Cooper Lighting SURE-LITES CX Series Bedienungsanleitung

BEFORE INSTALLING, DETERMINE ARROW POSITION REQUIREMENTS:

Step 1. Open the exit door and remove the colored exit lens by prying up the four retaining clips.

Step 2. Before knocking out desired arrows, place the exit door frame down on wood blocks 1/2" from arrows, taking care to protect the door face finish.

Step 3. Re-install the colored exit lens with the gloss side facing towards the LED’s.

Step 4. Tap the four retaining clips back into place.

FOR DOUBLE FACE UNITS:

Step 1. On housing, knock out desired arrows per Step 2 above.

Step 2. Install the extra colored exit lens with the gloss side facing towards the LED’s.

Step 3. Secure using four retaining clips supplied.

NOTE: Servicing of any parts should be performed by qualified service personnel. ONLY use replacement parts supplied by Sure-Lites.

For replacement transformer, or LED display PC board, see the fixture label.

TROUBLE SHOOTING HINTS: LED DISPLAY DOES NOT COME ON :

1. Check AC supply - be sure unit has 24 hour AC supply.

2. Unit is shorted.

If following the above trouble shooting hints

does not solve your problem, contact your local

Sure-Lites Representative or the factory for assistance.

Installation Instructions For AC L.E.D. Exit Signs, CX Series

IMPORTANT SAFEGUARDS

WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS

BE OBSERVED INCLUDING THE FOLLOWING:

1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS

2. Do not use outdoors.

3. Do not mount near gas or electric heaters.

4. Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by

unauthorized personnel.

5. The use of accessory equipment not recommended by Sure-Lites may cause an unsafe condition.

6. Do not use this equipment for other than its intended purpose.

7. SAVE THESE INSTRUCTIONS

ORANGE LEAD - TO 277V

BLACK LEAD - TO 120V

WHITE LEAD - TO NEUTRAL

LED DISPLAY PC BOARD

PRIMARY

POWER

SUPPLY PC

BOARD

TEST

SWITCH

CHARGE

INDICATOR

SCHEMATIC

WHITE LEAD

- TO NEUTRAL

ORANGE LEAD

- TO 277V

BLACK LEAD - TO 120V

2C POWER

SUPPLY PC

BOARD

IMPORTANT INSTALLATION NOTES FOR 2C OPTION:

CUT SUPPLY WIRE NOT BEING USED ON NORMAL

AND EMERGENCY CIRCUITS (BLACK OR ORANGE)

BY CABLE CLAMPS AND WIRENUT.

MAKE CONNECTIONS

IN JUNCTION BOX OR

CANOPY

Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800 FAX 770.486.4801 10/09 024-78A

SURE-LITES

WALL MOUNTING INSTALLATION:

Step 1. Extend unswitched 24 hour AC supply of rated voltage to junction box (by others). Circuit should not be energized at this time.

Step 2. Knock out wire access hole and the appropriate mounting pattern to fit junction box being used.

Step 3. Dress wires through wire access hole. Secure wires inside housing by positioning cable tie mounting pad near wire access hole and secure with

cable tie.

Step 4. Connect AC supply wires and ground wire in accordance with local codes. Wirenut any unused supply wire. 120V-BLACK, 277V-ORANGE,

NEUTRAL-WHITE, GROUND-GREEN. Dress wires and push into junction box.

Step 5. Mount housing to junction box with 2 screws (by others).

Step 6. Energize AC supply, LED display will come on.

CEILING OR END MOUNT INSTALLATION:

Step 1. Extend unswitched 24 hour AC supply of rated voltage to junction box

(by others). Circuit should not be energized at this time.

Step 2. Screw 3" long threaded nipple approximately 1-1/4" into mounting plate,

Attach mounting plate to junction box with 2 screws (by others). Dress

wires through large slots.

Step 3. Unscrew bracket from housing by removing 2 screws.

Step 4. Remove three 5/8" diameter knockouts (top or sides as required).

Support each knockout within 1/2" on two sides before removing.

Step 5. Fasten canopy to housing by using 3/4" long threaded nipple and 2 hex

nuts.

Step 6. Relocate wires on bracket towards canopy location being used. Dress

wires through small hole into canopy.

Step 7. Connect AC supply wires and ground wire in accordance with local

codes. Wirenut any un0used supply wire. 120V-BLACK, 277V-

ORANGE,

NEUTRAL-WHITE, GROUND-GREEN.

Step 8. Mount housing/canopy by sliding 3" long threaded nipple on mounting

plate through center hole in canopy and securing with hex nut.

Step 9. Screw bracket back into housing. Take care on end mount installation to

dress wires through slots on sides of bracket.

Step 10. Energize AC supply, LED display will come on.

HOUSING

MOUNTING PLATE

1-1/4" APPROX.

3" LONG

THREADED

NIPPLE

BRACKET

HEX NUT

CANOPY

3/4" LONG

THREADED

NIPPLE

HOUSING

MOUNTING PLATE

1-1/4" APPROX.

3" LONG

THREADED

NIPPLE

IF END MOUNTING THIS SIDE:

DRESS WIRES UNDER TAB AND

THROUGH SLOT ON BACK

IF END MOUNTING THIS SIDE:

DRESS WIRES UNDER TAB AND

THROUGH SLOT ON SIDE

HEX NUT

CANOPY

3/4" LONG

THREADED

NIPPLE

BRACKET

CEILING MOUNT

END MOUNT

Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800 FAX 770.486.4801 10/09 024-78A

SURE-LITES

Inhaltsverzeichnis

Andere Cooper Lighting Beleuchtungsausrüstung Handbücher

Cooper Lighting

Cooper Lighting PROfile AR60S Bedienungsanleitung

Cooper Lighting

Cooper Lighting MS80 Bedienungsanleitung

Cooper Lighting

Cooper Lighting Sure-Lites SELDWA50PS Series Bedienungsanleitung

Cooper Lighting

Cooper Lighting ATLANTIC PLUS Bedienungsanleitung

Cooper Lighting

Cooper Lighting RFM300 Bedienungsanleitung

Cooper Lighting

Cooper Lighting HALO miniLUME LA5300 Bedienungsanleitung

Cooper Lighting

Cooper Lighting PROfile AR60T Bedienungsanleitung

Cooper Lighting

Cooper Lighting COMBOLIGHT CR220M70 Bedienungsanleitung

Cooper Lighting

Cooper Lighting MT250PC Bedienungsanleitung

Cooper Lighting

Cooper Lighting Halo LF603 Bedienungsanleitung

Cooper Lighting

Cooper Lighting MIGHT LIGHT LED130 Bedienungsanleitung

Cooper Lighting

Cooper Lighting Halo Lazer LZR330 Bedienungsanleitung

Cooper Lighting

Cooper Lighting FAIL-SAFE CFE-4 Series Bedienungsanleitung

Cooper Lighting

Cooper Lighting ADH080901 Bedienungsanleitung

Cooper Lighting

Cooper Lighting AMETRIX ADY071480 Bedienungsanleitung

Cooper Lighting

Cooper Lighting HALO Series Bedienungsanleitung

Cooper Lighting

Cooper Lighting LINEA Series Installationsanleitung

Cooper Lighting

Cooper Lighting HALO LAZER LZR204 Bedienungsanleitung

Cooper Lighting

Cooper Lighting MS185R Bedienungsanleitung

Cooper Lighting

Cooper Lighting TopTier LED Bedienungsanleitung

Cooper Lighting

Cooper Lighting METALUX HBSPMS Bedienungsanleitung

Cooper Lighting

Cooper Lighting Halo L650 Bedienungsanleitung

Cooper Lighting

Cooper Lighting Halo TGS3S401DSRB Bedienungsanleitung

Cooper Lighting

Cooper Lighting Sure-Lites CC10 Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

Silvair

Silvair MESH-CEDRP Bedienungsanleitung

S&P

S&P PCRL80 Bedienungsanleitung