Contec FX-DS110-APL Bedienungsanleitung
FX-DS110-APL
Access Point
User’s Guide
FX-DS110-APL i
Copyright
Copyright 2001 CONTEC Co., LTD. ALL RIGHTS RESERVED
No part of this document may be copied or reproduced in any form
by any means without prior written consent of CONTEC Co., LTD.
CONTEC Co., LTD. makes no commitment to update or keep
current the information contained in this document.
The information in this document is subject to change without
notice.
All relevant issues have been considered in the preparation of this
document. Should you notice an omission or any questionable
item in this document, please feel free to notify
CONTEC Co., LTD.
Regardless of the foregoing statement, CONTEC assumes no
responsibility for any errors that may appear in this document nor
for results obtained by the user as a result of using this product.
Trademarks
MS, Microsoft, MS-DOS and Windows are trademarks of Microsoft
Corporation. Other brand and product names are trademarks of their
respective holder.
FX-DS110-APLii
Product Configuration
-FX-DS110-APL …1
-AC Adapter with 1.8m cable …1
-Cross cable(1.5m) …1
-Tapping screws (for mounting on wall, etc.) …2
-Locking screw (for connecting to ground wire) …1
-Magnets (for mounting on metallic surfaces) …2
-Rubber feet …4
-Floppy disk …1
-User’s Manual (this booklet)…1
-Installation Guide …1
User'sManual
FX-DS110-APL
Floppydiskx1
AC Adapterx1
Installation
Guide
Tappingscrewx2
Rubberfeetx4
Lockingscrewx1
User'sManualMagnetx2
Cross cable(1.5m)x1
POWER
WRX
WLINK
LINK
RX
Check the contents to make sure that you have everything listed
above. If you do not have all the items, contact your distributor
or CONTEC group office where you purchased.
FX-DS110-APL iii
Table of Contents
Copyright............................................................................i
Trademarks ........................................................................i
Product Configuration ..................................................... ii
1. Introduction .............................................................1
Features.........................................................................1
Terminology/Abbreviations...........................................2
Limited One-Year Warranty.........................................3
How to Obtain Service..................................................3
Liability.........................................................................3
Handling Precautions...................................................4
Precautions for Use.......................................................4
Precautions Related to Service ....................................5
About the Manual.........................................................6
2. Overview..................................................................7
Component Locations........................................................7
LED Indicators..................................................................8
DIP Switches.....................................................................9
Multi-channel Operation................................................10
3. Operating Mode Descriptions................................... 13
ADHOC (Simple Mode)...................................................13
Infrastructure (Standard Mode / Compatible Mode).......14
Operating Modes and Communications.........................15
4. Setup ..................................................................... 17
Wall Installation .............................................................17
Using the Mounting Screws (Included).....................17
Using the Magnets (Included)....................................18
Table Top Installation.....................................................20
Cable Installation ...........................................................20
Power Supply Connection...............................................21
Ground Connection.........................................................22
FX-DS110-APLiv
5. Settings .................................................................23
Preparing the Utility Software.......................................23
Utility Software Settings................................................24
Node Registration.......................................................25
Configuration..............................................................26
Base .............................................................................27
Wireless.......................................................................27
SNMP ..........................................................................30
Spanning Tree.............................................................31
File Management........................................................32
Status ..........................................................................33
Environment...............................................................34
Interfaces.....................................................................35
Wireless Node..............................................................36
Bridge..........................................................................37
Spanning Tree.............................................................38
Wireless Counter.........................................................39
To Register or Set Up a New Access Point.....................40
To Edit Settings for an Existing Access Point...............40
To Use Data scramble Functions for Better Security ...41
To Use SNMP Agent Functions......................................41
To Use Spanning Tree.....................................................42
To Access the APL from a Different Router...................42
6. Spanning Tree Algorithms (STA).............................. 43
What is an STA?..............................................................43
STA Parameters..............................................................44
Bridge Level................................................................44
Port Level....................................................................46
Sample STA Application .................................................47
7. SNMP Agent Functions ........................................... 51
SNMPc Overview............................................................51
MIB Support....................................................................52
Control Using SNMPc.....................................................53
Building-in to SNMPc.....................................................54
FX-DS110-APL v
MIB Database Updates...................................................54
8. Troubleshooting...................................................... 55
When Communication Fails.......................................55
When SNMP Connections Fail...................................56
When the APL Will Not Start.....................................57
9. Appendix................................................................ 59
Product Specifications.....................................................59
Input/Output Interface...................................................61
UTP Port Pin Assignments.........................................61
Glossary...........................................................................62
10. Index.................................................................... 65
FX-DS110-APLvi
List of Figures
Figure 2.1. Component Locations............................................... 7
Figure 2.2. Multi-channel Operation......................................... 10
Figure 2.3. Channel Frequencies ...............................................11
Figure 3.1. ADHOC Mode ....................................................... 13
Figure 3.2. Infrastructure Mode................................................ 14
Figure 4.1. Wall Installation..................................................... 17
Figure 4.2. Attaching Magnets Figure 4.3. Removing Magnets 18
Figure 4.4. Installation on a Steel Desk.................................... 19
Figure 4.5. Cable Connection................................................... 20
Figure 4.6. Power Supply Connection...................................... 21
Figure 4.7. Ground Connection................................................ 22
Figure 5.1. Main Menu............................................................. 24
Figure 5.2. Node Registration................................................... 25
Figure 5.3. Configuration (Base).............................................. 27
Figure 5.4. Configuration (Wireless) ........................................ 28
Figure 5.5. Configuration (SNMP)........................................... 30
Figure 5.6. Configuration (Spanning Tree)............................... 31
Figure 5.7. File Management.................................................... 32
Figure 5.8. Status (Environment).............................................. 34
Figure 5.9. Status (Interfaces)................................................... 35
Figure 5.10. Status (Wireless Node)........................................... 36
Figure 5.11. Status (Bridge) ....................................................... 37
Figure 5.12. Status (Spanning Tree) ........................................... 38
Figure 5.13. Status (Wireless Counter)....................................... 39
FX-DS110-APL vii
Figure 6.1. Sample STA Application........................................ 47
Figure 6.2. After STA Application............................................ 48
Figure 6.3. Reconfigured After STA Application..................... 49
Figure 7.1. Settings................................................................... 53
Figure 9.1. External Dimensions .............................................. 60
List of Tables
Table 2.1. ADHOC (Simple Mode) ............................................. 8
Table 2.2. Infrastructure (Standard Mode) / (Compatible
Mode) [Unit Type AP].............................................. 8
Table 2.3. Infrastructure (Standard Mode) / (Compatible
Mode) [Unit Type Station]........................................ 8
Table 2.4. Other........................................................................... 9
Table 2.5. DIP Switches .............................................................. 9
Table 3.1. Operating Modes and Communications..................... 15
Table 7.1. Group Names............................................................ 52
Table 9.1. Physical Specifications.............................................. 59
Table 9.2. Software Specifications............................................. 59
Table 9.3. Installation Environment Conditions (Environment
Specifications)........................................................ 59
Table 9.4. UTP Port Pin Assignments........................................ 61
FX-DS110-APLviii
Introduction
FX-DS110-APL 1
1. Introduction
Thank you for purchasing the FX-DS110-APL access point.
This product is a wireless LAN access point using the 2.4GHz
spectrum diffusion system, and is compatible with IEEE Standard
802.11b for wireless LAN.
The FX-DS110-APL is designed for use as an access point as well
as a station (Ethernet wireless converter). It is independent of
operating systems or protocols, so that it can be connected by UTP
cable to any Ethernet-compatible desktop computer, workstation,
point-of-sale terminal, printer, etc. for immediate wireless LAN use.
This product can also enable wireless communications from any PC
previously unsuitable for wireless communications due to lack of a
PC card slot or expansion bus slot.
Of course the FX-DS110-APL also operates as an access point,
allowing the user to configure a small wireless LAN system using
the product by itself.
This document explains how to use the FX-DS110-APL. Be sure to
read it carefully so that you can use the product correctly.
Features
-Ultra-compact antenna (micro access point)
Space-saving design allows installation anywhere (wall, magnet,
desktop)
-Operates as a LAN station
-Optional power supply from LAN cable
Uses compact, lightweight AC adapter.
-Full range of functions (roaming, 11 or 13-channel support)
-Automatic transmission speed (wireless) switching
Automatically switches transmission speeds from 11Mbps to
5.5Mbps, 2Mbps, 1Mbps according to conditions.
-Built-in SNMP agent
Uses SNMP compatible software for easy network management.
-Can be used with higher level model FX-DS110-APE.
Andere Handbücher für FX-DS110-APL
1
Inhaltsverzeichnis
Andere Contec Drahtloser Zugangspunkt Handbücher
Contec
Contec FXE2000-G Bedienungsanleitung
Contec
Contec FX-DS540-APDL-U Bedienungsanleitung
Contec
Contec FXE2000-DG Bedienungsanleitung
Contec
Contec FX-DS540-APP Bedienungsanleitung
Contec
Contec FXA3000 Series Bedienungsanleitung
Contec
Contec FXE3000 Series Bedienungsanleitung
Contec
Contec FXE3000-EU Bedienungsanleitung
Contec
Contec FX-DS110-APE Bedienungsanleitung
Contec
Contec FX-DS110-APL Bedienungsanleitung
Contec
Contec FXA2000-G Handbuch
Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken
D-Link
D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung
Ubiquiti
Ubiquiti NanoStation NSM2 Bedienungsanleitung
Cisco
Cisco Aironet 1550 Series Bedienungsanleitung
Aruba
Aruba IAP-335 Bedienungsanleitung
Advantek Networks
Advantek Networks AWN-AP-54MR Bedienungsanleitung
IP-COM
IP-COM AP355 Bedienungsanleitung
Buffalo
Buffalo AirStation WLA-L11G Bedienungsanleitung
EnGenius
EnGenius EnStationACv2 Bedienungsanleitung
D-Link
D-Link DAP-3662 Bedienungsanleitung
xG Technology
xG Technology xMax CN1300 Bedienungsanleitung
Widelink
Widelink ezWave WAP-1100 Series Bedienungsanleitung
Edimax
Edimax CAP1200 Bedienungsanleitung
