CommScope FOSC-OC-6 Bedienungsanleitung
FOSC-OC-6
INSTALLATION INSTRUCTION
US FOSC tray (A size) with integrated splitter
1 Kit content
2 Installation in FOSC closures
2.1 The first tray is secured against the tray tower. When necessary,
replace the appropriate tray by the splitter tray.
To remove this tray, loosen the screws and remove the bracket.
Alternatively, the splitter tray can be mounted on top of the already
installed trays.
Note: in a European FOSC A or FOSC B closure always install the
FOSC-OC-6 at the top of the installed trays.
2.2 Use a screwdriver to bend one of the legs and remove the tray
out of the tower.
2
2.7 Mark the transportation tube(s) 15 mm from the tray edge
(to the inside). Carefully remove the tube overlength from the mark
(longitudinal slits first, then circumferential).
Note: depending the manner of identification, the tube can be removed
with only a circumferential cut. Make sure not to lose ID.
2.4 Re-install the bracket.
2.5 Install a splicing tray in the second slot.
2.6 Route the tranportation tubes to the appropriate tray(s) as
shown.
2.3 The tray can be inserted in the tray tower by aligning the tray
pins (on the tray legs) with holes in the tray tower. Squeeze the tray legs
and slip the tray into the tray tower.
3
3 Identification
Identification can be done by means of
• colored fibers
• colored tubes
• marked tubes
• colored tapes
• flags.
Make sure not to lose ID.
2.8 Secure the transportation tube with two tie-wraps.
3.1 At the end of each fiber, a flag can be attached with the
identification of the fiber.
The identification is as follows
Ix.y: I = Incoming fiber of the splitter
x = splitter number
y = splitter port
Ox.y: O = Outgoing fiber of the splitter
x = splitter number
y = splitter port
3.2 Select the appropriate fiber to be spliced, cut the identification
flag when available and do all necessary steps till the splice protector is
installed.
Note: make sure not to lose fiber identification.
The fiber end can be deformed to create higher Return Loss on the
unused fibers.
Make sure to cut the fiber end (50 mm, 2” or behind the ID flag) before
starting with the splicing steps.
3.3 Proceed with the storage of the splices and fibers according to
the installation instruction delivered with the enclosure or tray kit.
Note: make sure the splice protector has cooled down before storing.
CommScope Connectivity Belgium bvba
Diestsesteenweg 692
B-3010 Kessel-Lo, Belgium
Tel.: 32-16-351 011
Fax: 32-16-351 697
commscope.com
Visit our website or contact your local CommScope representative for more information.
© 2016 CommScope, Inc. All rights reserved.
FOSC and all trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc.
This document is for planning purposes only and is not intended to modify or supplement any specifications or warranties relating to
CommScope products or services.
TC 729/IP/5 05/08
Inhaltsverzeichnis
Andere CommScope Medienkonverter Handbücher
