CommScope BSAMNT-3 Bedienungsanleitung

Part Lists

M8 screw

two hole plate

• Bracket edges parallel to each other.

(fully collapsed position)

Pre-assembly of Downtilt Brackets by Kit Vendor

(Not applicable for BSAMNT-F)

M10 screw

SCISSOR GASKET

ITEM NO.

DESCRIPTION

BSAMNT-3

QUANTITY

BSAMNT-M/-MH

QUANTITY

BSAMNT-F

QUANTITY

PIPECLAMP BRACKET, NO FLANGE

424

BRACKET, PIPE CLAMP INTERFACE

212

NOTCHED BRACKET

1 1

BRACKET

1 1

SCR,HCS,HEX,M8X25,10mm UNT,SST,PASS

2 2

WSHR,BELLE,M8,16-8.2-1.5,SST,PASS

2 2

PLATE, TWO HOLES

2 2

NUT,HEX,M10,STL,GALV

12 8 8

WSHR,LK,SPLT,M10,STL,GALV

644

SCR,HCS,HEX,M10X40,STL,GALV

644

NUT,HEX,M12,STL,GALV

12 6 12

WSHR,FLT,M12,13X24X2.5,STL,GALV

424

WSHR,LK,SPLT,M12,STL,GALV

424

CARRIAGE BOLT,WITH HEAT SHRINK

424

SCR,HCS,HEX,M10X25,10mm UNT,SST,PASS

2 2

WSHR,BELLE,M10,20-10.2-1.6,SST,PASS

2 2

17 SCISSOR GASKET 2 2

WSHR,FLAT,M16,17.5x30x2.5,SST

424

ISOLATOR

424

Mounting Kits For Wide Panel Antennas

BSAMNT-3, BSAMNT-M & BSAMNT-MH & BSAMNT-F: Mounting systems for

cylindrical pipe

installations

(60-115 mm pipe diameter) for heavy duty applications

This document explains how to install an antenna using a BSAMNT mount kit. Antennas with two mount points

will use BSAMNT-3 or BSAMNT-F. Antennas with three mount points will also include the BSAMNT-M or

BSAMNT-MH. The antenna mechanical tilt can not be adjusted if BSAMNT-F is used.

639840 Revision J, February 2020

Page 1 of 4

www.commscope.com

Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.

All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639840 J (02/20)

Pre-assembly of Pipe Bracket by Field Installer

(BSAMNT-3/-F QTY 2 EA)

(BSAMNT-M/-MH QTY 1 EA)

CRITICAL: For initial installation

to pipe, downtilt brackets must

be configured in pre-assembly

position (fully collapsed).

M10 screw

Top / Middle Mount Installations

BSAMNT-3/-M/-MH

211

8910

11098

M10 screw

WARNING

: LOOSENING OR REMOVING BOLTS

THAT ATTACH MOUNTING PLATE TO ANTENNA

WILL VOID WARRANTY AND MAY RESULT IN

PRODUCT DAMAGE OR PERSONAL INJURY.

1098

BSAMNT-F

DETAIL A

DETAIL B

MAXIMUM TORQUE

M12

58N.m (43ft.lbs)

MAXIMUM TORQUE

25N.m (18ft.lbs)

M10

40N.m (30ft.lbs)

M12

58N.m (43ft.lbs)

639840

Page 2 of 4

www.commscope.com

Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.

All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639840 J (02/20)

Bottom Mount Installation

M10 screw

M10 pivot screw

center location

(loosen only)

M10 pivot screw

(loosen only)

M8 adjuster screw

perimeter location

(remove to adjust tilt)

M10 pivot screw

(loosen only)

M10 pivot screw

(loosen only)

M10 pivot screw

(loosen only)

DETAIL D

•

Loosen pivot screws . (do

not remove)

• Remove adjuster screws.

• Adjust antenna angle.

(use inclinometer)

• Reinstall adjuster screws.

• Retighten all screws.

Adjusting Antenna Tilt - 2 POINT MOUNT

(Not applicable for BSAMNT-F)

use inclinometer to

adjust antenna angle

9 10

WARNING

: LOOSENING OR REMOVING BOLTS

THAT ATTACH MOUNTING PLATE TO ANTENNA

WILL VOID WARRANTY AND MAY RESULT IN

PRODUCT DAMAGE OR PERSONAL INJURY.

DETAIL C

MAXIMUM TORQUE

M10

40N.m (30ft.lbs)

M12

58N.m (43ft.lbs)

MAXIMUM TORQUE

25N.m (18ft.lbs)

M10

40N.m (30ft.lbs)

M12

58N.m (43ft.lbs)

639840

Page 3 of 4

www.commscope.com

Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.

All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639840 J (02/20)

SAFETY NOTICE

The installation, maintenance, or removal of an antenna

requires qualified, experienced personnel. CommScope

installation instructions are written for such installation

personnel. Antenna systems should be inspected once a

year by qualified personnel to verify proper installation,

maintenance, and condition of equipment.

CommScope disclaims any liability or responsibility for the

results of improper or unsafe installation practices.

It is recommended that transmit power be turned off

when the field installation is performed. Follow all

applicable safety precautions as shown on this page.

Do not install on a wet or windy

day or when lightning or thunder

is in the area. Do not use metal

ladder.

Do not install near power lines.

Power lines, telephone lines,

and guy wires look the same.

Assume any wire or line can

electrocute you.

Wear shoes with rubber soles and

heels. Wear protective clothing

including a long-sleeved shirt and

rubber gloves.

use inclinometer to

adjust antenna angle

•

Loosen pivot screws . (do

not remove)

• Remove adjuster screws.

• Adjust antenna angle.

(use inclinometer)

• Reinstall adjuster screws.

Middle Bracket First

• Retighten all screws.

Adjusting Antenna Tilt - 3 POINT MOUNT

(Not applicable for BSAMNT-F)

Remote Electrical

Tilt Connection

The AISG connector fitted to the antenna is designed to accept

any AISG compliant cable assembly, commscope recommends

hand tightening AISG mating connector only. Applied torque to

the connector shall not exceed 1.5N*m.

RF Cable Connection

The female RF connectors fitted to the antenna are designed

to fit jumper cables with standard related male RF connector.

Tighten the RF connector coupling according to torque

specification in antenna label, if the RF connectors are

tightened beyond the recommend torque, the RF connection

to the antenna may be damaged.

M10 pivot screw

(loosen only)

M10 pivot screw

(loosen only)

M10 pivot screw

(loosen only)

M10 pivot screw

center location

(loosen only)

M10 pivot screw

(loosen only)

M8 adjuster screw

perimeter location

(remove to adjust tilt)

DETAIL E

MAXIMUM TORQUE

25N.m (18ft.lbs)

M10

40N.m (30ft.lbs)

M12

58N.m (43ft.lbs)

639840

Page 4 of 4

www.commscope.com

Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.

All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639840 J (02/20)

Dieses Handbuch passt für folgende Modelle

Andere CommScope Rack & Stand Handbücher

CommScope

CommScope BSAMNT-SBS-2-3 Bedienungsanleitung

CommScope

CommScope 2RU FMT Bedienungsanleitung

CommScope

CommScope NETpodium 1-1671578-1 Bedienungsanleitung

CommScope

CommScope FIST-GR2-SMS-01 Bedienungsanleitung

CommScope

CommScope FL1000 Bedienungsanleitung

CommScope

CommScope CMC-21 Bedienungsanleitung

CommScope

CommScope NETpodium 1-1671405-1 Bedienungsanleitung

CommScope

CommScope BSAMNT-SBS-1-2 Bedienungsanleitung

CommScope

CommScope RK4P45-29A Bedienungsanleitung

CommScope

CommScope DB5091-3 Bedienungsanleitung

CommScope

CommScope ODF-FF19CM-40RU Bedienungsanleitung

CommScope

CommScope MC-MNT-3XV-SIDE Bedienungsanleitung

CommScope

CommScope F-118-GL-E Bedienungsanleitung

CommScope

CommScope IST-GPS2 Bedienungsanleitung

CommScope

CommScope OTE-M Bedienungsanleitung

CommScope

CommScope BSAMNT Series Bedienungsanleitung

CommScope

CommScope NETpodium 1-1671579-1 Bedienungsanleitung

CommScope

CommScope SYSTIMAX iPatch 600A Bedienungsanleitung

CommScope

CommScope 639849 Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung