Compaq Presario S7000 - Desktop PC Bedienungsanleitung

Compaq Presario Desktop Products

upgrading and

servicing the pc

The information in this document is subject to change without notice.

Hewlett-Packard®Company makes no warranty of any kind with regard to this material, including,

but not limited to, the implied warranties of merchantability and fitness for a particular purpose.

HP shall not be liable for errors contained herein or for incidental or consequential damages in

connection with the furnishing, performance, or use of this material.

HP assumes no responsibility for the use or reliability of its software on equipment that is not

furnished by HP.

This document contains proprietary information that is protected by copyright. All rights are

reserved. No part of this document may be photocopied, reproduced, or translated to another

language without the prior written consent of HP.

Hewlett-Packard Company

P.O. Box 4010

Cupertino, CA 95015-4010

USA

Hewlett-Packard is a registered trademark of Hewlett-Packard Company in the United States of

America and other countries/regions.

This product incorporates copyright protection technology that is protected by method claims of

certain U.S. patents and other intellectual property rights owned by Macrovision Corporation

and other rights owners. Use of this copyright protection technology must be authorised by

Macrovision Corporation, and is intended for home and other limited viewing uses only unless

otherwise authorised by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

Apparatus Claims of U.S. Patent Nos. 4,631,603, 4,577,216, 4,819,098, and 4,907,093 licensed for

limited viewing uses only.

Other brand or product names are trademarks of their respective holders.

HP supports lawful use of technology and does not endorse or encourage the use of our products for

purposes other than those permitted by national copyright law.

upgrading and servicing the pc iii

upgrading and servicing the pc ...................................................... 1

preparing the pc ............................................................................ 1

removing or upgrading a drive ...................................................... 3

locating drive positions..............................................................................3

removing a drive ......................................................................................3

replacing or adding a drive .......................................................................5

upgrading or replacing memory .................................................... 7

removing a memory module.......................................................................7

replacing or adding a memory module .......................................................8

removing or installing an expansion card ...................................... 9

reassembling the pc ..................................................................... 10

table of contents

iv upgrading and servicing the pc

upgrading and servicing the pc 1

upgrading and

servicing the pc

This guide describes procedures for accessing the

internal parts of the PC and installing components.

NOTE: The procedures for the S0000 and 8000 series

models are the same except where noted.

8000 series model and S0000 series model

preparing the pc

Before you upgrade any component in your PC, you

need to prepare the PC so that you can safely handle

it and the components.

CAUTION: Static electricity can damage

the electronic components of the PC or

optional equipment. Ensure that you are

discharged of static electricity by briefly

touching a grounded metal object.

1 Remove any diskette or optical disc (CD or DVD)

from the PC.

2 Click the Start button, and then click Turn Off

Computer. Click Tu r n O f f to turn the PC off.

3 Disconnect the modem/telephone cable, if

present.

4 Disconnect the power cable from the electrical

outlet (1) and then from the PC (2).

disconnecting the power cable

WARNING: To reduce the risk of

personal injury from electrical shock

and hot surfaces, disconnect the power

cable from the wall outlet, and allow

the internal system components to cool

before touching.

5 Disconnect all external devices connected to

the PC.

2upgrading and servicing the pc

6 Lay the PC on its side with the access panel (the

side with the pull grip) facing up.

7 Remove the access panel by loosening the screw(s)

(1) that secure the access panel to the PC chassis.

Slide the access panel back (2) about 1 inch (2.5

cm), and then lift it up and off the unit.

removing the pc access panel on the

S0000 series model

WARNING: Beware of sharp edges

inside the chassis.

removing the pc access panel on the

8000 series

8 Remove the front bezel by following the

appropriate method for your PC model.

• To remove the front bezel from the S0000 series

model, gently pry the top section (1) of the

bezel away from the chassis. On the inside of

the front bezel, press the centre two tabs (not

the bottom tabs) to release the bezel, and then

pull it from the chassis (2).

removing the front bezel from the

S0000 series

• To remove the front bezel from the 8000 series,

push up on the two release tabs (1), and then

rotate the front bezel away from the chassis to

release it (2).

removing the front bezel from the

8000 series

upgrading and servicing the pc 3

removing or

upgrading a drive

Depending on your PC configuration, you may have

up to four of the following storage drives in your PC:

• CD-ROM or CD-RW drive

• DVD-ROM or DVD+RW/+R drive

• Hard disk drive

• Diskette drive

• 7-In-1 memory card reader (select models only)

You need a screwdriver to replace any of the drives.

CAUTION: Back up your personal files

on the hard disk drive to an external

storage device, such as a CD, before

removing the hard disk drive. Failure to

do so will result in data loss. After

replacing the hard disk drive, you need

to run System Recovery using the

recovery discs to load the factory-

installed files. See “using application

recovery and system recovery” for

details.

locating drive positions

drive positions on the S0000/8000 series (S0000

shown)

1 Optical drive, may be a CD-ROM, CD-RW,

DVD-ROM, or DVD+RW/+R drive

2 Second optical drive, may be a DVD-ROM,

DVD+RW/+R, CD-ROM, CD-RW drive, or

7-In-1 memory card reader (select models only)

3 Diskette (floppy) drive

4 Hard disk drive

removing a drive

1 Locate the drive you want to remove.

2 Complete the procedure described in “preparing

the pc” on page 1.

3 Disconnect the power cable (1) and data cable (2)

from the back of the drive you want to remove, as

indicated in the following illustrations. Use a

gentle rocking motion. Some units may have a

sound cable. If so, disconnect the sound cable (3).

disconnecting the optical drive cables

disconnecting the 7-In-1 memory card

reader cable

4upgrading and servicing the pc

disconnecting the diskette (floppy) drive cables

disconnecting the hard disk drive cables

4 Release the drive from the chassis by following the

method appropriate for your PC model:

• To release a drive from the chassis of the S0000

series, lift the release tab (1) on the latch drive

bracket of the drive you want to remove, and

then slide the drive from its drive bay (2). (The

latch drive bracket secures the drives in their

respective positions in the chassis.)

removing a drive from the S0000 series

• To release an optical drive or diskette drive

from the chassis of the 8000 series, slide the

drive lock mechanism (1) to unlock the drive in

the drive bay and pull the drive out of the drive

bay (2).

removing an optical or diskette drive

from the 8000 series

• To release a hard disk drive from the chassis of

the 8000 series, slide the drive lock mechanism

(1) to unlock the drive in the drive bay, remove

the metal drive shield (2) by pressing and lifting

the two tabs on one side of the shield, and then

pull the drive out of the drive bay (3).

upgrading and servicing the pc 5

removing a hard disk drive from the 8000 series

5 For both the S0000 and 8000 series, if you are

replacing the old drive with a new drive, remove

the four screws (4) (two on each side) from the old

drive. You need these screws to install the new

drive.

NOTE: If you have the S0000 series, and you

removed a 7-In-1 memory card reader, continue to

step 7; otherwise, you are finished with the task of

removing a drive from the chassis.

If you have the 8000 series, and you removed a

hard disk drive, a 7-In-1 memory card reader or an

optical drive, you are also finished with this

task. If you have the 8000 series, and you removed

a diskette drive, continue to step 6.

6 For an 8000 series diskette drive, squeeze inward

on both sides of the bracket brace, and lift the

brace up and out (1). Remove the two sets of

screws (2) (left and right sides) that secure the

drive to the drive adapter. Lift the diskette drive

out of the drive adapter (3) by sliding the drive

back and then up. Ensure that the guide screws (4)

(left and right sides) are left in the drive adapter.

You are finished with the task of removing the

drive.

removing a diskette drive from the drive

adapter on the 8000 series

7 For the S0000 series 7-In-1 memory card reader,

remove the reader from the drive bay adapter if

the adapter is not included with your replacement

reader. Remove the two screws (left and right

sides) that secure the reader to the adapter. Lift the

reader out of the adapter by sliding the reader

back and then up. You are finished with the task of

removing the reader.

removing a 7-In-1 memory card reader from the

drive bay adapter on the S0000 series

replacing or adding a drive

The steps to replace or add a drive are the same for

both the S0000 and 8000 series, except when you are

replacing a diskette drive on the 8000 series, or the

7-In-1 memory card reader on the S0000 series.

6upgrading and servicing the pc

If you are replacing a diskette drive on the 8000

series, before starting step 1 in the following

instructions, you need to fit the diskette drive in a

diskette drive adapter as described in “reassembling

the diskette adapter” on page 7.

If you are replacing a 7-In-1 memory card reader,

before starting step 1 in the following instructions,

reassemble the reader in the drive bay adapter as

described in step 7 of “removing a drive” on page 3.

If you are replacing or adding any other drive, begin

with step 1 in the following instructions.

to replace or add a drive

1 Insert four guide screws into the sides of the drive

(two on each side). The screws help guide the

drive into its proper position in the bay.

• When replacing a drive on the S0000 and 8000

series, place the screws, that you removed from

the old drive, into the new drive.

• When adding a second hard disk drive on the

8000 series, use the four extra guide screws that

are attached to the chassis under the front bezel.

2 Slide the drive into the drive bay (1), making sure

to align the guide screws with the guide slots,

until it snaps into place.

sliding the drive into the drive bay on the

S0000/8000 (S0000 shown)

3 Reconnect the power and data cables to your drive

as indicated in the following illustrations.

reconnecting the 7-In-1 memory card reader

cable on the S0000 series

reconnecting the diskette drive cables

reconnecting the hard disk drive cables

Andere Handbücher für Presario S7000 - Desktop PC

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Compaq Desktop Handbücher

Compaq

Compaq D300v - Evo - 128 MB RAM Handbuch

Compaq

Compaq 3000R - ProLiant - 128 MB RAM Kurzanleitung

Compaq

Compaq BL10e - HP ProLiant - 512 MB RAM Referenzhandbuch

Compaq

Compaq Evo W6000 Bedienungs- und Wartungshandbuch

Compaq

Compaq Presario 5BW Series Handbuch

Compaq

Compaq Deskpro AP400 Bedienungsanleitung

Compaq

Compaq 127507-008 - Deskpro EP - 64 MB RAM Kurzanleitung

Compaq

Compaq Compaq Presario Handbuch

Compaq

Compaq dc7800 - Convertible Minitower PC Bedienungs- und Wartungshandbuch

Compaq

Compaq Presario SR1700 - Desktop PC Bedienungsanleitung

Compaq

Compaq Compaq Portable II Handbuch

Compaq

Compaq Deskpro AP400 Handbuch

Compaq

Compaq Compaq Presario Bedienungsanleitung

Compaq

Compaq Evo D310 Micro-Desktop Bedienungsanleitung

Compaq

Compaq Deskpro EX Handbuch

Compaq

Compaq 127507-008 - Deskpro EP - 64 MB RAM Kurzanleitung

Compaq

Compaq Evo Workstation W4000 Gebrauchs- und Pflegehandbuch

Compaq

Compaq dc5100 - Microtower PC Bedienungsanleitung

Compaq

Compaq 517212-001 Bedienungsanleitung

Compaq

Compaq Presario SR1600 - Desktop PC Montageanleitung

Compaq

Compaq 239158-999 - Mini Tower - Power Supply 250... Bedienungsanleitung

Compaq

Compaq SR5250NX - Presario - 1 GB RAM Anleitung zur Verwendung

Compaq

Compaq Evo D310 Micro-Desktop Produkthandbuch

Compaq

Compaq dc5800 - Microtower PC Bedienungsanleitung

Beliebte Desktop Handbücher anderer Marken

HP m9060n - Pavilion - Elite Technisches Datenblatt

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

HP Presario SV7000 - Desktop PC Bedienungsanleitung

HP ProDesk 400 G5 Handbuch

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Lenovo

Lenovo ThinkCentre Edge 72 Handbuch

Lenovo

Lenovo ThinkStation D20 Handbuch

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung