Compaq 1024 Bedienungsanleitung

NOTICE

The information in this guide is subject to change without notice.

COMPAQ COMPUTER CORPORATION SHALL NOT BE

LIABLE FOR TECHNICAL OR EDITORIAL ERRORS OR

OMISSIONS CONTAINED HEREIN; NOR FOR INCIDENTAL

OR CONSEQUENTIAL DAMAGES RESULTING FROM THE

FURNISHING, PERFORMANCE, OR USE OF

THIS MATERIAL.

This guide contains information protected by copyright. No part of

this guide may be photocopied or reproduced in any form without

prior written consent from Compaq Computer Corporation.

COMPAQ, DESKPRO, SYSTEMPRO, LTE, FASTART

Registered U. S. Patent and Trademark Office.

SLT, EZ Help, QVision, ProLinea and Contura are trademarks of

Compaq Computer Corporation.

The software described in this guide is furnished under a license

agreement or nondisclosure agreement. The software may be used or

copied only in accordance with the terms of the agreement.

Product names mentioned herein may be trademarks and/or

registered trademarks of their respective companies.

COMPAQ 1024 COLOR MONITOR

INSTALLATION GUIDE

First Edition (June 1992)

Second Edition (June 1992)

Part Number 141781-002

Compaq Computer Corporation

FEDERAL COMMUNICATIONS COMMISSION NOTICE

This equipment has been tested and found to comply with the limits for

a Class digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following

measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

•Consult the dealer or an experienced radio or television technician

for help.

Modifications

The FCC requires the user to be notified that any changes or

modifications made to this device that are not expressly approved by

Compaq Computer Corporation may void the user's authority to

operate the equipment.

Cables

Connections to this device must be made with shielded cables with

metallic RFI/EMI connector hoods to maintain compliance with FCC

Rules and Regulations.

CANADIAN NOTICE

This equipment does not exceed the Class B limits for radiated

emissions as described in the Radio Interference Regulations of the

Canadian Department of Communications.

AVIS CANADIEN

Le présent appareil numérique n'énict pas de bruits radioélectriques

dépassant les limites applicables aux appareils numeriques de la Classe

B prescrites dans le Règlement sur le brouillage radioélectrique édicté

par le Ministère des Communications du Canada.

GERMAN NOTICE

COMPAQ computers, when tested with the COMPAQ 1024 Color

Monitor were evaluated for compliance to the requirements of ZHI/618

in the Text Mode (640 x 480) using MS-DOS Version 3.31 (or higher)

and BASICA as published by Compaq Computer Corporation.

HINWEIS

Hiermit wird bescheinigt, daß der COMPAQ Series 460 und 461 in

Übereinstimmung mit den Bestimmungen der BMPT-AmtsblVfg

243/1991 funk-entstört ist. Der vorschriftsmäßige Betrieb mancher

Geräte (z.B. Meßsender) kann allerdings gewissen Einschränkungen

unterliegen. Beachten Sie deshalb die Hinweise in der

Bedienungsanleitung.

Dem Zentralamt für Zulassungen im Fernmeldewesen wurde das

Inverkehrbringen dieses Gerätes angezeigt und die Berechtiguna zur

Überprüfung der Serie auf die Einhaltung der Bestimmungen

eingeräumt.

vii

CONTENTS

OMPAQ 1024 COLOR MONITOR

About the Monitor 1

Installing the Monitor 1

Using Controls and Indicators 3

Care and Maintenance 5

PPENDIX

Advanced Picture Adjustments A–1

Preset Modes A–4

Specifications A–5

OMPAQ 1024 COLOR MONITOR

This manual provides information necessary for you to install and

operate the COMPAQ 1024 Color Monitor.

BOUT THE MONITOR

The 1024 Color Monitor is a microprocessor based, intelligent scanning

color monitor. It is best suited for applications from word processing to

spreadsheets to CAD/CAE. Its microprocessor intelligence allows easy

adjustment of screen configurations with various display modes.

Some of the features of the 1024 Color Monitor are as follows:

•Supports VGA standards, Super VGA (800 x 600), 8514/A

(1024 x 768 interlaced), and 1024 x 768 non-interlaced mode.

•Analog input allows the monitor to display up to 256 colors.

•Front panel controls to adjust the Horizontal-size, Horizontal-

position, Vertical-size, and Vertical-position in each display mode.

•Built-in automatic frequency control that eliminates the need of

Horizontal-hold controls.

•Automatically scans the horizontal frequency from 30 to 58 KHz

and the vertical frequency from 50 to 100 Hz.

•Monitors compliant with MPR 1990 Emissions Standards are

identified by a statement on the product label.

NSTALLING THE MONITOR

All COMPAQ personal computers have integrated display adapters that

work with the 1024 Color Monitor. If your computer requires a

separate display adapter, install it before proceeding with these

instructions.

COMPAQ 1024 Color Monitor 2

To install the monitor, ensure that power to the monitor, computer

system, and other attached devices is off and complete the following

steps:

1. Connect the monitor AC power cord to a properly grounded AC

outlet that is easily accessible and located as near the monitor as

possible. Depending on your location, the power cord for your

monitor could be different from the one in the illustration.

2. Connect the video cable on the monitor to the 15-pin video

graphics connector and tighten the fastening screws.

IMPORTANT: Make sure the signal cable aligns with the video

graphics connector. Do not force the cable onto the connector, or you

may damage the video cable.

Rear Panel Connectors

WARNING: This equipment is designed for connection

to a grounded (earthed) outlet. The 3-prong grounding

type plug is an important safety feature. To avoid risk of

electric shock or damage to your equipment, do not

disable this feature.

COMPAQ 1024 Color Monitor 3

SING CONTROLS AND INDICATORS

This section describes the controls and indicators on the COMPAQ

1024 Color Monitor.

ront Panel Controls

The following illustration shows the front panel controls used to power

on the monitor and adjust the contrast and brightness.

Front Panel Controls

1. Power Switch

2. Power-on Indicator

3. Brightness Control

4. Contrast Control

CAUTION: To prevent damage to the monitor, wait at

least three (3) seconds after turning off the monitor before

you turn it back oil.

COMPAQ 1024 Color Monitor 4

isplay Adjustment Controls

The display adjustments on the 1024 Color Monitor are preset.

Normally, you do not need to make any adjustments. If you need to

make adjustments, press the panel marked PUSH on the front of the

monitor. You can use this row of push buttons to change the settings

shown below. The settings are automatically saved and recalled each

time you change the monitor's mode.

Display Adjustment Controls

1. Horizontal position

2. Horizontal width

3. Vertical height

4. Vertical position

5. Reset

COMPAQ 1024 Color Monitor 5

ARE AND MAINTENANCE

•Use only a power source and connection appropriate for this

monitor, as indicated on the marking label/back plate.

•When you connect the monitor to an outlet or extension cord, make

sure the total ampere rating of the products connected to the outlet

does not exceed the current rating of the electrical outlet, and the

total ampere rating of the products connected to the cord do not

exceed the rating of the cord.

•Install the monitor near an outlet that you can reach easily.

Disconnect the product by grasping the plug firmly and pulling it

from the outlet. Never disconnect it by pulling the cord.

•Unplug the monitor from the wall outlet before cleaning. Do not

use liquid cleaners or aerosol cleaners. Use a damp cloth for

cleaning.

•Do not drop the monitor or place it on an unstable surface.

•Slots and openings in the cabinet are provided for ventilation; these

openings must not be blocked or covered. Never push objects of

any kind into cabinet slots or other openings.

•Do not allow anything to rest on the power cord. Do not walk on

the cord.

•Keep the monitor in a well-ventilated area, away from excessive

light, heat and moisture. Keep the monitor away from high capacity

transformers, electric motors, and other strong magnetic fields.

•Do not open the monitor cabinet or attempt to service this product

yourself. Adjust only those controls that are covered by the

operating instructions. If the monitor is not operating properly, or

has been dropped or damaged, contact your dealer.

A-1

PPENDIX

DVANCED PICTURE ADJUSTMENTS

This section is intended for the experienced user only. It includes a brief

description on adjusting the picture geometry, as well as the vertical

and horizontal position and size.

NOTE: Specific test patterns and service experience may be required

to perform these adjustments. If you have any problems adjusting the

service controls, just press Reset and start again.

hanging Front Panel Control Functions

A set of DIP switches recessed on the front panel of the 1024 Color

Monitor changes the functions of the front panel control buttons. Once

set, the settings are automatically saved and recalled each time you

change the monitor's mode

Both the DIP switches are set to Off at the factory, and you can use the

front panel controls control the following user functions:

Removing tile Rubber Cap to Change the DIP Switch Settings

•Horizontal-position (1)

•Horizontal-width (2)

•Vertical-height (3)

•Vertical-position (4)

Inhaltsverzeichnis

Andere Compaq Monitor Handbücher

Compaq

Compaq Flat Panel Monitor tft5017m Bedienungsanleitung

Compaq

Compaq S920 Bedienungsanleitung

Compaq

Compaq V1100 Bedienungsanleitung

Compaq

Compaq Compaq S720 Bedienungsanleitung

Compaq

Compaq Compaq S700 Bedienungsanleitung

Compaq

Compaq 7020 Bedienungsanleitung

Compaq

Compaq MV7540 Bedienungsanleitung

Compaq

Compaq V40 Bedienungsanleitung

Compaq

Compaq 5017 - TFT - 15" LCD Monitor Bedienungsanleitung

Compaq

Compaq P75 Bedienungsanleitung

Compaq

Compaq TFT5010 Bedienungsanleitung

Compaq

Compaq Compaq S710 Bedienungsanleitung

Compaq

Compaq TFT500 Bedienungsanleitung

Compaq

Compaq COMPAQ Q1859 Bedienungsanleitung

Compaq

Compaq TFT 5000R Bedienungsanleitung

Compaq

Compaq MV 740 Bedienungsanleitung

Compaq

Compaq 1825 Bedienungsanleitung

Compaq

Compaq S900 Bedienungsanleitung

Compaq

Compaq P700 Bedienungsanleitung

Compaq

Compaq MV 540 Bedienungsanleitung

Compaq

Compaq CV5500 Bedienungsanleitung

Compaq

Compaq MV5500 Gebrauchsanweisung

Compaq

Compaq ProLiant 5500 Bedienungsanleitung

Compaq

Compaq Compaq S710 Bedienungsanleitung

Beliebte Monitor Handbücher anderer Marken

Linear Acoustic

Linear Acoustic LQ-1000 Bedienungsanleitung

AOC

AOC I2579V Bedienungsanleitung

Gateway

Gateway FPD1520 Bedienungsanleitung

Furuno

Furuno Mu 120c Bedienungsanleitung

Asus

Asus VB171D - 17" LCD Monitor Bedienungsanleitung

Dell

Dell S2230MX Gebrauchsanweisung

Philips

Philips 107C64 Bedienungsanleitung

Dell

Dell S2409WFP Bedienungsanleitung

EverFocus

EverFocus EN-7517E Bedienungsanleitung

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Bedienungsanleitung

Dell

Dell Precision 7680 Bedienungsanleitung

LG 50PM1M - - 50" Plasma Panel Bedienungsanleitung

Bosch

Bosch DDU 9 Bedienungsanleitung

Acer

Acer A231HL Bedienungsanleitung

Philips

Philips 86BDL4152T Bedienungsanleitung

NEC

NEC AccuSync LCD5V Bedienungsanleitung

Emay

Emay SleepO2 Bedienungsanleitung

IBM

IBM 6360 Montageanleitung