Contrik CA-HT-smallONE Bedienungsanleitung
CA-HT-smAllONE
MANUAL
[ Seite 2 ]
TABLE OF CONTENTS
1. Introduction.......................................................................................................................................6
1.1 Introduction to the Scaler Switcher............................................................................................. 6
1.2 Features.................................................................................................................................. 6
1.3 Package List ............................................................................................................................ 6
2. Panel Description ...............................................................................................................................7
2.1 Transmitter .............................................................................................................................. 7
2.2 Receiver.................................................................................................................................. 8
3. System Connection .............................................................................................................................9
3.1 Usage Precautions.................................................................................................................... 9
3.2 System Diagram ....................................................................................................................... 9
3.3 Connection Procedure ............................................................................................................... 9
3.4 Application............................................................................................................................ 10
3.5 Twisted Pair Cable Connection ................................................................................................. 10
4. Specification ................................................................................................................................... 11
5. Panel Drawing.................................................................................................................................. 12
6. Troubleshooting & Maintenance.......................................................................................................... 13
7. After-sales Service............................................................................................................................ 14
CA-HT-smAllONE
MANUAL
All Rights Reserved
© Contrik AG, Version 1 / 5.2017
[ Seite 4 ]
PREFACE
Read this user manual carefully before using this product. Pictures shown in this manual is for refe-
rence only, different model and specifications are subject to real product.
This manual is only for operation instruction only, not for any maintenance usage. The functions de-
scribed in this version are updated till December 2016. In the constant effort to improve our product,
we reserve the right to make functions or parameters changes without notice or obligation. Please refer
to the dealers for the latest details. All product function is valid till November 2019.
TRADEMARKS
Product model and logo are trademarks. Any other trademarks mentioned in this manual are ack-
nowledged as the properties of the trademark owner. No part of this publication may be copied or
reproduced without the prior written consent.
FCC STATEMENT
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. It has
been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a commercial installation.
Operation of this equipment in a residential area is likely to cause interference, in which case the
user at their own expense will be required to take whatever measures may be necessary to correct the
interference.
Any changes or modifications not expressly approved by the manufacture would void the user’s au-
thority to operate the equipment.
Manual Ca-HT-SMallOnE
[ Seite 5 ]
SAFETY PRECAUTIONS
• To insure the best from the product, please read all instructions carefully before using the device.
Save this manual for further reference.
• Unpack the equipment carefully and save the original box and packing material for possible
future shipment
• Follow basic safety precautions to reduce the risk of fire, electrical shock and injury to persons.
• Do not dismantle the housing or modify the module. It may result in electrical shock or burn.
• Using supplies or parts not meeting the products’ specifications may cause damage, deteriora-
tion or malfunction.
• Refer all servicing to qualified service personnel.
• To prevent fire or shock hazard, do not expose the unit to rain, moisture or install this product
near water.
• Do not put any heavy items on the extension cable in case of extrusion.
• Do not remove the housing of the device as opening or removing housing may expose you to
dangerous voltage or other hazards.
• Install the device in a place with fine ventilation to avoid damage caused by overheat.
• Keep the module away from liquids.
• Spillage into the housing may result in fire, electrical shock, or equipment damage. If an object
or liquid falls or spills on to the housing, unplug the module immediately.
• Do not twist or pull by force ends of the optical cable. It can cause malfunction.
• Do not use liquid or aerosol cleaners to clean this unit. Always unplug the power to the device
before cleaning.
• Unplug the power cord when left unused for a long period of time.
• Information on disposal for scrapped devices: do not burn or mix with general household waste,
please treat them as normal electrical wastes.
[ Seite 6 ]
1. INTRODUCTION
1.1. Introduction to the HDBaseT-Devices
HDBaseT Extender is a mini-size extender set consists of transmitter and receiver. HDBaseT techno-
logy is used to transmit high-resolution 1080p/ 4k signal from transmitter to the receiver via a CAT5e/
CAT6a cable at a distance of up to 70/40m.Moreover, HDBaseT Extender support CEC, bi-directional
RS232&IR control, and unidirectional PoH function.
1.2. Features
• Support Full HD: Delivers high resolution image (1080p@60Hz@48 b/pixels/3D/4Kx2K).
• Maximum transmission distance is 70m for 1080p and 40m for 4Kx2K over single CAT5e/CAT6a
cable
• High Bandwidth: 10.2Gps.
• HDTV Compatible, use HDMI 1.4 and HDCP2.2 compliant.
• Support CEC/IR/RS232 pass-through.
• Support PoH, the receiver can be powered by transmitter.
• Bi-directional RS232/IR control.
• Use HDBaseT technology.
• LED indicators show work status.
Note: Please use a CAT5e cable with low impedance (Shielded twisted pair will be better and
should be well grounded) for good transmission effect.
1.3. Package Contents
• 1 x Transmitter
• 1 x Receiver
• 4 x Mounting ears (Separated from HDBaseT Extender)
• 8 x Plastic cushions
• 8 x Screws
• 2 x Power adapter (DC 24V 1.25A)
• 2 x RS232 cables
• 1 x User manual
Note: Please confirm that the product and the accessories are all included, if not, please contact
the dealers.
Manual Ca-HT-SMallOnE
[ Seite 7 ]
2. PANEL DESCRIPTION
2.1. Transmitter
No. Name Description
LINK
HDBT Link status indicator:
OFF: No Link
GREEN:Link Successful
Blinking GREEN: Link abnormal
HDCP
HDCP compliant indicator
OFF: No HDMI traffic (no picture)
GREEN: Traffic with HDCP.
Blinking GREEN: Traffic without HDCP
Power OFF: No power; RED: DC power present.
RS232 RS232 connector.
IR IN Connect with 5V IR receiver (with carrier) to collect inf-
rared signal, work with far-end IR OUT port
IR OUT Connect with 5V IR Emitter to send infrared signal, work
with far-end IR IN port
HDMI IN Connect with HDMI source
HDBT OUT Connect to the HDBT IN socket on the Receiver via CA-
T5e/ CAT6a cable, support unidirectional PoH.
DC 24V Connect with power supply
Pictures shown in this manual are only for reference.
[ Seite 8 ]
2.2. Receiver
No. Name Description
LINK
HDBT Link status indicator:
OFF: No Link
GREEN:Link Successful
Blinking GREEN: Link abnormal
HDCP
HDCP compliant indicator
OFF: No HDMI traffic (no picture)
GREEN: Traffic with HDCP.
Blinking GREEN: Traffic without HDCP
Power OFF: No power; RED: DC power present.
RS232 RS232 connector.
IR IN Connect with 5V IR receiver (with carrier) to collect infrared signal, work
with far-end IR OUT port
IR OUT Connect with 5V IR Emitter to send infrared signal, work with far-end
IR IN port
HDMI OUT Connect with HDMI display
HDBT IN Connect to the HDBT OUT socket on the transmitter via CAT5e/ CAT6a
cable.
DC 24V Connect with power supply (Not necessary if transmitter connects with
power).
Pictures shown in this manual are only for reference.
Manual Ca-HT-SMallOnE
[ Seite 9 ]
3. SYSTEM CONNECTION
3.1. Usage Precautions
• System should be installed in a clean environment and has a prop temperature and humidity.
• All of the power switches, plugs, sockets and power cords should be insulated and safe.
• All devices should be connected before power on.
3.2. System Diagram
3.3. Connection Procedure
Step1. Connect HDMI source (such as Blue-ray DVD) to HDMI IN port of transmitter with HDMI
cable.
Step2. Connect HDBT OUT port of transmitter and HDBT IN port of receiver, with single CAT5e/CA-
T6a cable.
Step3. Connect HDMI displayer (such as HDTV) to HDMI OUT port of receiver with HDMI cable.
Step4. Both transmitter and receiver have IR IN and OUT. When one end is used as an IR receiver,
the signal sent from the end can only be transmitted via the other end.
For example: When “IR IN” of transmitter connects with an IR receiver, the IR transmitter must con-
nect to IR OUT of Receiver.
Step5. Connect the RS232 port of the devices to be controlled and the receiver or the transmitter.
Step6. Connect with DC24V power adaptor(s) (One is enough if transmitter is connected with adapter
as its PoH function).
[ Seite 10 ]
3.4. Application
HDBaseT Extender has a good application in various occasions, such as computer realm, monito-
ring, big screen displaying, meeting room, education and bank & securities institution etc.
3.5. Twisted Pair Cable Connection
The twisted pair used in this extender MUST be a straight-through cable.
TIA/EIA T568A TIA/EIA T568B
Pin Cable color Pin Cable color
1green white 1orange white
2green 2orange
3orange white 3green white
4blue 4blue
5blue white 5blue white
6orange 6green
7brown white 7brown white
8brown 8brown
1st
Ground 4--5 1st
Ground 4--5
2nd
Ground 3--6 2nd
Ground 1--2
3rd
Group 1--2 3rd
Group 3--6
4th
Group 7--8 4th
Group 7--8
Notice: Cable connectors MUST be metal one, the shielded layer of cable
MUST be connected to the connector’s metal shell, to make a better trans-
mission.
Inhaltsverzeichnis
Beliebte Sender Handbücher anderer Marken
Dejero
Dejero EnGo 3x Bedienungsanleitung
Rosemount
Rosemount 4600 Bedienungsanleitung
Speaka Professional
Speaka Professional 2342740 Bedienungsanleitung
trubomat
trubomat GAB 1000 Bedienungsanleitung
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 Bedienungsanleitung
Rondish
Rondish UT-11 Bedienungsanleitung
