Cooper Lighting HALO miniLUME LA5300 Bedienungsanleitung

• SAFETY INFORMATION

• IMPORTANT SAFETY

INSTRUCTIONS

• READ CAREFULLY FOR YOUR

PROTECTION AND SAVE ALL

INSTRUCTIONS

•Disconnect power before installing light fixture on track.

•Wear rubber-soled shoes and work on a sturdy wooden ladder.

•This fixture must be installed according to the National Electric

Code and local building codes.

•To avoid a hazard to children, account for all parts and destroy all

packing materials.

•If you are unsure about the installation or use of this fixture con-

sult a qualified electrician.

•CAUTION: To reduce the risk of fire and electrical shock, use only

fixtures and fittings intended for use with Halo and Lazer by Halo

track systems only.

Installation Instructions for LA5300, LF5300

& L5300 Adjustable Beam Lampholders

HALO®

Operation

This device has an internal ceramic metal halide transformer allowing it to operate

on Halo and Lazer by Halo line voltage track. Make sure you are using the correct

lamp type and wattage for your track fixture. In the event of a shutdown the lamp

will re-strike in approximately 5 minutes

NOTICE: THIS EQUIPMENT CONTAINS A R.F. BALLAST THAT HAS BEEN TESTED AND

FOUND TO COMPLY WITH THE LIMITS PURSUANT TO PART 18C NON-CONSUMER

LIMITS OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE

PROTECTION AGAINST HARMFUL INTERFERENCE WITH ELECTRONIC DEVICES SUCH

AS: RADIOS, TELEVISIONS, WIRELESS TELEPHONES OR REMOTE CONTROLS. IF

INTERFERENCE OCCURS IT MAY BE POSSIBLE TO CORRECT THE INTERFERENCE BY

ONE OR MORE OF THE FOLLOWING MEASURES:

• REORIENT OR RELOCATE ANTENNA OF THE RECEIVING DEVICE.

• INCREASE THE SEPARATION BETWEEN THIS EQUIPMENT AND THE DEVICE.

• CONNECT THIS EQUIPMENT OR THE DEVICE INTO A DIFFERENT OUTLET OR CIR-

CUIT.

THIS EQUIPMENT SHOULD NOT BE USED:

• CLOSER THAN THREE (3) FEET FROM ANY SENSITIVE ELECTRONIC EQUIPMENT.

• NEAR MARITIME SAFETY, NAVIGATION, OR COMMUNICATIONS EQUIPMENT.

Service

There are no user serviceable parts inside. Opening unit will void

warranty. Contact point of purchase for service.

Installation Instructions for

L5300 Series Track Fixture (Fig. 1A, 1B, 1C & 1D)

The L5300 track fixture can be used with Halo and Lazer by Halo

single circuit track and Halo-2 two-circuit track. An adjustable con-

tact allows you to select the circuit position. Use a narrow blade

screwdriver as shown (Fig.1A) to adjust the contact. Lift or lower

the contact until it touches the upper or lower plastic stop of the

contact assembly.

To use with Halo or Lazer by Halo single circuit track the

adjustable contact must be in the circuit #1 or lower position. To

use with Halo-2 two circuit track adjust the contact position to the

desired circuit position, circuit #1 down or circuit #2 up position

(Fig. 1B).

DOWN

POSITION UP

POSITION

ADJUSTABLE

CONTACT

FIG. 1A

FIG.1B

Customer First Center • 1121 Highway 74 South • Peachtree City, GA 30269 • 770.486.4800 • FAX 770.486.4801

11/06 rev.4 702505

Customer First Center • 1121 Highway 74 South • Peachtree City, GA 30269 • 770.486.4800 • FAX 770.486.4801

11/06 rev.4 702505

FOCUSING

KNOB

HORIZONTAL

LOCK

9/64" ALLEN

WRENCH

FIG.13

VERTICAL

LOCK

9/64" ALLEN

WRENCH

FIG. 12

FIG. 11

Changing Media

The fixture bezel assembly can accept two clear glass lenses or one color

filter with or without a clear lens.

Focusing Beam

Focus by rotating knob 1/4 turn on fixture. Beam can be adjusted from a

spot to a flood (Fig. 11).

Instructions for Lockable Aiming

Lockable aiming is only available for L530070E series fixtures.

Step 1 Aim fixture to desired position.

Step 2 Insert 9/64 allen wrench, provided by others, into hole under track

adapter. Turn clockwise to tighten. This will lock vertical rotation

(Fig.12).

Step 3 Insert 9/64 allen wrench into hole near on/off switch. Turn clock-

wise to tighten. This will lock horizontal rotation (Fig. 13).

HALO®

SWITCH

LAMP

(do not twist)

Do not touch

lamp with bare

fingers - hold

lamp with cloth

FIG. 7 FIG. 10

HALO®

TRACK

POLARITY

GROOVE

INSERT FIXTURE

IN TRACK AND

THEN TWIST 90°

FIXTURE

POLARITY

GROOVE

FIXTURE

POLARITY

GROOVE

THUMB

LATCH

FIG. 1C

FIG. 1D

To install the fixture to the track, insert the contact assembly into the track and

rotate the fixture neck 90° so the polarity line on the power supply aligns with

the polarity line on the track. Pull back and release the thumb latch allowing

the power supply to lock into position (Fig 1C and 1D).

To remove the fixture, slide thumb latch down until latch is clear of the track

channel opening. Twist the fixture neck and turn (90°) until the contact

assembly is free and remove power supply from track.

Installation Instructions for

LA5300 Series Track Fixture (Fig. 2)

The LA5300 track fixture can be used with Halo two circuit Architectural Track.

Fixture can be rotated 180° to second circuit.

To install fixture into track, open switch cover so that contacts are concealed

inside fixture. Insert fixture into track so the contact will engage the desired

circuit. Close switch cover.

To remove fixture, rotate switch cover 90° and remove from track. (Fig. 2)

Installation Instructions for

LF5300 Series Track Fixture (Fig. 3)

The LF5300 track fixture can be used with Halo ‘LF’ series 2 two-circuit track

only.

Step 1. Open connector cover by pulling downward on the connector sleeve

and connector cover so that the contacts are exposed.

Step 2. Raise fixture to track with contacts facing intended circuit.

Step 3. Move connector into position and close connector cover until it snaps

into position.

To remove fixture from track.

Step 1. Open connector cover by pulling downward on the connector sleeve.

Step 2. Raise fixture from track and remove.

Note: To access the other circuit, rotate fixture 180 degrees and follow

installation instruction above.

Relamping Instructions

Warning: Before working on fixture, be sure to turn off AC power or remove

fixture from track.

Step 1 Allow unit to cool then remove from track

Step 2 Remove bezel and glass assembly by rotating assembly counter-

clockwise (Figs 4 & 5).

Step 3 Remove glare shield by pulling both ends of the glare shield straight

out (Fig. 6).

Step 4 Locate the relamp label on the outer surface of the reflector to deter-

mine the required lamp wattage for proper fixture operation (Fig. 6).

Step 5 Remove the existing lamp by pulling straight out.

Step 6 Using a soft cloth to avoid contacting the new lamp with bare hands,

insert the replacement lamp into the socket by carefully aligning the

lamp pins to the socket and pushing the lamp straight into the

socket without twisting (Fig. 7). Insure lamp pins are inserted

properly into the socket for proper lamp function.

FIG. 2

FIG. 3

BEZEL & GLASS

ASSEMBLY

FIG. 4

CONNECTOR COVER

CONNECTOR

SLEEVE

Customer First Center • 1121 Highway 74 South • Peachtree City, GA 30269 • 770.486.4800 • FAX 770.486.4801

11/06 rev.4 702505

Customer First Center • 1121 Highway 74 South • Peachtree City, GA 30269 • 770.486.4800 • FAX 770.486.4801

11/06 rev.4 702505

FIG. 9

REFLECTOR

HOUSING

FIG.8

LUGS

Step 7 Replace the glare shield and bezel and glass assembly by carefully

engaging all three lugs on the bezel with the corresponding lugs on the

reflector housing (Fig. 8). Turn the bezel and glass assembly clockwise

until the positive ‘click’ is felt, indicating the home position has been

engaged in the reflector housing (Fig. 9). Verify the bezel and glass

assembly is securely retained in the reflector housing.

Step 8 DO NOT OPERATE FIXTURE WITHOUT GLASS LENS. RISK OF FIRE.

Be sure on-off switch is returned to ON position (Fig 10).

FIG. 5

FIG. 6

GLARE SHIELD

BEZEL &

GLASS

ASSEMBLY

RELAMP

LABEL

Dieses Handbuch passt für folgende Modelle

Andere Cooper Lighting Beleuchtungsausrüstung Handbücher

Cooper Lighting

Cooper Lighting Halo Lazer LZR305 Bedienungsanleitung

Cooper Lighting

Cooper Lighting ALL-PRO MST18920L Bedienungsanleitung

Cooper Lighting

Cooper Lighting IRIS MH4CFL42E Bedienungsanleitung

Cooper Lighting

Cooper Lighting PROfile AR60T Bedienungsanleitung

Cooper Lighting

Cooper Lighting MIGHT LIGHT LED130 Bedienungsanleitung

Cooper Lighting

Cooper Lighting ALL-PRO AL3050LPC Series Bedienungsanleitung

Cooper Lighting

Cooper Lighting ALL-PRO MST18920LES Bedienungsanleitung

Cooper Lighting

Cooper Lighting RFM300 Bedienungsanleitung

Cooper Lighting

Cooper Lighting IRiS E3AASR Bedienungsanleitung

Cooper Lighting

Cooper Lighting HALO RL6 Bedienungsanleitung

Cooper Lighting

Cooper Lighting SURE-LITES HR87 Series Bedienungsanleitung

Cooper Lighting

Cooper Lighting Night Harrier/NHR Bedienungsanleitung

Cooper Lighting

Cooper Lighting SURE-LITES SLX Series Bedienungsanleitung

Cooper Lighting

Cooper Lighting MT250 Bedienungsanleitung

Cooper Lighting

Cooper Lighting Corelite Class R2R Bedienungsanleitung

Cooper Lighting

Cooper Lighting TopTier LED Bedienungsanleitung

Cooper Lighting

Cooper Lighting Iris E-5 Series Bedienungsanleitung

Cooper Lighting

Cooper Lighting Halo L611 Bedienungsanleitung

Cooper Lighting

Cooper Lighting Halo TGS3S401DSRB Bedienungsanleitung

Cooper Lighting

Cooper Lighting Portfolio LD4A Bedienungsanleitung

Cooper Lighting

Cooper Lighting HALO MWP20FSUNVDBZ Bedienungsanleitung

Cooper Lighting

Cooper Lighting McGraw-Edison Impact Elite LED Bedienungsanleitung

Cooper Lighting

Cooper Lighting IRIS E4RPINSR Bedienungsanleitung

Cooper Lighting

Cooper Lighting HALO Home MicroEdge HLB6 Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

Silvair

Silvair MESH-CEDRP Bedienungsanleitung

S&P

S&P PCRL80 Bedienungsanleitung