other objects.

• At least 300 mm distance above the supply air unit.

Min. 300 mm

Min. 800 - 1000 mm

Min. 10 mm

4.2 INSTALLING THE AIR SUPPLY UNIT

The wall bracket is mounted horizontally on the wall. The supply air unit is lifted into

place and hooked onto the unit bracket at the rear of the wall bracket so that the unit

rests against the wall with the spacers down. For dimensions, see technical

specifications.

Check the following:

• The wall has a load-bearing capacity which can handle the weight of the unit.

• The wall is flat.

Inhaltsverzeichnis

Andere Comfort Zone Lüfter Handbücher

Comfort Zone

Comfort Zone CZ6XM Series Bedienungsanleitung

Comfort Zone

Comfort Zone CZ9BWT Bedienungsanleitung

Comfort Zone

Comfort Zone CZ16W Series Bedienungsanleitung

Comfort Zone

Comfort Zone CZMC42 Bedienungsanleitung

Comfort Zone

Comfort Zone CZHV201BS-EU Bedienungsanleitung

Comfort Zone

Comfort Zone CZTF421R Series Bedienungsanleitung

Comfort Zone

Comfort Zone CZHV82T Series Bedienungsanleitung

Comfort Zone

Comfort Zone CZHV81T Series Bedienungsanleitung

Comfort Zone

Comfort Zone CZ112 Series Bedienungsanleitung

Comfort Zone

Comfort Zone CZHVW30EX Series Bedienungsanleitung

Comfort Zone

Comfort Zone CZHVP20S Series Bedienungsanleitung

Comfort Zone

Comfort Zone CZHV101BS-EU Bedienungsanleitung

Comfort Zone

Comfort Zone CZHV18BK Bedienungsanleitung

Comfort Zone

Comfort Zone CZTF329WT Bedienungsanleitung

Comfort Zone

Comfort Zone CZHV20B Bedienungsanleitung

Comfort Zone

Comfort Zone CZ6XMWT Bedienungsanleitung

Comfort Zone

Comfort Zone CZ16WR Series Bedienungsanleitung

Comfort Zone

Comfort Zone CZBC Series Bedienungsanleitung

Comfort Zone

Comfort Zone CZDR12 Series Bedienungsanleitung

Comfort Zone

Comfort Zone CZHV12B Series Bedienungsanleitung

Comfort Zone

Comfort Zone POWR CURVE Bedienungsanleitung

Comfort Zone

Comfort Zone CZPF402AS2-EC Bedienungsanleitung

Comfort Zone

Comfort Zone CZ122BK Bedienungsanleitung

Comfort Zone

Comfort Zone CZMC24 Bedienungsanleitung

Beliebte Lüfter Handbücher anderer Marken

ELTA FANS

ELTA FANS H03VV-F Bedienungsanleitung

Hunter

Hunter 20714 Gebrauchsanweisung

Emerson

Emerson CARRERA VERANDA CF542ORB00 Bedienungsanleitung

Hunter

Hunter Caraway Gebrauchsanweisung

Panasonic

Panasonic FV-15NLFS1 Bedienungsanleitung

Kompernass

Kompernass KH 1150 Bedienungsanleitung

VES

VES FALA100/12V/TR Bedienungsanleitung

Vertiv

Vertiv Liebert DCD Bedienungsanleitung

Westinghouse

Westinghouse GFP Series Bedienungsanleitung

Venmar

Venmar KUBIX HRV PLUS Series Bedienungsanleitung

Maico

Maico ECR 31 Bedienungsanleitung

Sonnenkonig

Sonnenkonig Dinky Bedienungsanleitung

S&P

S&P ECOWATT HXBR Bedienungsanleitung

Wider

Wider IMP03369BH Bedienungsanleitung

Panasonic

Panasonic F-60DHN Bedienungsanleitung

Hinkley

Hinkley HIGHLAND Bedienungsanleitung

Broan

Broan 766BN Bedienungsanleitung

Premium

Premium PFS16022 Montageanleitung